Origins of thin film delamination induced by electrodeposition and processing methods to overcome it
Source abstract
Abstract
Electrodeposition is widely used to deposit films in technological applications, but when the current efficiency is low, injected hydrogen can strongly affect the materials properties of an underlying film including its residual stress, adhesion and electrical resistivity. It is of interest to quantify this issue and demonstrate processing routes that retain good quality films. In this work, we explore the effects of electrodeposited nanocrystalline Ni-W on to a Ta thin film. This system serves as challenging test case because the current efficiency is only 31%. We observe that H incorporation induces GPa-level compressive stress in an underlying Ta film. The stress initiates a buckling-induced delamination failure of within 2 s, even though at 1.5 µm the Ta is relatively thick. Delamination over the entire film area occurs within 5 s. We demonstrate two process routes by which Ta films remain adhered when Ni-W is electrodeposited for 100 s, corresponding to a 1 µm thick Ni-W film.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Electrodeposition and Electroless Coatings · Semiconductor materials and interfaces · Corrosion Behavior and Inhibition
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.