journal article·2020-03

Comments on the paper: “Thermoelectric properties and thermal stress simulation of pressureless sintered SiC/AlN ceramic composites at high temperatures” published by Dina H.A. Besisa in Solar Energy Materials & Solar Cells 182 (2018) 302–313

Jiahao Wang, Xianbin Jia, Darrin Sime Nkemeni, Guihui Li, Shaomin Zhou

Publisher page

Abstract

Abstract We find it necessary to contribute by the addendum to a serious and objective scientific discussion on the relationship between Seebeck coefficient and electrical resistivity with the change of doping amount. In the comment, we argue that Seebeck coefficient and electrical resistivity of the solid materials must theoretically vary simultaneously with the changing doping amount as this phenomenon has been observed in previous publications [1–4]. However, in the recent report (Solar Energy Materials & Solar Cells, 2018, 182, 302–313), α and ρ show a negative correlation with changing doping amount, which is invalid conclusion because it is based on a mistake. Apart from the wrong correlation, we also contend that the formula used to calculate the ZT was wrongly stated (from line 3 to line 9 on page 304)[5], which introduces doubts about their results. The figure of merit of thermoelectric material is given by Z T = α 2 σ κ T , where α is the Seebeck coefficient; σ is the electrical conductivity; κ is the thermal conductivity; T is the absolute temperature. We equally observe a considerable discrepancy between descriptions and experimental results as demonstrated from line 1 to line 7 on page 307, which disagrees with Figs. 6 and 7 in Ref. 5.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Advanced Thermoelectric Materials and Devices · Thermal properties of materials · Thermal Radiation and Cooling Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (15)

Show source-provided references
1. Electrical and thermal transport properties of Pb1-xSnxSe solid solution thermoelectric materials10.1039/C4CP06021K ↗
2. Complex thermoelectric materials10.1038/nmat2090 ↗
3. Advances in thermoelectric materials research: looking back and moving forward10.1126/science.aak9997 ↗
4. Enhanced thermoelectric performance of SmBaCuFeO5+δ/Ag composite ceramics10.1111/jace.14062 ↗
5. Thermoelectric properties and thermal stress simulation of pressureless sintered SiC/AlN ceramic composites at high temperatures10.1016/j.solmat.2018.03.032 ↗
6. New and old concepts in thermoelectric materials10.1002/anie.200900598 ↗
7. A fan-tastic quantitative exploration of Ohm's Law10.1119/1.5021431 ↗
8. High-performance bulk thermoelectrics with all-scale hierarchical architectures10.1038/nature11439 ↗
9. Gated Si nanowires for large thermoelectric power factors
10. Preparation of Bi2Te3/nano-SiC composite thermoelectric films by electrodeposition10.1007/s11664-015-3747-z ↗
11. Low temperature thermoelectric properties of p-type doped single-crystalline SnSe
12. Double doping induced power factor enhancement in CuCrO2 for high temperature thermoelectric application10.1016/j.jallcom.2018.10.083 ↗
13. Study on thermoelectric performance by Na doping in nanostructured Mg1-xNaxAg0.97Sb0.9910.1016/j.nanoen.2014.11.027 ↗
14. Average drift time and average mobility in ion mobility spectrometry10.1016/j.ijms.2016.11.016 ↗
15. Energy band gap, intrinsic carrier concentration, and fermi level of CdTe bulk crystal between 304 and 1067 K10.1063/1.2899087 ↗