article·2003-04-01

Preparation of n–i–p solar cells entirely by HWCVD with microcrystalline p-layer

M. Kupich, Prabhat Kumar, Bernd Schröder

Publisher page

Abstract

The hot-wire technique was used to entirely deposit n–i–p-type amorphous silicon solar cells with microcrystalline p-layers. Open circuit voltages of V s864 mVand short-circuit current densities of j s13.7 mA cm have been achieved. However, y2 OC SC the best initial conversion efficiency achieved was only h s6.2% due to a low fill factor of less than 60%. These low fill initial factors are associated with a high series resistivity of the p yTCO-interface and of the TCO material grown on mc-Si:H p-layer. A first attempt to study the stability of these n–i–p cells showed, that in comparison to the cells prepared at lower T the fill factor S degraded less when the n- and i-layer were deposited at T s340 8C. S 2003 Elsevier Science B.V. All rights reserved.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Thin-Film Transistor Technologies · Silicon and Solar Cell Technologies · Silicon Nanostructures and Photoluminescence

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.