Rapid, simple method for determining the porosity of mesoporous TiO2 films using a quartz crystal microbalance (QCM)
Source abstract
Abstract
Abstract Two different mesoporous films of TiO 2 were coated onto a QCM disc and fired at 450 °C for 30 min. The first film was derived from a sol–gel paste that was popular in the early days of dye-sensitised solar cells, i.e. dssc, research, a TiO 2 (sg) film. The other was a commercial colloidal paste used to make examples of the current dssc cell; a TiO 2 (ds) film. A QCM was used to determine the mass of the TiO 2 film deposited on each disc and the increase in the mass of the film when immersed in water/glycerol solutions with wt% values spanning the range 0–70%. The results of this work reveal that with both TiO 2 mesoporous films the solution fills the film's pores and acts as a rigid mass, thereby allowing the porosity of each film to be calculated as: 59.1% and 71.6% for the TiO 2 (sg) and TiO 2 (ds) films, respectively. These results, coupled with surface area data, allowed the pore radii of the two films to be calculated as: 9.6 and 17.8 nm, respectively. This method is then simplified further, to just a few frequency measurements in water and only air to reveal the same porosity values. The value of the latter ‘one point’ method for making porosity measurements is discussed briefly.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Analytical Chemistry and Sensors · Gas Sensing Nanomaterials and Sensors · TiO2 Photocatalysis and Solar Cells
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (21)
Show source-provided references
1. A perspective on mesoporous TiO2 materials10.1021/cm4014859 ↗
2. Titanium dioxide nanomaterials: synthesis, properties, modifications, and applications10.1021/cr0500535 ↗
3. Bond · 1987
4. Wikipedia. 〈http://en.wikipedia.org/wiki/Anatase〉 (accessed May 2015).
5. Light scattering enhancement from sub-micrometer cavities in the photoanode for dye-sensitized solar cells10.1039/c2jm32401f ↗
6. A comparative study into the photocatalytic properties of thin mesoporous layers of TiO2 with controlled mesoporosity10.1016/j.jphotochem.2007.08.005 ↗
7. Azo Materials. 〈http://www.azom.com/article.aspx?ArticleID=5192〉 (accessed May 2015).
8. J. Rathouský, J. Heyrovsky, Institute of Physical Chemistry of ASCR, Prague, private communication.
9. Wikipedia. 〈http://en.wikipedia.org/wiki/Quartz_crystal_microbalance〉 (accessed May 2015).
10. Verwendung von Schwingquarzen zur Wägung dünner Schichten und zur Mikrowägung10.1007/BF01337937 ↗
11. Frequency of a quartz microbalance in contact with liquid10.1021/ac00285a062 ↗
12. The quartz microbalance: a sensitive tool to probe surface reconstructions on gold electrodes in liquid10.1016/0039-6028(85)90835-0 ↗
13. Liquid density response of a quartz crystal microbalance modified with mesoporous titanium dioxide10.1021/ac9903813 ↗
14. Preparation and characterisation of novel thick sol–gel titania film photocatalysts10.1039/B212865A ↗
15. Mesoporous TiO2 single crystals delivering enhanced mobility and optoelectronic device performance10.1038/nature11936 ↗
16. Dyesol. 〈http://www.dyesol.com/〉 (accessed May 2015).
17. Phase Characterization of TiO2 Powder by XRD and TEM
18. Inficon. 〈http://www.inficon.com/〉 (accessed May 2015).
19. Enhanced performance of dye-sensitized solar cells by an Al2O3 charge-recombination barrier formed by low-temperature atomic layer deposition10.1039/b819337a ↗
20. GCell. 〈http://gcell.com/gcell-labs/titanium-dioxide-coatings-for-dssc〉 (accessed May 2015).
21. Titania particle size effect on the overall performance of dye-sensitized solar cells10.1021/jp068939f ↗