journal article·2022-06-03Open access

Metallic MoS2 enhances the performance of water-based drilling fluids

West Branch of Sinopec North China Petroleum Engineering Co., Ltd, Zhengzhou, 450000, P.R. China, F. L. Sun, Y.L. Song, West Branch of Sinopec North China Petroleum Engineering Co., Ltd, Zhengzhou, 450000, P.R. China, H. Tang, West Branch of Sinopec North China Petroleum Engineering Co., Ltd, Zhengzhou, 450000, P.R. China, J. Xu, West Branch of Sinopec North China Petroleum Engineering Co., Ltd, Zhengzhou, 450000, P.R. China

Chalcogenide Letters· Volume 19· Issue 5

Abstract

In this work, the metal phase MoS2 was prepared by a simple one-step hydrothermal method, and it was systematically studied by XRD, Raman, SEM, TEM, and other characterization methods. In addition, the tribological behavior of M-MoS2 in water-based drilling fluids has been extensively studied with a ball-disk tribometer. In addition, the influence of applied load and speed on friction performance is also studied. The experimental results show that the introduction of M-MoS2 significantly reduces the friction and wear of the material. Among them, M-MoS2-5-water-based drilling fluid has the lowest friction coefficient (~0.11).
Source: crossref · Quality: baseline

Research context

OpenAlex topics: Metal and Thin Film Mechanics · Corrosion Behavior and Inhibition · Lubricants and Their Additives

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (34)

Show source-provided references
1. [1] K. Holmberg, P. Andersson, et al., Tribol. Int. 47 (2012); https://doi.org/10.1016/j.triboint.2011.11.02210.1016/j.triboint.2011.11.022 ↗
2. [2] A. Tomala, A. Karpinska, et al., Wear 269 (2010); https://doi.org/10.1016/j.wear.2010.08.00810.1016/j.wear.2010.08.008 ↗
3. [3] E. Serpini, A. Rota, et al. Nanoscale frictional properties of ordered and disordered MoS2, Tribol. Int. 136 (2019); https://doi.org/10.1016/j.triboint.2019.03.00410.1016/j.triboint.2019.03.004 ↗
4. [4] K. Ming, H. Minmin, et al. In situ formation of spherical MoS2 nanoparticles for ultra-low friction. Nanoscale, (2018).
5. [5] Y. X. Wang, Y. Y. Du, et al., Colsurfa 562 (2019); https://doi.org/10.1016/j.colsurfa.2018.11.04710.1016/j.colsurfa.2018.11.047 ↗
6. [6] Y. W. Hu, Y. Xin, et al. BLG-RGO: A novel nanoadditive for water-based lubricant. Tribol. Int. (2019).
7. [7] M. J. Shariatzadeh, D. Grecov, et al., Cellulose, (2019); https://doi.org/10.1007/s10570-019-02398-w10.1007/s10570-019-02398-w ↗
8. [8] Y. Wang, N. Li, et al., RES CHEM INTERMEDIAT, (2021). https://doi.org/10.1007/s11164-020-04356-910.1007/s11164-020-04356-9 ↗
9. [9] H. Wu, J. wei, et al., J MANUF PROCESS, (2017); https://doi.org/10.1016/j.jmapro.2017.03.01110.1016/j.jmapro.2017.03.011 ↗
10. [10] Y. Hu, Y. Wang, et al., Carbon, (2018); https://doi.org/10.1016/j.carbon.2018.05.00910.1016/j.carbon.2018.05.009 ↗
11. [11] H. T. Nguyen, K. H. Chung, et al., Materials, (2020); https://doi.org/10.3390/ma1323554510.3390/ma13235545 ↗
12. [12] Y Hu, Y Wang, C Wang, et al., Carbon, (2019); https://doi.org/10.1016/j.carbon.2019.06.04710.1016/j.carbon.2019.06.047 ↗
13. [13] R. Qiang, L. Hu, et al., Tribology Letters, (2019); https://doi.org/10.1007/s11249-019-1177-410.1007/s11249-019-1177-4 ↗
14. [14] P. Guo, L. Chen, et al., ACS Appl. Nano Mater, (2018); https://doi.org/10.1021/acsanm.8b0165310.1021/acsanm.8b01653 ↗
15. [15] B. Luan, R. Zhou, et al., APPL PHYS LETT, (2016); https://doi.org/10.1063/1.494484010.1063/1.4944840 ↗
16. [16] W. Chen, C. Tang, et al., Extreme Mech. Lett, (2020); https://doi.org/10.1016/j.eml.2020.10099610.1016/j.eml.2020.100996 ↗
17. [17] B. Shi, X. Gan, et al., Nanoscale, (2021); https://doi.org/10.1039/D1NR04252A10.1039/D1NR04252A ↗
18. [18] R. P. Wu, Z. Liu, et al. Growth of MoS2 Nanotubes Templated by Halloysite Nanotubes for the Reduction of Friction in Oil. ACS Omega, (2018).
19. [19] B. Mba, C. Ms, et al. Friction control by engineering the crystallographic orientation of the lubricating few-layer MoS2 films. APPL SURF SCI, (2021).
20. [20] X. zhong, Z. Y. Tian, et al. Probing the difference in friction performance between graphene and MoS2 by manipulating the silver nanowires. J. Mater. Sci, (2019).
21. [21] H. Ye, Z. J. Ye, et al. Origin of Nanoscale Friction Contrast between Supported Graphene, MoS2, and a Graphene/MoS2 Heterostructure. Nano Letters, (2019).
22. [22] Y. Q. Xing, Z. Wu, et al., Surf. Coat. Technol, (2020); https://doi.org/10.1016/j.surfcoat.2020.12539610.1016/j.surfcoat.2020.125396 ↗
23. [23] Z. Yang, S. Bhowmick, et al., APPL SURF SCI, (2021); https://doi.org/10.1016/j.apsusc.2021.15027010.1016/j.apsusc.2021.150270 ↗
24. [24] B. Chen,X. Li, et al., Compos. Part A Appl. Sci. Manuf, (2018); https://doi.org/10.1016/j.compositesa.2018.02.03910.1016/j.compositesa.2018.02.039 ↗
25. [25] J. Xu, H. Tang, et al., Rsc Advances, (2015); https://doi.org/10.1039/C5RA06999H10.1039/C5RA06999H ↗
26. [26] X. Li, Z. Cao, et al., APPL SURF SCI, (2006); https://doi.org/10.1016/j.apsusc.2005.09.06810.1016/j.apsusc.2005.09.068 ↗
27. [27] L. Rapoport, V. Leshchinsky, et al., Wear, (2003); https://doi.org/10.1016/S0043-1648(03)00044-910.1016/S0043-1648(03)00044-9 ↗
28. [28] J. Xu, H. Tang, et al. Facile synthesis and characterization of flower-like MoS2 microspheres. Chalcogenide Letters, (2014).
29. [29] R. Tong, B. Han, et al., MICROGRAVITY SCI TEC, (2021); https://doi.org/10.1007/s12217-021-09896-210.1007/s12217-021-09896-2 ↗
30. [30] L. Kong, K. Huang, et al., Ceramics International, (2021); https://doi.org/10.1016/j.ceramint.2021.04.15510.1016/j.ceramint.2021.04.155 ↗
31. [31] A. Mukherji, L. Saikia, et al., Chem. Eng. J., (2019); https://doi.org/10.1016/j.cej.2019.05.13310.1016/j.cej.2019.05.133 ↗
32. [32] S. Bolar, S. Shit, et al., Appl. Catal. B, (2019); https://doi.org/10.1016/j.apcatb.2019.04.02810.1016/j.apcatb.2019.04.028 ↗
33. [33] F. Ma, Y. Liang, et al., MATER CHEM PHYS, (2020); https://doi.org/10.1016/j.matchemphys.2020.12264210.1016/j.matchemphys.2020.122642 ↗
34. [34] S. Wang, D. Zhang, et al ADV ENERGY MATER, (2018); https://doi.org/10.1002/aenm.20180134510.1002/aenm.201801345 ↗