journal article·2025-09Open access

Influence of deposition power of PECVD intrinsic a-Si:H buffer layer on n+ poly-Si/SiO /c-Si passivating contacts

Zhirong Yao, Wanyu Si, Yingwen Zhao, Paul Procel Moya, Engin Özkol, Guangtao Yang, Prasad Gonugunta, Prasaanth Ravi Anusuyadevi, Peyman Taheri, Olindo Isabella

Abstract

Optimizing the deposition parameters in the fabrication of passivating contacts for crystalline silicon solar cells is critical for improving efficiency. This study explored the influence of varying RF power of Plasma-Enhanced Chemical Vapor Deposition (PECVD) on the quality of hydrogenated intrinsic amorphous silicon ( a-Si:H) films. The aim is to manufacture in-situ phosphorous-doped poly-Si/SiO x /c-Si passivating contacts with a-Si:H as buffer layer between the tunnelling oxide and the n-type poly-Si. The microstructure factor of our intrinsic layers increases from 0.176 to 0.804, that is from higher to lower film density, as the RF power increases from 5 W to 55 W. Analysis using X-ray Photoelectron Spectroscopy and Optical Microscopy indicates that the Si content in SiO x is correlated with the formation of pinholes. Our detailed analysis showed that varying the RF power when depositing a-Si:H contacting layer is crucial in altering both the Si 4+ content in SiO x and the pinhole density, due to the interplay between the plasma etching and the buffering effects during of the a-Si:H layer growth. Notably, the sample processed with 25 W exhibited the maximum pinhole density, the lowest Si 4+ content in SiO x and the deepest phosphorus in-diffusion, potentially yielding superior results in passivation quality and contact resistivity under optimized PECVD conditions. • Investigated the influence of PECVD intrinsic a-Si:H deposition power on n + poly-Si/SiOx/c-Si passivating contacts. • Revealed that increased RF power enhances plasma etching and modifies SiOx stoichiometry and Si 4+ content. • Clarified pinhole density evaluation methods and improved XPS data calibration with C1s correction. • Demonstrated that hydrogen plasma effects dominate passivation improvements compared to LPCVD references. • Insights contribute to the development of high-performance poly-SiOx passivating contacts for TOPCon solar cells.
Source: openalex_inverted_index · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (50)

Show source-provided references
1. A wafer-based monocrystalline silicon photovoltaics road map: utilizing known technology improvement opportunities for further reductions in manufacturing costs10.1016/j.solmat.2013.01.030 ↗
2. Passivating contacts for crystalline silicon solar cells10.1038/s41560-019-0463-6 ↗
3. A passivated rear contact for high-efficiency n-type silicon solar cells
4. Laser contact openings for local poly-Si-metal contacts enabling 26.1%-efficient POLO-IBC solar cells10.1016/j.solmat.2018.06.020 ↗
5. For none, one, or two polarities—how do POLO junctions fit best into industrial Si solar cells?10.1002/pip.3201 ↗
6. Silicon-based passivating contacts: the TOPCon route
7. Passivated rear contacts for high-efficiency n-type Si solar cells providing high interface passivation quality and excellent transport characteristics10.1016/j.solmat.2013.09.017 ↗
8. Poly-crystalline silicon-oxide films as carrier-selective passivating contacts for c-Si solar cells10.1063/1.5027547 ↗
9. Highly passivating and blister-free hole selective poly-silicon based contact for large area crystalline silicon solar cells10.1016/j.solmat.2019.109912 ↗
10. Evolution of the surface passivation mechanism during the fabrication of ex-situ doped poly-Si(B)/SiOx passivating contacts for high-efficiency c-Si solar cells10.1016/j.solmat.2020.110899 ↗
11. Poly-SiOx passivating contacts with plasma-assisted N2O oxidation of silicon (PANO-SiOx)10.1002/solr.202300186 ↗
12. Screen printed Ag contacts for n-type polysilicon passivated contacts10.1063/1.5123829 ↗
13. Material properties of LPCVD processed n-type polysilicon passivating contacts and its application in PERPoly industrial bifacial solar cells10.1016/j.egypro.2017.09.250 ↗
14. Optimization of in-situ and ex-situ doped p+ passivating contact for high efficiency p-TOPCon solar cell application
15. 26.1%-efficient POLO-IBC cells: quantification of electrical and optical loss mechanisms10.1002/pip.3098 ↗
16. High-quality amorphous silicon thin films for tunnel oxide passivating contacts deposited at over 150 nm/min
17. Ultrathin silicon oxide prepared by in-line plasma-assisted N2O oxidation (PANO) and the application for n-type polysilicon passivated contact10.1016/j.solmat.2019.110389 ↗
18. Comparison of different types of interfacial oxides on hole-selective p+-poly-Si passivated contacts for high-efficiency c-Si solar cells10.1016/j.solmat.2020.110487 ↗
19. Influence of plasma-enhanced chemical vapor deposition poly-Si layer thickness on the wrap-around and the quantum efficiency of bifacial n-TOPCon (tunnel oxide passivated contact) solar cells
20. Morphology, microstructure, and doping behaviour: a comparison between different deposition methods for poly‐Si/SiO x passivating contacts
21. Tunnel oxide passivated carrier-selective contacts based on ultra-thin SiO2 layers10.1016/j.solmat.2015.06.048 ↗
22. Working principle of carrier selective poly-Si/c-Si junctions: is tunnelling the whole story?10.1016/j.solmat.2016.05.045 ↗
23. Will SiOx-pinholes for SiOx/poly-Si passivating contact enhance the passivation quality?10.1016/j.solmat.2023.112200 ↗
24. Studying dopant diffusion from Poly-Si passivating contacts10.1016/j.solmat.2019.109978 ↗
25. High pressure processing of hydrogenated amorphous silicon solar cells: relation between nanostructure and high open-circuit voltage10.1063/1.4907316 ↗
26. Doped hydrogenated nanocrystalline silicon oxide layers for high-efficiency c-Si heterojunction solar cells10.1002/pip.3256 ↗
27. Oxygen-alloyed poly-Si passivating contacts for high-thermal budget c-Si heterojunction solar cells
28. A simple method with analytical model to extract heterojunction solar cell series resistance components and to extract the a-Si:H(I/P) to transparent conductive oxide contact resistivity
29. Infrared absorption strength and hydrogen content of hydrogenated amorphous silicon
30. Beyer
31. For none, one, or two polarities—how do POLO junctions fit best into industrial Si solar cells?10.1002/pip.3201 ↗
32. Simple cleaning and conditioning of silicon surfaces with UV/ozone Sources10.1016/j.egypro.2014.08.067 ↗
33. Ultrathin silicon oxide prepared by in-line plasma-assisted N2O oxidation (PANO) and the application for n-type polysilicon passivated contact
34. A strong-oxidizing mixed acid derived high-quality silicon oxide tunneling layer for polysilicon passivated contact silicon solar cell10.1016/j.solmat.2018.09.001 ↗
35. Surface oxidation states of germanium10.1016/0039-6028(86)90767-3 ↗
36. Effects of RF power and working pressure on the properties of nc-Si:H thin films deposited by an ICP-CVD system
37. Properties of high growth rate amorphous silicon deposited by MC-RF-PECVD10.1016/S0042-207X(01)00293-7 ↗
38. Plasma-enhanced chemical vapor deposition of silicon nitride10.1143/JJAP.31.336 ↗
39. Hydrogen in amorphous and microcrystalline silicon films prepared by hydrogen dilution10.1063/1.363541 ↗
40. In situ-doped silicon thin films for passivating contacts by Hot-wire chemical vapor deposition with a high deposition rate of 42 nm/min10.1021/acsami.9b10360 ↗
41. Temperature dependence of the surface roughness evolution during hydrogenated amorphous silicon film growth10.1063/1.1543237 ↗
42. Topography simulation of novel processing techniques
43. EI-Kareh · 2012
44. RF sputtering: a viable tool for MEMS fabrication, Sadhana - Acad
45. Process analysis and optimization on PECVD amorphous silicon on glass substrate10.1088/1742-6596/34/1/134 ↗
46. Nucleation mechanism of microcrystalline silicon from the amorphous phase10.1016/j.jnoncrysol.2004.02.029 ↗
47. Local enhancement of dopant diffusion from polycrystalline silicon passivating contacts10.1021/acsami.2c01801 ↗
48. Auger coefficients for highly doped and highly excited semiconductors10.1063/1.89694 ↗
49. Enhancement of Band-to-Band auger recombination by electron-hole correlations10.1103/PhysRevLett.65.215 ↗
50. Unraveling the passivation mechanisms of c-Si/SiOx/poly-Si contacts10.1016/j.solmat.2022.112047 ↗