Thermal stability of laser-assisted fired TOPCon solar cells: Crucial insights for module manufacturing, certification testing, and field conditions
Source abstract
Abstract
Laser-assisted firing (LAF) technology, such as laser-enhanced contact optimization (LECO), is increasingly utilized in the mass production of tunnel oxide passivated contact (TOPCon) solar cells. However, concerns regarding the thermal stability of LAF TOPCon remain. This study systematically evaluates the thermal stability of LAF TOPCon cells at both the moderate temperatures encountered during module fabrication and a higher temperature of 450 °C. While soldering did not have a negative impact on cell performance, lamination resulted in a ∼0.29 % absolute power conversion efficiency ( PCE ) loss, primarily due to a reduction in fill factor ( FF ). The degradation is driven mainly by an increase in J 02 -like recombination, likely in the space charge region. A 1-min one-sun light soaking at room temperature effectively restores cell performance, suggesting that field operation effectively mitigates such degradation. Under repeated 450 °C rapid thermal annealing and LAF cycles, initial FF and PCE losses (∼21.6 % and ∼6.7 % absolute, respectively) are attributed to contact deterioration, but performance is restored through subsequent LAF treatment. Based on these findings, a three-state defect model and contact degradation mechanisms are proposed. These findings provide new insights into the reliability of LAF TOPCon cells and highlight key considerations for industrial processing and module reliability testing. • ∼0.29% PCE loss after the lamination process, primarily caused by FF degradation and increased J 02 -like recombination. • Rapid recovery through 1-min one-sun light soaking at room temperature, suggesting self-healing during operation. • FF degradation after high-temperature RTA, due to contact instability, which can be restored through the LAF process. • The proposal of a three-state defect model explaining the activation and recovery dynamics of thermally induced defects. • Discussions of hydrogen-related defects, and possible contributions from metal impurities and interfacial changes.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · solar cell performance optimization · Advancements in Solid Oxide Fuel Cells
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (74)
Show source-provided references
1. Optimization of efficiency enhancement of TOPCon cells with boron selective emitter10.1016/j.solmat.2023.112585 ↗
2. High-performance boron emitters for tunnel oxide passivating contact solar cells enabled by multi-layer PECVD-deposited boron source structures10.1016/j.cej.2025.163487 ↗
3. B. Liao, S. Ma, R.J. Yeo, X. Wu, S. Zou, X. Su, W. Shen, G. Xing, B. Hoex, Novel Nano-Pyramid/Polish hybrid morphology designed for high-efficiency passivated contact solar cells, Prog. Photovoltaics Res. Appl. n/a (n.d.). https://doi.org/10.1002/pip.70002.10.1002/pip.70002 ↗
4. Fabrication of selective boron emitters for TOPCon solar cells using boron-doped amorphous silicon as diffusion source10.1016/j.solener.2025.113706 ↗
5. Enabling 95 % bifaciality of efficient TOPCon solar cells by rear-side selective sunken pyramid structure and zebra-crossing passivation contact10.1016/j.solmat.2025.113809 ↗
6. Solar cell efficiency tables (Version 66)10.1002/pip.3919 ↗
7. Impact of laser-enhanced contact optimization on n-TOPCon solar cells' performance and efficiency: experimental and simulated insights10.1016/j.solmat.2025.113526 ↗
8. Mechanisms and strategies for laser-enhanced contact optimization in tunnel oxide passivating contact solar cells with ultra-high sheet resistance emitters10.1016/j.cej.2025.162979 ↗
9. Understanding current paths and temperature distributions during ‘Laser Enhanced Contact Optimization’ (LECO)
10. Laser-enhanced contact optimization on iTOPCon solar cells10.1002/pip.3598 ↗
11. Mette · Sol. Energy Mater. Sol. Cell. · 2024 · 27710.1016/j.solmat.2024.113110 ↗
12. Higher-efficiency TOPCon solar cells in mass production enabled by laser-assisted firing: advanced loss analysis and near-term efficiency potential10.1002/pip.3921 ↗
13. Investigation of the Ag–Si contact characteristics of boron emitters for n-Tunnel oxide-passivated contact solar cells metallized by laser-assisted current injection treatment10.1002/solr.202400268 ↗
14. Nano-size Joule-heating to achieve low-ohmic Ag–Si contact on boron emitters of n-TOPCon solar cells
15. Microscale contact formation by laser enhanced contact optimization10.1109/JPHOTOV.2021.3129362 ↗
16. Microstructure analysis of current-fired contacts on TOPCon layers10.1002/solr.202500197 ↗
17. Efficiency improvement and microstructural working principle of LECO on the n-TOPCon rear side of industrial-like TOPCon solar cells10.1016/j.solmat.2025.113795 ↗
18. Investigation on effects of the laser-enhanced contact optimization process with Ag paste in a boron emitter for n-TOPCon solar cell10.1002/pip.3854 ↗
19. Is TOPCon ready for EVA? Insights from damp heat testing of glass-backsheet modules10.1016/j.solmat.2025.113650 ↗
20. Enhancing the reliability of TOPCon technology by laser-enhanced contact firing10.1016/j.solmat.2024.112846 ↗
21. Influence of laser induced sintering on contact performance of TOPCon solar cells10.7498/aps.73.20241372 ↗
22. A failure mode affecting the reliability of LECO-treated high-efficiency TOPCon solar cells10.1002/solr.202500151 ↗
23. NIH image to ImageJ: 25 years of image analysis10.1038/nmeth.2089 ↗
24. Double-diode model carrier lifetime-based internal recombination parameter analysis and efficiency prediction of crystalline Si solar cells10.1016/j.solener.2024.112697 ↗
25. Hydrogen-induced degradation: explaining the mechanism behind light- and elevated temperature-induced degradation in n- and p-type silicon10.1016/j.solmat.2019.110353 ↗
26. On the impact of dark annealing and room temperature illumination on p-type multicrystalline silicon wafers10.1016/j.solmat.2018.09.018 ↗
27. Degradation and recovery of n-Type multi-crystalline silicon under illuminated and dark annealing conditions at moderate temperatures10.1109/JPHOTOV.2018.2885711 ↗
28. Edge recombination analysis of silicon solar cells using photoluminescence measurements
29. Quantifying edge and peripheral recombination losses in industrial silicon solar cells10.1109/TED.2015.2480089 ↗
30. Analysis of edge losses on silicon heterojunction half solar cells10.1016/j.solmat.2019.110213 ↗
31. Modeling edge recombination in silicon solar cells10.1109/JPHOTOV.2017.2787020 ↗
32. Analysis of variation in recombination characteristics due to light and heat in industrial silicon solar cells10.1016/j.solener.2023.01.053 ↗
33. Reduced fill factors in multicrystalline silicon solar cells due to injection-level dependent bulk recombination lifetimes10.1002/1099-159X(200007/08)8:4<363::AID-PIP328>3.0.CO;2-Y ↗
34. Impact of the injection-level-dependent lifetime on Voc, FF, ideality m, J02, and the dim light response in a commercial PERC cell10.1002/pip.2792 ↗
35. High-efficiency silicon solar cells: full factor limitations and non-ideal diode behaviour due to voltage-dependent rear surface recombination velocity10.1002/pip.4670010204 ↗
36. The theory of p-n junctions in semiconductors and p-n junction transistors10.1002/j.1538-7305.1949.tb03645.x ↗
37. Fast separation of front and bulk defects via photoluminescence on silicon solar cells10.1016/j.solmat.2014.05.029 ↗
38. Investigation of potential-induced degradation in n-PERT bifacial silicon Photovoltaic modules with a Glass/Glass structure10.1109/JPHOTOV.2017.2762587 ↗
39. Assessing the impact of thermal profiles on the elimination of Light- and elevated-temperature-induced degradation10.1109/JPHOTOV.2018.2874769 ↗
40. The role of dark annealing in light and elevated temperature induced degradation in p-Type Mono-Like silicon10.1109/JPHOTOV.2020.2993653 ↗
41. Kinetics of light and elevated temperature-induced degradation in cast mono p-type silicon10.1016/j.solener.2021.06.054 ↗
42. Low-temperature dark anneal as pre-treatment for LeTID in multicrystalline silicon10.1016/j.solmat.2018.12.021 ↗
43. A four-state kinetic model for the carrier-induced degradation in multicrystalline silicon: introducing the reservoir state10.1016/j.solmat.2018.04.024 ↗
44. UVID of TOPCon solar cells: effect of the front passivation Al2O3 layer thickness and recovery by different processes10.1016/j.solmat.2025.113691 ↗
45. UV-Induced degradation of industrial PERC, TOPCon, and HJT solar cells: the next big reliability challenge?10.1002/solr.202400628 ↗
46. Gebhardt
47. A 3-state defect model for light-induced degradation in boron-doped float-zone silicon10.1002/pssr.201600408 ↗
48. Fast regeneration processes to avoid light-induced degradation in multicrystalline silicon solar cells10.1109/JPHOTOV.2016.2598273 ↗
49. Deciphering the role of hydrogen in the degradation of silicon solar cells under light and elevated temperature10.1002/solr.202400457 ↗
50. Evidence of an identical firing-activated carrier-induced defect in monocrystalline and multicrystalline silicon10.1016/j.solmat.2017.08.003 ↗
51. Hydrogen induced degradation: a possible mechanism for light- and elevated temperature- induced degradation in n-type silicon10.1016/j.solmat.2018.05.034 ↗
52. Modulation of carrier-induced defect kinetics in multi-crystalline silicon PERC cells through Dark Annealing10.1002/solr.201600028 ↗
53. Enhancing UV light stability in commercial silicon HJT solar cells and modules10.1016/j.solener.2025.113735 ↗
54. Unveiling the mechanism of ultraviolet-induced degradation in silicon heterojunction solar cells10.1016/j.solmat.2024.113062 ↗
55. Powerful recombination centers resulting from reactions of hydrogen with carbon–oxygen defects in n-type Czochralski-grown silicon
56. Theory of a carbon-oxygen-hydrogen recombination center in n-type Si
57. Correlated annealing and formation of vacancy-hydrogen related complexes in silicon10.1088/1361-648X/ab0bf2 ↗
58. Interaction between hydrogen and vacancy defects in crystalline Silicon
59. Degradation of surface passivation and bulk in p-Type monocrystalline silicon wafers at elevated temperature10.1109/JPHOTOV.2018.2878791 ↗
60. Hydrogen-Induced degradation
61. Hydrogen-induced platelets in disordered silicon10.1016/0038-1098(96)00283-9 ↗
62. Observations of contact resistance in TOPCon and PERC solar cells10.1016/j.solmat.2022.111934 ↗
63. Hydrogen induced contact resistance in PERC solar cells10.1016/j.solmat.2018.04.036 ↗
64. Instability of increased contact resistance in silicon solar cells following post-firing thermal processes10.1002/solr.201700129 ↗
65. New measurement method for the investigation of space charge region recombination losses induced by the metallization of silicon solar cells10.1016/j.egypro.2011.06.203 ↗
66. Impact of screen printing silver paste components on the space charge region recombination losses of industrial silicon solar cells10.1016/j.solmat.2012.06.040 ↗
67. Lifetime degradation and regeneration in multicrystalline silicon under illumination at elevated temperature10.1063/1.4944839 ↗
68. Progress in the understanding of light- and elevated temperature-induced degradation in silicon solar cells: a review10.1002/pip.3362 ↗
69. Current transport in thick film Ag metallization: direct contacts at Silicon pyramid tips?10.1016/j.egypro.2011.06.179 ↗
70. High-Efficiency Crystalline-Si solar cells with screen-printed front-side metallization: a percolation model to explainthe Current path10.1007/s11664-016-4818-5 ↗
71. Thermal properties of glass frit and effects on Si solar cells10.1016/j.matchemphys.2008.09.011 ↗
72. Impact of extended contact cofiring on multicrystalline silicon solar cell parameters10.1109/JPHOTOV.2016.2621342 ↗
73. The Ag-Si (Silver-Silicon) system10.1007/BF02877631 ↗
74. Thermodynamic modelling of Ag–Si nanophase diagram including shape effect10.1007/s11051-024-06080-6 ↗