Improved fatigue properties of lead zirconate titanate films made on oxygen-implanted platinum electrodes
Source abstract
Abstract
Abstract Pb(Zr 0.3 Ti 0.7 )O 3 (PZT) thin film capacitors fabricated on an oxygen-implanted Pt bottom electrode were studied. Oxygen was implanted at a low acceleration voltage (40 kV) and dose (1×10 15 cm −2 ). Structural examination by grazing-incident X-ray diffraction (GIXD) and chemical analysis by X-ray photoelectron spectroscopy (XPS) revealed that the implantation generated a very thin amorphous top surface layer (approx. 20 nm), which contained approximately 7% of oxygen that stayed in the film in the form of PtO bonding. The amorphous layer, however, resumed the crystalline structure accompanied by the dissociation of PtO under the rapid thermal annealing at 600 °C for 5 min. The remnant polarization of sol–gel derived Pb(Zr 0.3 Ti 0.7 )O 3 (PZT) films fabricated on the oxygen-implanted Pt was slightly reduced from 11.92 μC/cm 2 for the PZT capacitors fabricated on a Pt electrode without implanted oxygen to 9.07 μC/cm 2 . Nevertheless, the fatigue endurance was significantly increased. The switching polarization of PtO x /PZT/Pt (O-implanted) capacitors remained within 95% of the starting value after 4×10 10 switching cycles, which is comparable to that of PZT capacitors made with other conducting oxides.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Ferroelectric and Piezoelectric Materials · Microwave Dielectric Ceramics Synthesis · Electronic and Structural Properties of Oxides
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.