article·2004-12-03

Ultraflat indium tin oxide films prepared by ion beam sputtering

Younggun Han, Dong‐Hwan Kim, Jun-Sik Cho, Seok‐Keun Koh

Publisher page

Abstract

Abstract Indium tin oxide (ITO) films with a smooth surface (root-mean-square roughness; R rms =0.40 nm) were made using a combination of the deposition conditions in the ion beam-sputtering method. Sheet resistance was 13.8 Ω/sq for a 150-nm-thick film grown at 150 °C. Oxygen was fed into the growth chamber during film growth up to 15 nm, after which, the oxygen was turned off throughout the rest of the deposition. The surface of the films became smooth with the addition of ambient oxygen but electrical resistance increased. In films grown at 150 °C with no oxygen present, a rough surface ( R rms =2.1 nm) and low sheet resistance (14.4 Ω/sq) were observed. A flat surface ( R rms =0.5 nm) with high sheet resistance (41 Ω/sq) was obtained in the films grown with ambient oxygen throughout the film growth. Surface morphology and microstructure of the films were determined by the deposition conditions at the beginning of the growth. Therefore, fabrication of ITO films with a smooth surface and high electrical conductivity was possible by combining experimental conditions.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: ZnO doping and properties · Thin-Film Transistor Technologies · Gas Sensing Nanomaterials and Sensors

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.