journal article·2015-12

The low-temperature deposition of textured multilayer back reflectors with enhanced light-scattering properties on polymeric substrates

Jun-Sik Cho, Dongmin Lim, Bo-Hun Choi, Seungkyu Ahn, Ara Cho, Kihwan Kim, Jinsu Yoo, Joo Hyung Park

Publisher page

Abstract

Abstract In this article, we report on the low-temperature deposition of textured back reflectors using sputtered ZnO:Al/Ag/Al:Si layers in flexible nanocrystalline silicon (nc-Si:H) thin-film solar cells. The surface morphology of this multilayer system depends on that of the Al:Si bottom layers, whereas its optical properties are determined by the Ag and ZnO:Al films deposited on top of the Al:Si layers. The nc-Si:H thin-film solar cells fabricated on textured ZnO:Al/Ag/Al:Si multilayer back reflectors showed an enhanced spectral response for wavelengths between 650 nm and 1100 nm when compared with cells with flat multilayer back reflectors. A high conversion efficiency of 7.25% was successfully achieved for a solar cell with a moderately textured ZnO:Al/Ag/Al:Si multilayer back reflector with a root-mean-square roughness (σrms) of 30.2 nm deposited at low substrate temperature of 75 °C in which an additional current gain of 2 mA/cm2 was obtained by effective light scattering from the textured surface without any reduction in the open circuit voltage and the fill factor compared with a solar cell with the flat multilayer back reflector with σrms=9.13 nm. This result confirms that textured ZnO:Al/Ag/Al:Si multilayer back reflectors prepared at a low substrate temperature of 75 °C can be used in flexible silicon thin-film solar cells using polymeric substrates with low heat resistance.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Thin-Film Transistor Technologies · Silicon and Solar Cell Technologies · Advanced Surface Polishing Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (15)

Show source-provided references
1. Effect of argon plasma-treated polyethylene terepthalate on ZnO:Al properties for flexible thin film silicon solar cells applications
2. Efficient flexible thin film silicon module on plastics for indoor energy harvesting10.1016/j.solmat.2014.07.048 ↗
3. Flexible n–i–p thin film silicon solar cells on polyimide foils with textured ZnO:Ga back reflector10.1016/j.tsf.2014.09.026 ↗
4. Remarkable progress in thin-film silicon solar cells using high-efficiency triple-junction technology10.1016/j.solmat.2013.04.016 ↗
5. High open-circuit voltage (1.04V) n–i–p type thin film silicon solar cell by two-phase silicon carbide intrinsic material10.1016/j.solmat.2014.08.011 ↗
6. Optical modeling of a-Si:H solar cells with rough interfaces: effect of back contact and interface roughness10.1063/1.1324690 ↗
7. New progress in the fabrication of n–i–p micromorph solar cells for opaque substrates10.1016/j.solmat.2013.02.032 ↗
8. Impact of front and rear texture of thin-film microcrystalline silicon solar cells on their light trapping properties10.1063/1.3467968 ↗
9. Fundamental structure forming phenomena of polycrystalline films and the structure zone models10.1016/S0040-6090(97)00503-8 ↗
10. Microstructural evolution during film growth10.1116/1.1601610 ↗
11. Fabrication of dc sputtered Ag/Al:Si bilayers with improved optical reflectance
12. Study of back reflectors for thin film silicon solar cells10.1016/j.tsf.2013.05.019 ↗
13. Absorption loss at nanorough silver back reflector of thin-film silicon solar cells10.1063/1.1633652 ↗
14. Study of back reflectors for amorphous silicon alloy solar cell application10.1063/1.347418 ↗
15. Structural defects caused by a rough substrate and their influence on the performance of hydrogenated nano-crystalline silicon n–i–p solar cells10.1016/j.solmat.2008.11.013 ↗