article·2000-12-01

The growth of CoSi2 through an oxide layer: dependence on Si(100) surface structure

Jinhwa Heo, Hyeongtag Jeon

Publisher page

Abstract

Abstract The growth of Co–silicide on two different kinds of Si(100) substrates covered with a chemical oxide was investigated. The off-axis Si(100), which was cut 4° off to the (100) plane towards the [110] direction, and the on-axis Si(100), which was cut with less than 0.5°, were prepared. The atomic scale microsteps of the two different Si(100) substrates were observed by high resolution transmission electron microscope. These Si substrates were chemically oxidized by submerging the Si wafers into a hydrogen peroxide (H 2 O 2 ) solution for 10 min and loaded into an ultrahigh vacuum evaporation system. The 10-nm cobalt thin films were deposited on both kinds of substrates in this system and subsequently in-situ annealed for 10 min at temperatures between 400 and 700°C with 100°C increments. After this treatment, the Co–silicide is formed and analyzed by an X-ray diffractometer, scanning electron microscope, transmission electron microscope and Auger electron spectroscopy to verify the phase formation, surface and interface morphologies, and chemical composition. The Co 2 Si phase was found to be the first silicide formed during in-situ annealing. The formation temperature of CoSi 2 on the 4° off-axis Si(100) and on-axis Si(100) were 600 and 700°C, respectively. This difference in formation temperature of the CoSi 2 phase was considered to be related to the atomic scale microsteps of the Si surface.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Semiconductor materials and interfaces · Surface and Thin Film Phenomena · Silicon and Solar Cell Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.