article·2011-12-14

Behavior of Cu nanoparticles ink under reductive calcination for fabrication of Cu conductive film

Kiyonobu Ida, Masanori Tomonari, Yasuyuki Sugiyama, Yuki Chujyo, Tomoharu Tokunaga, Tetsu Yonezawa, Kotaro Kuroda, Katsuhiro Sasaki

Publisher page

Abstract

Abstract Cu nanoparticle ink was prepared from Cu nanoparticles that were coated with a gelatin layer at an average diameter of 46 nm. The Cu nanoparticle ink was applied on the polyimide substrate. Conductive films were fabricated using the Cu nanoparticle ink with a two-step annealing process consisting of oxidative pre-heating at 200 °C under 10 ppm O2–N2 mixed gas flow and reductive calcination at 250 °C under 3 vol.% H2–N2 mixed gas flow showed a low resistivity of 5 μΩ cm. The hydrolysis of the remaining gelatin layer by H2O vapor, which was formed during the reduction of the Cu oxide by 3 vol.% H2–N2 mixed gas, was suggested. The results suggest the possibility of the removal of the gelatin layer without oxidative pre-heating and simultaneous sintering of Cu nanoparticles in reductive calcination.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Nanomaterials and Printing Technologies · Nanofabrication and Lithography Techniques · Advanced Sensor and Energy Harvesting Materials

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.