article·2006-06-16

Reactive direct current magnetron sputtering of tungsten oxide: A correlation between film properties and deposition pressure

C. Salinga, Oliver Kappertz, Matthias Wuttig

Publisher page

Abstract

Abstract Gasochromic WOx-films with a Pt catalyst cap layer can serve as optically switchable coatings for a variety of applications. In this study the influence of the total pressure during deposition on film growth rate, properties and switching kinetics has been analyzed by X-ray reflectometry and optical spectroscopy. The dependency of density and deposition rate upon total pressure shows the same non-monotone behavior. While the decrease of the rate at higher pressures can be simulated via the Keller–Simmons model, the deviation observed at low pressures is indicative for backsputtering. A similar behavior is observed for the density, which is further evidence for backsputtering attributed to oxygen ion bombardment. To verify that not only surface atoms but also subsurface atoms are sputtered back, TRIM (Transport of Ions in Matter) calculations for high energetic oxygen ion bombardment on a WO3-film have been performed which confirm the experimental results. Finally switching kinetics have been shown to increase with decreasing film density. This is important since films with lower density can be prepared at low deposition pressure demonstrating a possibility to deposit WOx-films at better controllable deposition pressures.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Transition Metal Oxide Nanomaterials · Gas Sensing Nanomaterials and Sensors · ZnO doping and properties

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.