article·2008-10-30

Polypyrrole thin films for gas sensors prepared by Matrix-Assisted Pulsed Laser Evaporation technology: Effect of deposition parameters on material properties

Dušan Kopecký, Martin Vrňata, Filip Vysloužil, V. Myslík, Přemysl Fitl, Ondřej Ekrt, Pavel Matějka, M. Jelı́nek, T. Kocourek

Publisher page

Abstract

Abstract Thin films of polypyrrole (PPY) were prepared by Matrix-Assisted Pulsed Laser Evaporation (MAPLE) technology from two matrices: water and dimethylsulfoxide (DMSO). The deposition was carried out using a KrF excimer laser (laser fluence F ranged from 0.1 to 0.6 J cm− 2). This work deals with optimization of two deposition parameters – laser fluence and number of pulses – for both matrices. From the deposition curves, the fluence thresholds, Fth, and maximum growth rates were subsequently determined (water matrix: Fth ~ 0.40–0.45 J cm− 2, maximum growth rate 0.16 nm pulse− 1; DMSO matrix: Fth ~ 0.25–0.30 J cm− 2; maximum growth rate 0.20 nm pulse− 1). The changes in chemical composition of deposited layers were studied by Attenuated Total Reflection Fourier Transform Infrared spectroscopy. Surface morphology was characterized by Atomic Force Microscopy. A discussion is also presented concerning relationships between laser fluence and chemical composition of deposited layers with respect to their potential application in gas sensors. Finally, the response of a sensor with a MAPLE deposited PPY active layer to air humidity is presented.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Gas Sensing Nanomaterials and Sensors · Analytical Chemistry and Sensors · Advanced Chemical Sensor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.