journal article·2018-06Open access

Injection intensity-dependent recombination at various grain boundary types in multicrystalline silicon solar cells

F. Frühauf, P.P. Altermatt, T. Luka, T. Mehl, H. Deniz, O. Breitenstein

Abstract

Abstract If the ratio of two open circuit photoluminescence ( V oc -PL) images taken at two different light intensities is displayed, some grain boundaries (GBs) may show up as bright lines. This indicates that these special GBs show distinct injection intensity-dependent recombination properties. It will be shown here that this results in an apparent ideality factor of the light emission smaller than unity. The effect is reproduced with numerical device simulations using a usual distribution of defects in the band gap along grain boundaries. Quantitative imaging of this apparent luminescence ideality factor by PL imaging is complicated by the lateral horizontal balancing currents flowing at open circuit. The local voltage response of an inhomogeneous solar cell at different injection levels under open circuit is modelled by Griddler simulations, based on PL investigations of this cell. The evaluation of V oc -PL images at different illumination intensities allows us to conclude that the apparent luminescence ideality factor at the special GBs is about 0.89, whereas in the other regions it is between 0.94 and 0.95. Reverse bias electroluminescence showed no pre-breakdown sites, and hyperspectral PL imaging showed only in one of the investigated GBs particular defect luminescence. TEM investigations of two GBs, one showing distinct injection intensity-dependent recombination and the other one showing none, revealed that the investigated special GB is a large-angle GB whereas the GB not showing this effect is a small-angle GB.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Integrated Circuits and Semiconductor Failure Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. Correlation between residual strain and electrically active grain boundaries in multicrystalline silicon10.1063/1.2983649 ↗
2. Recombination at Lomer dislocations in multicrystalline silicon for solar cells10.1109/JPHOTOV.2015.2494680 ↗
3. Towards an improved Laplacian-based photoluminescence image evaluation method10.1016/j.solmat.2015.06.020 ↗
4. Correlation of pre-breakdown sites and bulk defects in multicrystalline silicon solar cells10.1002/pssr.200802264 ↗
5. On the origin of inter band gap radiative emission in crystalline silicon10.1063/1.4766588 ↗
6. Spatially resolved series resistance of silicon solar cells obtained from luminescence imaging10.1063/1.2709630 ↗
7. Quantitative luminescence characterization of crystalline silicon solar cells
8. The impact of silicon CCD photon spread on quantitative analyses of luminescence images10.1109/JPHOTOV.2013.2287912 ↗
9. An improved method to measure the point spread function of cameras used for electro- and photoluminescence imaging of silicon solar cells10.1109/JPHOTOV.2016.2514744 ↗
10. Effective diffusion length and bulk saturation current density imaging in solar cells by spectrally filtered luminescence imaging10.1109/JPHOTOV.2016.2571621 ↗
11. Linear-response description of the series resistance of large-area silicon cells: resolving the difference between dark and illuminated behavior10.1016/j.egypro.2016.07.072 ↗
12. Local solar cell efficiency analysis performed by injection-dependent PL imaging (ELBA) and voltage-dependent lock-in thermography (Local I-V)10.1016/j.egypro.2016.07.003 ↗
13. Reduced fill factors in multicrystalline silicon solar cells due to injection-level dependent bulk recombination lifetimes10.1002/1099-159X(200007/08)8:4<363::AID-PIP328>3.0.CO;2-Y ↗
14. Predicted electronic properties of polycrystalline silicon from three-dimensional device modeling combined with defect-pool model
15. The physics of industrial crystalline silicon solar cells
16. Analytic findings in the electroluminescence characterization of crystalline silicon solar cells
17. see 〈http://de.mathworks.com/products/matlab/index.html?requestedDomain=uk.mathworks.com〉, Jan 2017.
18. Finite element simulation of inhomogeneous solar cells based on lock-in thermography and luminescence imaging10.1016/j.solmat.2016.12.037 ↗
19. J. Wong, Griddler: Intelligent computer aided design of complex solar cells, in: Proceedings of the 40th IEEE PVSC, Tampa, 2013, pp. 933–938.10.1109/PVSC.2013.6744296 ↗
20. Understanding junction breakdown in multicrystalline solar cells10.1063/1.3562200 ↗
21. Electron microscope verification of breakdown-inducing α-FeSi2 needles in multicrystalline silicon solar cells10.1063/1.4779601 ↗
22. Spectrally and spatially resolved imaging of photoluminescence in multicrystalline silicon wafers10.1063/1.3607307 ↗
23. Hyperspectral photoluminescence imaging of defects in solar cells10.1255/jsi.2016.a8 ↗
24. Tajima · J. Appl. Phys. · 2012 · 111 · 11352310.1063/1.4728194 ↗
25. Multivariate curve resolution applied to second order data10.1016/0169-7439(95)00047-X ↗
26. Classification of crystal defects in multicrystalline silicon solar cells and wafer using spectrally and spatially resolved photoluminescence10.1063/1.4940711 ↗
27. Defects in multicrystalline Si wafers studied by spectral photoluminescence imaging, combined with EBSD and dislocation mapping10.1016/j.egypro.2016.07.043 ↗
28. Distribution of radiative crystal imperfections through a silicon ingot10.1063/1.4834155 ↗
29. Nano-XRF analysis of metal impurities distribution at PL active grain boundaries during mc-silicon solar cell processing10.1109/JPHOTOV.2016.2621340 ↗