journal article·2012-12

Microanalysis of post-deposition annealing of Cu(In,Ga)Se2 solar cells

Jörn Timo Wätjen, Uwe Zimmermann, Marika Edoff

Publisher page

Abstract

The sun provides us with a surplus of energy convertible to electricity using solar cells. This thesis focuses on solar cells based on chalcopyrite (CIGSe) as well as kesterite (CZTS(e)) absorber layers. These materials yield record efficiencies of 20.4 % and 11.1 %, respectively. Especially for CZTS(e), the absorber layers often do not consist of one single desired phase but can exhibit areas with deviating material properties, referred to as secondary phases. Furthermore, several material layers are required for a working solar cell, each exhibiting interfaces. Even though secondary phases and interfaces represent a very small fraction of the solar cell they can have a profound influence on the over-all electrical solar cell characteristics. As such, it is crucial to understand how secondary phases and interfaces influence the local electrical characteristics.Characterising secondary phases and interfaces is challenging due to their small sample volume and relatively small differences in composition amongst others. This is where electronmicroscopy, especially transmission electron microscopy, offers valuable insight to material properties on the microscopic scale. The main challenge is, however, to link these material properties to the corresponding electrical characteristics of a solar cell.This thesis uses electron beam induced current imaging and introduces a new method for JV characterisation of solar cells on the micron scale. Combining microscopic structural and electrical characterisation techniques allowed identifying and characterising local defects found in the absorber layer of CIGS solar cells after thermal treatment. Furthermore, CZTSe solar cells in this thesis exhibited a low photo-current density which is traced to the formation of a current blocking ZnSe secondary phase at the front contact interface. The electron microscopy work has contributed to an understanding of the chemical stability of CZTS and has shown the need for an optimised back contact interface in order to avoid chemical decomposition reactions and formation of detrimental secondary phases. With this additional knowledge, a comprehensive picture of the material properties from the macroscopic down to the microscopic level can be attained throughout all required material layers.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (19)

Show source-provided references
1. Band-gap engineering in Cu(In,Ga)Se2 thin films grown from (In,Ga)2Se3 precursors10.1016/0927-0248(95)00122-0 ↗
2. Back surface band gap gradings in Cu(In,Ga)Se2 solar cells10.1016/S0040-6090(00)01726-0 ↗
3. Study of the effect of gallium grading in Cu(In,Ga)Se210.1016/S0040-6090(99)00845-7 ↗
4. Diffusion of indium and gallium in Cu(In,Ga)Se2 thin film solar cells10.1016/S0022-3697(03)00127-6 ↗
5. S.M. Schleussner, T. Törndahl, M. Linnarsson, U. Zimmermann, T. Wätjen, M. Edoff, Development of gallium gradients in three-stage Cu(In,Ga)Se2 co-evaporation processes, Progress in Photovoltaics: Research and Applications 20 (3) (2012) 284–293. 10.1002/pip.1134.10.1002/pip.1134 ↗
6. 19.9%-efficient ZnO/CdS/CuInGaSe2 solar cell with 81.2% fill factor10.1002/pip.822 ↗
7. Highly efficient CIS solar cells and modules made by the co-evaporation process10.1016/j.tsf.2008.10.126 ↗
8. P. Jackson, D. Hariskos, E. Lotter, S. Paetel, R. Wuerz, R. Menner, W. Wischmann, M. Powalla, New world record efficiency for Cu(In,Ga)Se2 thin-film solar cells beyond 20%, Progress in Photovoltaics: Research and Applications 19 (7) (2011) 894–897. 10.1002/pip.1078.10.1002/pip.1078 ↗
9. Increased homogeneity and open-circuit voltage of Cu(In,Ga)Se2 solar cells due to higher deposition temperature10.1016/j.solmat.2010.10.021 ↗
10. H. Miyazaki, R. Mikami, A. Yamada, M. Konagai, Cu(In,Ga)Se2 thin film absorber with high Ga contents and its application to the solar cells , Journal of Physics and Chemistry of Solids 64 (2003) 2055–2058. 10.1016/S0022-3697(03)00204-X10.1016/S0022-3697(03)00204-X ↗
11. A multi-diode model for spatially inhomogeneous solar cells10.1016/j.tsf.2005.01.027 ↗
12. 2D device modelling and finite element simulations for thin-film solar cells10.1016/j.solmat.2008.11.058 ↗
13. P.O. Grabitz, U. Rau, B. Wille, G. Bilger, J.H. Werner, Spatial inhomogeneities in Cu(In,Ga)Se2 solar cells analyzed by electron beam induced voltage measurements, in: Conference Record of the 2006 IEEE Fourth World Conference on Photovoltaic Energy Conversion, vol. 1, 2006, pp. 424–427. 10.1109/WCPEC.2006.279480.10.1109/WCPEC.2006.279480 ↗
14. M. Paire, L. Lombez, N. Pere-Laperne, S. Collin, J.-L. Pelouard, D. Lincot, J.-F. Guillemoles, Microscale solar cells for high concentration on polycrystalline Cu(In,Ga)Se2 thin films, Applied Physics Letters 98 (26) (2011) 264102-1-264102-3. 10.1063/1.3604789.10.1063/1.3604789 ↗
15. M. Edoff, S. Woldegiorgis, P. Neretnieks, M. Ruth, J. Kessler, L. Stolt, CIGS submodules with high performance and high manufacturability, in: Proceedings of the 19th European Photovoltaic Energy Conference and Exhibition, Paris, 2004, pp. 1690–1693.
16. Thin-film solar cells: device measurements and analysis10.1002/pip.518 ↗
17. FIB lift-out specimen preparation techniques
18. Effect of gallium grading in Cu(In,Ga)Se2 solar-cell absorbers produced by multi-stage coevaporation10.1016/j.solmat.2010.10.011 ↗
19. Phases, morphology, and diffusion in CuInxGa1-xSe2 thin films10.1063/1.366122 ↗