journal article·2024-08Open access

Influence of boron doping profile on emitter and metal contact recombination for n-PERT silicon solar cells

Gence Bektaş, Sercan Aslan, Ahmet Emin Keçeci, Vahdet Özyahni, Hasan Hüseyin Canar, Hasan Asav, Selin Seyrek, Pierre J. Verlinden, Raşit Turan

Abstract

Increasing interest in n-type silicon (Si) solar cells due to the high-quality material properties of the n-Si wafers, their relatively low sensitivity to donor-like impurities like iron and their resistance to light-induced degradation brings more recent attention to the studies on the p + emitter and its metal contact. In this work, we investigate the effect of the Boron doping profile on the quality of p + emitter and their contacts with screen-printed Ag/Al metal fingers. The emitters within the scope of this study are created with BBr 3 diffusion in an atmospheric diffusion furnace on n-type Si wafers and also applied to n-PERT Si cells to analyze their effects on device performance. Our results highlight the significance of the doping profile for solar cell performance, as it considerably affects the contact resistivity at the emitter-metal interface and the saturation current densities for emitter (J 0, emitter) and Ag/Al metal contacts (J 0, AgAl ). Reducing the Boron concentration within the emitter leads to a decrease in carrier recombination in the non-contacted region of the emitter, which in turn decreases J 0, emitter. However, this reduction increases the recombination in the contacted areas of the emitter, consequently elevating the J 0, AgAl, and increasing the contact resistance values. Besides, the power loss analysis and simulation results based on experimental values obtained for our best solar cells group show how much J 0, emitter and J 0, AgAl values contribute to and would improve solar cell efficiency. The manuscript presents a case study of experimental emitter doping profile optimization applicable to similar n-type PERT or TOPCon cells with varying design parameters.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Photovoltaic System Optimization Techniques · solar cell performance optimization

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (44)

Show source-provided references
1. Review of light-induced degradation in crystalline silicon solar cells10.1016/j.solmat.2015.11.047 ↗
2. Optimization of boron diffusion for screen printed n-PERT solar cells10.1016/j.egypro.2016.07.129 ↗
3. A comparative study on alternative industrial manufacturing routes for bifacial n-PERT silicon solar cells10.1002/pip.3706 ↗
4. Comparison of electrical performances of fully ion implanted n-PERT solar cells made of different n-type wafer feedstocks
5. Bektaş · 2022
6. Co-diffusion from APCVD BSG and POCl 3 for industrial n-type solar cells10.1016/j.egypro.2013.07.282 ↗
7. 21.0%-efficient screen-printed n-PERT back-junction silicon solar cell with plasma-deposited boron diffusion source10.1016/j.solmat.2016.05.054 ↗
8. Formation of emitter by boron spin-on doping from SiO2 nanosphere and properties of the related n-PERT solar cells10.1016/j.solener.2021.07.033 ↗
9. Chemical passivation of crystalline Si by Al2O3Deposited using atomic layer deposition: implications for solar cells10.1021/acsanm.1c00448 ↗
10. A comparison study of boron emitter passivation by silicon oxide and a PECVD silicon nitride stack10.1016/j.egypro.2017.09.301 ↗
11. PECVD-AlOx/SiNx passivation stacks on silicon: effective charge dynamics and interface defect state spectroscopy10.1016/j.egypro.2014.08.068 ↗
12. Electrical and Chemical studies on Al2O3 passivation activation process
13. On the passivation performance of SiNx, SiOxNy and their stack on c-Si wafers for solar cell applications: correlation with optical, chemical and interface properties
14. The effect of SiNx: H stoichiometry on electrical and chemical passivation of Al2O3/SiNx: H stack layer on p-type silicon wafers10.1063/5.0140213 ↗
15. Thin Al2O3 passivated boron emitter of n-type bifacial c-Si solar cells with industrial process10.1002/pip.2859 ↗
16. Metallization of n-type silicon solar cells using fine line printing techniques10.1016/j.egypro.2011.06.184 ↗
17. Towards understanding the characteristics of Ag-Al spiking on boron-doped silicon for solar cells10.1016/j.solmat.2015.11.032 ↗
18. N-type single-crystalline Si solar cells: front side metallization for solar cells reaching 20% efficiency10.1016/j.solmat.2016.05.027 ↗
19. King · 1990
20. Doped surfaces in one sun, point-contact solar cells10.1063/1.101345 ↗
21. Studies of diffused phosphorus emitters: saturation current, surface recombination velocity, and quantum efficiency10.1109/16.46368 ↗
22. Studies of diffused boron emitters: saturation current, bandgap narrowing, and surface recombination velocity10.1109/16.81632 ↗
23. High-low junctions for solar cell applications10.1016/0038-1101(81)90072-1 ↗
24. Simplified process flow for the fabrication of PERC solar cells with ion implanted emitter10.1016/j.renene.2021.08.054 ↗
25. Optimization of front and rear surface dielectric passivation layers for ion implanted PERC solar cells10.1063/5.0140410 ↗
26. Impact of ion implantation and annealing parameters on bifacial perc and pert solar cell performance
27. Canar · 2022
28. Effect of implanted phosphorus profile on iVoc variations during firing process of n-type silicon
29. 2006
30. Measurement of the emitter saturation current by a contactless photoconductivity decay method
31. The recombination parameter J010.1016/j.egypro.2014.08.073 ↗
32. Role of firing temperature, sheet resistance, and contact area in contact formation on screen-printed metal contact of silicon solar cell10.1007/s11664-017-6022-7 ↗
33. Recombination at metal-emitter interfaces of front contact technologies for highly efficient silicon solar cells10.1016/j.egypro.2011.06.111 ↗
34. Injection dependent emtitter saturation current density measurement under metallized areas using photoconductance decay
35. Improvments in silicon solar cell performance
36. The concept of skins for silicon solar cell modeling10.1016/j.solmat.2017.05.012 ↗
37. A free and fast three-dimensional/two-dimensional solar cell simulator featuring conductive boundary and quasi-neutrality approximations10.1109/TED.2012.2231415 ↗
38. Characterization of metallization-induced recombination losses of screen-printed silicon solar cells
39. Optimization of phosphorus implant dose and activation temperature for emitter formation of p-type silicon solar cells
40. Effect of doping profile on contact resistivty between screen printed Ag/Al and implanted boron emitter
41. Towards 24% efficiency for industrial N-type bifacial passivating-contact solar cells with homogeneous emitter
42. Ghasemikashtiban · 2023
43. Seyrek · 2023
44. Understanding metal induced recombination losses in silicon solar cells with screen printed silver contacts10.1016/j.egypro.2016.10.077 ↗