Influence of the preparation conditions on the properties of CuInS2 films deposited by one-stage RF reactive sputtering
Source abstract
Abstract
Abstract We investigated systematically the influence of the sputter parameters, such as substrate temperature, H 2 S flow, and sputter power on the structural, optical, and electrical properties of the sputtered CuInS 2 films, to optimize the parameters for the one-stage growth of CuInS 2 films by radio frequency (RF) reactive sputtering. When the H 2 S flow during sputtering is too low, there are mainly Cu–In secondary phases coexisting in the films. With a RF power of 200 W and a H 2 S flow in the range of 20–30 sccm (standard cubic centimeter per minute), high quality films with good adhesion can be sputtered on bare float glass at a substrate temperature of 400 °C or above. A higher substrate temperature (500 °C) resulted in bigger grain sizes of the films. Moreover, the films sputtered at 500 °C showed a sharper absorption edge than those sputtered at 400 °C, and the corresponding band gap shifted from approximately 1.27 to 1.44 eV. Mo- or ZnO-coatings of the substrates can help to reduce the substrate temperature to 200 °C, and work effectively as a barrier to prevent Na diffusion from the substrates into the sputtered CuInS 2 layers.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Copper-based nanomaterials and applications · ZnO doping and properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.