journal article·2012-01Open access

Influence of Raman crystallinity on the performance of micromorph thin film silicon solar cells

Ch. Ellert, C. Wachtendorf, A. Hedler, M. Klindworth, M. Martinek

Abstract

Abstract The performance of micromorph silicon tandem solar cells deposited by plasma enhanced chemical vapor deposition (PECVD) at 40 MHz was investigated in a large area industrially employed reactor as a function of the crystalline fraction of the microcrystalline bottom cell. The relevant plasma parameters frequency, pressure, hydrogen and silane mixture, temperature were kept constant. The RF-power for the deposition of the bottom cell was varied in order to scan its Raman crystalline fraction over the transition region from amorphous into highly crystalline. Assuming constant amorphous or microcrystalline material quality (in terms of stability and defect density) the optimum value of the Raman crystalline fraction and especially the width of the optimum range was thus determined quantitatively. It is shown that the optimum Raman crystalline fraction of the bottom cell on substrates with front contact and amorphous top cell is 52 % ± 10 % . A clear decrease of short circuit current density is observed for too high crystalline fraction.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Thin-Film Transistor Technologies · Silicon and Solar Cell Technologies · Silicon Nanostructures and Photoluminescence

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (14)

Show source-provided references
1. J. Meier, S. Dubail, R. Flückiger, D. Fischer, H. Keppner, A. Shah, Intrinsic microcrystalline silicon (μc-Si:H) - a promising new thin film solar cell material, in: Proceedings of the First WCPEC, vol. 1, Hawaii, USA, 1994, pp. 409–412.10.1109/WCPEC.1994.519985 ↗
2. Intrinsic microcrystalline silicon: a new material for photovoltaics10.1016/S0927-0248(99)00140-3 ↗
3. Microcrystalline materials and cells deposited by RF glow discharge10.1016/S0927-0248(02)00451-8 ↗
4. Relationship between Raman crystallinity and open-circuit voltage in microcrystalline silicon solar cells10.1016/j.solmat.2003.07.004 ↗
5. Microcrystalline silicon films and solar cells deposited by PECVD and HWCVD10.1016/j.solener.2004.08.029 ↗
6. Open circuit voltage improvement of high-deposition-rate microcrystalline silicon solar cells by hot wire interface layers10.1063/1.2011771 ↗
7. Deposition of microcrystalline silicon prepared by hot-wire chemical-vapor deposition: the influence of the deposition parameters on the material properties and solar cell performance10.1063/1.1957128 ↗
8. Stability of microcrystalline silicon solar cells with HWCVD buffer layer10.1016/j.tsf.2007.06.201 ↗
9. Relationship between microstructure and photovoltaic performance in microcrystalline silicon film solar cells fabricated by a high-density microwave plasma10.1016/S0040-6090(02)01176-8 ↗
10. Influence of the substrate's surface morphology and chemical nature on the nucleation and growth of microcrystalline silicon10.1016/j.tsf.2005.03.017 ↗
11. C. Droz, Thin Film Microcrystalline Silicon Layers and Solar Cells: Microstructure and Electrical Performances, PhD Thesis, University of Neuchatel, IMT, 2003.
12. Influence of the substrate geometrical parameters on microcrystalline silicon growth for thin-film solar cells10.1016/j.solmat.2009.05.025 ↗
13. Relation between substrate surface morphology and microcrystalline silicon solar cell performance10.1016/j.jnoncrysol.2007.09.084 ↗
14. Microcrystalline silicon deposition: process stability and process control10.1016/j.tsf.2006.11.119 ↗