Simulated and measured temperature coefficients in compensated silicon wafers and solar cells
Source abstract
Abstract
Abstract In this paper we perform a thorough investigation of the temperature coefficients of c-Si solar cells and wafers, based on both experimental data and device simulations. Groups of neighboring wafers were selected from different heights of four high performance multicrystalline silicon ingots cast using different dopants concentrations and Si feedstocks; Three different target resistivities of compensated silicon ingots based on Elkem Solar Silicon (ESS®), which are purified through a metallurgical route, and one non-compensated reference ingot. The wafers were processed into Al-BSF and PERCT type solar cells, as well as into lifetime samples subjected to selected solar cell processing steps before being etched down and re-passivated to assess the bulk lifetime of the final cells. Temperature-dependent photoluminescence imaging was used to study the spatial distribution of the carrier lifetime and the temperature coefficient of the lifetime. We observe a beneficial effect of higher doping levels on the temperature coefficients of the short circuit current J S C in PERCT type cells, with the most favorable temperature coefficients are found in the ingot doped to 0.5 Ω-cm. Increasingly beneficial temperature coefficients in J S C is also observed with increasing height in each ingot, which might be attributed to a combination of small variations in the dopant concentrations and to a clear increase in the temperature coefficient of the carrier lifetime with increasing ingot height. The latter point is also in agreement with the changes in the so-called gamma parameter of the open circuit voltage throughout the ingot. To build a more fundamental understanding of the experimental results the temperature dependence of the solar cells was simulated using PC1Dmod6.2. We find that the experimental temperature coefficients of the final cells can be reproduced in device simulations within 8% of and 14% for the V O C and J S C , respectively. The compensation level itself is of minor importance for the cell performance. Instead, the simulations indicate that the observed behavior in the temperature coefficients of the solar cells is mostly explained by differences in the net doping and carrier lifetime of the wafers.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Semiconductor materials and interfaces · Thin-Film Transistor Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (45)
Show source-provided references
1. McCrone · 2018
2. Comparison of the energy consumption in different production processes for solar grade silicon
3. First results from a simplified Elkem Solar route—input to tolerance limits10.1016/j.solmat.2014.04.012 ↗
4. Environmental footprint of Elkem solar Silicon®
5. Solar silicon from a metallurgical route by Elkem Solar: a viable alternative to virgin polysilicon
6. Elkem silicon vs polysilicon: a quantitative impurity element analyses
7. Results on performance and ageing of solar modules based on Elkem Solar Silicon (ESSTM) from installations at various locations10.1016/j.solmat.2014.04.002 ↗
8. Resistivity profiles in multicrystalline silicon ingots featuring Gallium co-doping10.1063/1.5049335 ↗
9. Compensation engineering for silicon solar cells10.1016/j.egypro.2012.02.008 ↗
10. Ga co-doping in Cz-grown silicon ingots to overcome limitations of B and P compensated silicon feedstock for PV applications10.1002/pssc.201000330 ↗
11. A full thermal model for photovoltaic devices10.1016/j.solener.2016.10.033 ↗
12. Assessing the outdoor operating temperature of photovoltaic modules10.1002/pip.813 ↗
13. A materials perspective on one full years performance of multicrystalline Si PV modules in a grid-connected system
14. Temperature dependent photoluminescence imaging calibrated by photoconductance measurements10.1016/j.egypro.2017.09.338 ↗
15. Low temperature-coefficient for solar cells processed from solar-grade silicon purified by metallurgical route10.1002/pip.1104 ↗
16. Irradiance dependent temperature coefficients for MC solar cells from Elkem solar grade silicon in comparison with reference polysilicon10.1016/j.egypro.2014.08.032 ↗
17. General temperature dependence of solar cell performance and implications for device modelling10.1002/pip.496 ↗
18. A simulation model for the density of states and for incomplete ionization in crystalline silicon. I. Establishing the model in Si:P10.1063/1.2386934 ↗
19. A simulation model for the density of states and for incomplete ionization in crystalline silicon. II. Investigation of Si:As and Si:B and usage in device simulation10.1063/1.2386935 ↗
20. Towards a unified low-field model for carrier mobilities in crystalline silicon10.1016/j.solmat.2014.05.047 ↗
21. Recombination in compensated crystalline silicon for solar cells10.1063/1.3555588 ↗
22. Effects of the compensation level on the carrier lifetime of crystalline silicon10.1063/1.2961030 ↗
23. Reduced temperature sensitivity of multicrystalline silicon solar cells with low ingot resistivity
24. Experimental investigation of the optimal ingot resistivity for both the cell performances and the temperature coefficients for different cell architectures
25. Temperature dependent quantum efficiencies in multicrystalline silicon solar cells10.1016/j.egypro.2015.07.093 ↗
26. Photoluminescence imaging for photovoltaic applications10.1016/j.egypro.2012.02.016 ↗
27. Bifacial multicrystalline solar cells with efficiencies above 18% prepared in an industrial production environment
28. Progress in the industrial evaluation of the mc-Si PERCT technology based on boron diffusion10.1016/j.egypro.2015.07.029 ↗
29. PC1D version 5: 32-bit solar cell modeling on personal computers
30. PC1Dmod 6.2 – improved simulation of c-Si devices with updates on device physics and user interface10.1016/j.egypro.2016.07.010 ↗
31. A graphical user interface for multivariable analysis of silicon solar cells using scripted PC1D simulations10.1016/j.egypro.2013.07.251 ↗
32. Implementation of Fermi-Dirac statistics and advanced models in PC1D for precise simulations of silicon solar cells10.1016/j.solmat.2014.06.021 ↗
33. Temperature-dependent modeling of silicon solar cells—eg, ni, recombination, and VOC10.1109/JPHOTOV.2017.2651822 ↗
34. Physics of the temperature coefficients of solar cells10.1016/j.solmat.2015.03.025 ↗
35. Intrinsic carrier concentration and minority‐carrier mobility of silicon from 77 to 300 K10.1063/1.353288 ↗
36. Reassessment of the intrinsic carrier density in crystalline silicon in view of band-gap narrowing10.1063/1.1529297 ↗
37. Intrinsic concentration, effective densities of states, and effective mass in silicon10.1063/1.345414 ↗
38. PC1Dmod 6.1 – state-of-the-art models in a well-known interface for improved simulation of Si solar cells10.1016/j.solmat.2015.05.047 ↗
39. Impact of incomplete ionization of dopants on the electrical properties of compensated p-type silicon10.1063/1.3686151 ↗
40. Improved quantitative description of Auger recombination in crystalline silicon10.1103/PhysRevB.86.165202 ↗
41. Temperature dependence of the band-band absorption coefficient in crystalline silicon from photoluminescence10.1063/1.4862912 ↗
42. Simulating the effect of lifetime non-uniformity on solar cell performance using cmd-PC1D 6 and Griddler 210.1016/j.egypro.2016.07.011 ↗
43. Study of evolution of dislocation clusters in high performance multicrystalline silicon10.1016/j.solmat.2014.02.034 ↗
44. Microstructure of multicrystalline silicon seeded by polysilicon chips and fluidized bed reactor granules10.1016/j.jcrysgro.2016.02.017 ↗
45. Temperature coefficient imaging for silicon solar cells10.1109/JPHOTOV.2018.2828839 ↗