Theoretical analysis of backside polycrystalline silicon layer in the TOPCon solar cells
Source abstract
Abstract
As an upgraded version of passivated emitter and rear cell (PERC) solar cells, the performance of tunnel oxide passivating contacts (TOPCon) solar cells is very dependent on the silicon oxide layer and poly-Si layer. We found that different crystallization rates or doping of germanium, carbon and other elements in poly-Si can change the band gap of poly-Si, which has an impact on the efficiency ( E ff ) of TOPCon solar cells. Therefore, the appropriate band gap is particularly important. At the same time, the internal defect of poly-Si also have great influence on the performance of solar cells. The simulated band diagram, charge carrier concentration and recombination rate were used to deeply explore the defect in poly-Si and the influence of poly-Si with different band gap on the performance of TOPCon solar cells.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Semiconductor materials and interfaces · Integrated Circuits and Semiconductor Failure Analysis
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (31)
Show source-provided references
1. Dielectric surface passivation for silicon solar cells: a review
2. Glunz · 2013
3. Tunnel oxide passivated rear contact for large area n-type front junction silicon solar cells providing excellent carrier selectivity10.3934/matersci.2016.1.180 ↗
4. Frigge · 2016
5. n-Type Si solar cells with passivating electron contact: identifying sources for efficiency limitations by wafer thickness and resistivity variation10.1016/j.solmat.2017.05.042 ↗
6. 25.11% efficiency silicon heterojunction solar cell with low deposition rate intrinsic amorphous silicon buffer layers10.1016/j.solmat.2020.110643 ↗
7. Influence of unintentional H2O introduction in sputtering chamber on ITO films and HJT solar cells10.1016/j.solmat.2023.112274 ↗
8. Light-induced activation of boron doping in hydrogenated amorphous silicon for over 25% efficiency silicon solar cells10.1038/s41560-022-01018-5 ↗
9. Flexible solar cells based on foldable silicon wafers with blunted edges10.1038/s41586-023-05921-z ↗
10. Tunnel oxide passivated contacts as an alternative to partial rear contacts10.1016/j.solmat.2014.06.015 ↗
11. Influence of SiOx film thickness on electrical performance and efficiency of TOPCon solar cells10.1016/j.solmat.2020.110423 ↗
12. Excellent surface passivation of p-type TOPCon enabled by ozone-gas oxidation with a single-sided saturation current density of ∼ 4.5 fA/cm210.1016/j.solener.2023.05.028 ↗
13. Influence of backside surface morphology on passivation and contact characteristics of TOPCON solar cells10.1016/j.solener.2023.04.065 ↗
14. 24.18% efficiency TOPCon solar cells enabled by super hydrophilic carbon-doped polysilicon films combined with plated metal fingers10.1016/j.solmat.2023.112393 ↗
15. Interdigitated back-contacted silicon heterojunction solar cells with improved fill-factor and efficiency
16. Efficient carrier-selective p- and n-contacts for Si solar cells10.1016/j.solmat.2014.05.039 ↗
17. Polysilicon passivating contacts for silicon solar cells: interface passivation and carrier transport mechanism10.1021/acsaem.8b02149 ↗
18. Simulation of silicon solar cells with passivation contact of tunnel oxide layer10.3103/S1068375521050045 ↗
19. Characterization of trap states distribution in poly-Si TFTs using OEMS
20. Electrical properties of solid-phase crystallized polycrystalline silicon films10.1007/s00339-002-1513-6 ↗
21. Defect absorption and optical transitions in hydrogenated amorphous silicon10.1016/j.ssc.2010.06.034 ↗
22. Analysis of negative bias temperature instability in body-tied low-temperature polycrystalline silicon thin-film transistors10.1109/LED.2007.914083 ↗
23. Numerical simulation of transient emission from deep level traps in polysilicon thin film transistors
24. Characterization of the polysilicon thin film transistors elaborated in high and low temperature processes. Study of the density of traps10.1016/S0379-6779(98)80004-0 ↗
25. A new charge pumping model considering bulk trap states in polysilicon thin film transistor10.1016/S0038-1101(98)00156-7 ↗
26. Density of gap states of silicon grain boundaries determined by optical absorption10.1063/1.94278 ↗
27. Hydrogen diffusion in polycrystalline silicon thin films10.1063/1.108446 ↗
28. Determination of interface and bulk traps in the subthreshold region of polycrystalline silicon thin-film transistors10.1109/TED.2003.815372 ↗
29. Determination of bulk states and interface states distributions in polycrystalline silicon thin‐film transistors10.1063/1.354648 ↗
30. Effects of various hydrogenation processes on bias-stress-induced degradation in p-channel polysilicon thin film transistors10.1143/JJAP.41.5048 ↗
31. Quasi-Fermi level variation in the space-charge region of a grain boundary10.1088/0022-3727/18/4/011 ↗