article·2001-11-01

Micro/nanomechanical and tribological studies of bulk and thin-film materials used in magnetic recording heads

Xiaodong Li, Bharat Bhushan

Publisher page

Abstract

Abstract Micro/nanomechanical characterization of the bulk Al 2 O 3 –TiC and Ni–Zn ferrite, and thin films of Co–Zr–Ta and Al 2 O 3 used in magnetic recording heads have been carried out. Hardness, elastic modulus and scratch resistance of these materials were measured by nanoindentation and microscratching using a nanoindenter. Fracture toughness was measured by indentation using cube corner and Vickers indenters. Friction and wear properties for these materials were measured using an accelerated ball-on-flat tribometer. Al 2 O 3 –TiC shows the highest hardness, elastic modulus and scratch resistance as well as the lowest wear damage, followed by the Ni–Zn ferrite, Al 2 O 3 films, and Co–Zr–Ta film. The Co–Zr–Ta film exhibits the highest fracture toughness, followed by the Al 2 O 3 –TiC, Al 2 O 3 films and Ni–Zn ferrite. There exists a good correlation between mechanical properties and wear damage. Higher mechanical properties result in less wear damage. In general, the bulk Al 2 O 3 –TiC and Ni–Zn ferrite show lower damage than the Co–Zr–Ta and Al 2 O 3 films. For the thin films studied, the Al 2 O 3 films show higher mechanical properties and less scratch and wear damage.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Copper Interconnects and Reliability · Advanced materials and composites

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References

Reference metadata was not supplied for this record.