On-axis radio frequency magnetron sputtering of stoichiometric BaTiO3 target: Localized re-sputtering and substrate etching during thin film growth
Source abstract
Abstract
Abstract BaTiO 3 thin films were prepared on Nb–SrTiO 3 (100) and Pt/Al 2 O 3 /SiO 2 /Si substrates by radio frequency (rf) magnetron sputtering using a stoichiometric BaTiO 3 ceramic target. This on-axis BaTiO 3 thin film growth encountered severe re-sputtering and substrate etching, above a threshold power density (4 W/cm 2 ), due to negative ion formation at the target surface and subsequent acceleration towards the substrate. However, the film deposition with reduced or negligible re-sputtering was possible below 4 W/cm 2 of rf-power. The rf-voltage vs. power curve showed two distinct linear regimes with high and low slopes; the change in the slope coincides with substrate etching. Optical emission spectroscopy was employed to establish the link between the onset of excessive re-sputtering and could be used as a control tool. Since, negative oxygen ions (O − ) are responsible for the re-sputtering, additional processing parameters like the oxygen partial pressure [P o = (O 2 ∕ O 2 + Ar) %] and total pressure were also adjusted to realize target stoichiometry on the grown films. Finally, through optimization steps, as revealed by the X-ray photoelectron spectroscopy, stoichiometric BaTiO 3 films were obtained, at a pressure ≥ 2.7 Pa, power density of 2 W/cm 2 and P o around 50%.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Electronic and Structural Properties of Oxides · Semiconductor materials and devices · Ferroelectric and Piezoelectric Materials
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.