Near-neutral pre-extraction of hemicelluloses and subsequent kraft pulping of southern mixed hardwoods
Source abstract
Abstract
Southern mixed hardwood chips were extracted with alkaline solutions at different chemical charges, times (45-110 min), and temperatures (125°C-160°C). At high alkali charges (10% and 20% sodium hydroxide [NaOH] as sodium oxide [Na2O]), the extract was strongly alkaline (pH about 13) and 17%-40% of the wood was dissolved. Subsequent kraft cooking of the extracted chips yielded 5%-7% less pulp than that of control kraft pulps. However, at reduced alkali charge, just sufficient to approximately neutralize the acids released during pre-extraction, the pulp yield (on original wood) after subsequent kraft pulping was not affected. In this case, about 5%-10% of the wood substance is removed during pre-extraction with 3% NaOH or 3% green liquor (+0.05% anthraquinone) at 140°C and 160°C for 60, 90, and 110 min. The green liquor extract obtained after 110 min at 160°C contained 2.1% (oven-dry weight basis) of sugars, 2.1% acetic acid, and 1.6% lignin accounting for 64% of the wood weight loss. Kraft pulping of the pre-extracted wood chips performed at 12% effective alkali charge showed significantly improved delignification rates and approximately the same or slightly higher yield than the kraft control at 15% effective alkali. The near-neutral green liquor+anthraquinone pre-extraction kraft pulps showed lower refining response but higher tear resistance and similar tensile strength compared to control kraft pulps.
Source: crossref · Quality: baseline
Research context
OpenAlex topics: Lignin and Wood Chemistry · Advanced Cellulose Research Studies · Polysaccharides Composition and Applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (22)
Show source-provided references
1. van Heiningen, A.R.P., Pulp Pap. Can. 107(6): 38(2006).
2. Gullichsen, J. and Fogelholm, C-J., Eds., Chemical Pulping, Book 6B, Fapet Oy, Helsinki, Finland, 2000.
3. Gullichsen, J. and Fogelholm, C-J., Eds., Chemical Pulping, Book 6A, Fapet Oy, Helsinki, Finland, 1999.
4. Yoon, S-H., MacEwan, K., and van Heiningen, A.R.P., TAPPI Eng., Pulping Environ. Conf., TAPPI PRESS, Atlanta, GA, USA, 2006, Conf. CD.
5. Yoon, S-H., MacEwan, K., and van Heiningen, A.P.R., TAPPI J. 7(6): 27 (2008).10.32964/TJ7.6.27 ↗
6. Yoon, S-H. and van Heiningen, A.R.P., TAPPI J. 7(7): 27(2008).10.32964/TJ7.7.22 ↗
7. Mao, H., Yoon, S-H., Genco, J., et al., Finnish Recovery Boiler Committee Annu. Meet., Vantaa, Finland, 2007.
8. Al-Dajani, W.W. and Tschirner, U., TAPPI Eng., Pulping Environ. Conf., TAPPI PRESS, Atlanta, 2006, Conf. CD.
9. Al-Dajani, W.W. and Tschirner, U., TAPPI J. 7(6): 3(2008).10.32964/TJ7.6.3 ↗
10. Amidon, T.E., Bolton, T.S., Francis, R.C., et al., TAPPI Eng., Pulping Environ. Conf., TAPPI PRESS, Atlanta, 2006, Conf. CD.
11. Lora, J.H. and Wayman, M., Tappi 61(6): 47(1978).
12. Davis, M.W., J. Wood Chem. Tech. 18(2): 235(1998).10.1080/02773819809349579 ↗
13. Pronto, M.B., TAPPI Pulping Conf., TAPPI PRESS, Atlanta, 1998, p. 1477.
14. Scott, R.W. Anal. Chem. 51(7): 936(1979).10.1021/ac50043a036 ↗
15. Tunc. M.S. and van Heiningen, A.R.P., Nord. Pulp Pap. Res. J. 24(1): 42(2009).10.3183/npprj-2009-24-01-p046-051 ↗
16. Radiotis, T., Sullivan, J., MacLeod, M., et al., TAPPI Eng., Pulping Environ. Conf., TAPPI PRESS, Atlanta, 2007, Conf. CD.
17. van Heiningen, A.R.P., Tunc, M.S., Gao, Y., et al., J. Pulp Pap. Sci. 30(8): 211(2004).
18. Yoon, S-H., van Heiningen, A.R.P., and Krishnagopalan, A., TAPPI Eng., Pulping Environ. Conf., TAPPI PRESS, Atlanta, 2008, Conf. CD.
19. Casey, J.P., Pulp and Paper Chemistry and Chemical Technology. Interscience Publishers, New York, 1952, vol. 1, p. 352.
20. Braun, F.E. and Lewis, H.F., Pap. Trade J. 105(10): 35(1937).
21. Clark, J.d’A., Pulp Technology and Treatment for Paper, Miller Freeman Publications, San Francisco, CA, USA, 1985, p. 173.
22. Institute of Paper Chemistry, Pap. Trade J. 118(5): 499(1957).