Fabrication of scandium stabilized zirconia thin film by electrostatic spray deposition technique for solid oxide fuel cell electrolyte
Source abstract
Abstract
Abstract A cost-effective and promising simple deposition method, electrostatic spray deposition (ESD), was used to fabricate dense scandium stabilized zirconia (ScSZ) thin films. The effect of solvent mixtures on their surface morphology was investigated. The films deposited using a mixed ethanol-butyl carbitol solvent with high boiling point showed higher smoothness compared with those deposited using ethanol and a mixture of ethanol and ethylene glycol, respectively. Single-phase ScSZ dense films were formed within 2 h at a low deposition temperature of 450 °C. Analysis of as heat-treated films using scanning electron microscope and atomic force microscope also indicated the formation of the uniform, smooth and dense thin films even at a low densification temperature. Furthermore, the ScSZ film deposited under the optimal condition showed the maximum in electrical conductivity of approximately 0.33 S cm − 1 at a low operating temperature of 800 °C.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Advancements in Solid Oxide Fuel Cells · Electronic and Structural Properties of Oxides · Semiconductor materials and devices
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.