Poly-Si thickness and temperature dependent oxide disruption induced by penetration of the interfacial oxide in (p) poly-Si/SiOx passivating contacts
Source abstract
Abstract
Passivating contacts based on polycrystalline silicon on an interfacial oxide (poly-Si/SiO x ) require a fine-tuned in-diffused dopant profile at the surface of the crystalline silicon wafer. In particular, a strong dopant in-diffusion causes excessive recombination. This study contributes to reveal the yet unclear mechanism of this degradation of passivation. Boron in-diffusion from co-sputtered (p) poly-Si layers through the interfacial oxide is investigated for several layer thicknesses and plateau temperatures during the solid phase crystallization. It is shown that for higher temperatures and unexpectedly also for thicker layers the observed recombination current density increases up to a total loss of passivation, accompanied by a physical interfacial oxide disruption, which is not observed for intrinsic reference layers. This behavior is supported by simple numerical calculations. The recombination current densities are transferred into the actual surface recombination velocity which in turn reveals an exponential increase towards higher boron concentrations at the interface between the oxide and the crystalline Si base. It is concluded that rather dopant penetration of the interfacial oxide is responsible for the degradation of passivation than the actual boron concentration at the interface itself as reported before in literature.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Integrated Circuits and Semiconductor Failure Analysis · Semiconductor materials and interfaces
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (40)
Show source-provided references
1. Surface passivation of crystalline silicon solar cells: present and future10.1016/j.solmat.2018.06.047 ↗
2. Passivating contacts for crystalline silicon solar cells10.1038/s41560-019-0463-6 ↗
3. Passivating contacts and tandem concepts: approaches for the highest silicon-based solar cell efficiencies10.1063/1.5139202 ↗
4. Polysilicon passivated junctions: the next technology for silicon solar cells?10.1016/j.joule.2021.02.013 ↗
5. The application of poly-Si/SiOx contacts as passivated top/rear contacts in Si solar cells10.1016/j.solmat.2016.09.015 ↗
6. Polycrystalline silicon passivated tunneling contacts for high efficiency silicon solar cells10.1557/jmr.2016.77 ↗
7. Polysilicon emitters for bipolar transistors: a review and re-evaluation of theory and experiment10.1109/16.141239 ↗
8. Studying dopant diffusion from poly-Si passivating contacts10.1016/j.solmat.2019.109978 ↗
9. Ion implantation for poly-Si passivated back-junction back-contacted solar cells10.1109/JPHOTOV.2014.2382975 ↗
10. Physics, technology, and modeling of polysilicon emitter contacts for VLSI bipolar transistors10.1109/T-ED.1986.22738 ↗
11. Diffusion of boron, phosphorus, arsenic, and antimony in thermally grown silicon dioxide10.1149/1.1391859 ↗
12. Passivated rear contacts for high-efficiency n-type Si solar cells providing high interface passivation quality and excellent transport characteristics10.1016/j.solmat.2013.09.017 ↗
13. Bias temperature instability in scaled p polysilicon gate p-MOSFET’s10.1109/16.760398 ↗
14. Working principle of carrier selective poly-Si/c-Si junctions: is tunnelling the whole story?10.1016/j.solmat.2016.05.045 ↗
15. An investigation of the thermal stability of the interfacial oxide in polycrystalline silicon emitter bipolar transistors by comparing device results with high‐resolution electron microscopy observations10.1063/1.338861 ↗
16. Early stage evolution kinetics of the polysilicon/single‐crystal silicon interfacial oxide upon annealing10.1063/1.347346 ↗
17. Role of polysilicon in poly-Si/SiOx passivating contacts for high-efficiency silicon solar cells10.1039/C9RA03560E ↗
18. Progress with passivation and screen-printed metallization of boron-doped monoPolyTM layers10.1016/j.solener.2021.11.015 ↗
19. Conductivity and surface passivation properties of boron‐doped poly‐silicon passivated contacts for c‐Si solar cells10.1002/pssa.201800603 ↗
20. Influence of the carbon concentration on (p) poly-SiCx layer properties with focus on parasitic absorption in front side poly-SiCx/SiOx passivating contacts of solar cells10.1109/JPHOTOV.2020.3023506 ↗
21. Steffens · 2020
22. 23% efficient p-type crystalline silicon solar cells with hole-selective passivating contacts based on physical vapor deposition of doped silicon films10.1063/1.5037610 ↗
23. Introducing pinhole magnification by selective etching: application to poly-Si on ultra-thin silicon oxide films10.1016/j.egypro.2017.09.270 ↗
24. Carrier-diffusion corrected J0-analysis of charge carrier lifetime measurements for increased consistency10.1016/j.solmat.2015.06.043 ↗
25. Interlaboratory study of eddy-current measurement of excess-carrier recombination lifetime10.1109/JPHOTOV.2013.2284375 ↗
26. A freeware 1D emitter model for silicon solar cells
27. Steady-state solubility of substitutional impurities in silicon10.1002/pssa.2211010113 ↗
28. Study of lifetime degradation in n-type silicon due to oxidation of boron-rich layer
29. Surface passivation of boron-diffused junctions by a borosilicate glass and in situ grown silicon dioxide interface layer10.1109/JPHOTOV.2018.2792422 ↗
30. Towards a fast determination of the hydrogen concentration in thin passivating a-Si:H layers using GD-OES
31. Influence of the transparent electrode sputtering process on the interface passivation quality of silicon heterojunction solar cells
32. Degradation of hydrogenated amorphous silicon passivation films caused by sputtering deposition10.1002/pssa.201431923 ↗
33. Compensation of the sputter damage during a-Si deposition for poly-Si/SiOx passivating contacts by ex-situ P-doping
34. Effects of iron contamination in silicon on thin oxide breakdown and reliability characteristics10.1016/0022-3093(95)00125-5 ↗
35. Crystallization‐induced stress in silicon thin films10.1063/1.106864 ↗
36. Crystallization‐induced stress in phosphorus‐doped amorphous silicon thin films10.1063/1.355932 ↗
37. Analytical model for the diode saturation current of point-contacted solar cells10.1002/pip.637 ↗
38. Dopant ionisation calculator with default settings
39. Models for numerical device simulations of crystalline silicon solar cells—a review10.1007/s10825-011-0367-6 ↗
40. Effect of boron concentration on recombination at the p-Si-Al2O3 interface10.1063/1.4867643 ↗