The influence of thermal treatment on the microstructure and hardness in electroless Ni–P–W deposit
Source abstract
Abstract
Ni–P–W alloy deposit on the mild steel substrate was obtained by the electroless process. Various thermal heat-treatment temperatures from 350 to 600 °C for 4 h were performed on the coating to evaluate the effect of crystallization behavior and grain size on the mechanical properties. The microstructure at as-deposited and heat-treatment states were investigated by the X-ray diffraction (XRD) and transmission electron microscope (TEM). The hardness at all depths of the coating on the substrate could be acquired by the nanoindentation. The Ni–P–W coating showed an amorphous structure in the as-deposited state and exhibited a relatively low hardness of approximately 6.8 GPa. As temperature was raised to 380 °C, the hardness was slightly increased to 8.7 GPa due to the partial precipitation of Ni and Ni3P in the amorphous matrix. On heating to 500 °C for 4 h, the hardness reached the maximum value of 12.3 GPa with a grain size of 33.1 nm and followed by gradual degradation above 500 °C. The Young modulus of the amorphous Ni–P–W coating showed a relatively low value of 195 GPa. However, for increasing the heat-treatment temperature accompanied with the grain growth, the Young modulus was enhanced to the maximum of 233 GPa and then decreased gradually with temperature.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Electrodeposition and Electroless Coatings · Metal and Thin Film Mechanics · Advanced materials and composites
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References
Reference metadata was not supplied for this record.