Can interface charge enhance selectivity in tunnel layer passivated contacts? Using negatively charged aluminium oxide capped with dopant free PEDOT or boron doped polysilicon
Source abstract
Abstract
Abstract Tunnel layer passivated contacts are widely used for selective extraction of electrons or holes in silicon solar cells. We investigate if a tunnel layer with high negative interface charge can further enhance the hole extraction ability (selectivity) of a passivated contact and thus the efficiency of silicon solar cells. High negative-charged, atomic layer deposited AlOx dielectric tunnel layers, capped with either conventional boron doped polysilicon (p+-poly-Si) or low-temperature, dopant-free poly (3,4-ethylenedioxythiophene) polystyrene sulfonate (PEDOT:PSS), are investigated in order to form hole selective passivated contacts. Ultra-thin AlOx films in the tunnel regime (0.13–2 nm) are studied, measuring their passivation quality (τeff), fixed charge density (Qtot) and defect density (Dit) prior to capping, and contact recombination density (J0,contact) and effective contact resistivity (ρcontact) after capping with either PEDOT:PSS or p+-poly-Si. The measured J0,contact and ρcontact values are then used to calculate carrier selectivity and efficiency potential if rear-side integrated in a solar cell. Low temperature deposited PEDOT:PSS capped passivated contacts behave differently compared to high temperature deposited p+-poly-Si capped passivated contacts. Yes, negatively charged AlOx tunnel layers can enhance hole extraction capability/selectivity of a passivated contact. For PEDOT:PSS capped passivated contacts, the efficiency potential deploying optimized negatively charged AlOx tunnel layers (1.5 nm, annealed at 425 °C) was measured to be 1.1% higher than conventional reference-moderately charged SiOx tunnel layer (26% as compared to 24.9%). However, this is not observed for p+-poly-Si capped passivated contacts due to boron in-diffusion and associated charge compensation mechanism, a consequence of the high-temperature diffusion process.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Integrated Circuits and Semiconductor Failure Analysis · Semiconductor materials and interfaces
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (52)
Show source-provided references
1. Tunnel oxide passivated carrier-selective contacts based on ultra-thin SiO2 layers10.1016/j.solmat.2015.06.048 ↗
2. n-Type Si solar cells with passivating electron contact: identifying sources for efficiency limitations by wafer thickness and resistivity variation10.1016/j.solmat.2017.05.042 ↗
3. Tunnel oxide passivating electron contacts as full-area rear emitter of high-efficiency p-type silicon solar cells10.1002/pip.2960 ↗
4. Laser contact openings for local poly-Si-metal contacts enabling 26.1%-efficient POLO-IBC solar cells10.1016/j.solmat.2018.06.020 ↗
5. Charge carrier transport mechanisms of passivating contacts studied by temperature-dependent J-V measurements10.1016/j.solmat.2018.01.008 ↗
6. 24.58% total area efficiency of screen-printed, large area industrial silicon solar cells with the tunnel oxide passivated contacts (i-TOPCon) design10.1016/j.solmat.2019.110258 ↗
7. monoPoly™ cells: large-area crystalline silicon solar cells with fire-through screen printed contact to doped polysilicon surfaces10.1016/j.solmat.2018.05.059 ↗
8. Comparison and characterization of different tunnel layers, suitable for passivated contact formation10.7567/JJAP.56.08MA01 ↗
9. Improved silicon oxide/polysilicon passivated contacts for high efficiency solar cells via optimized tunnel layer annealing10.1016/j.solmat.2020.110720 ↗
10. Recombination behavior and contact resistance of n+ and p+ poly-crystalline Si/mono-crystalline Si junctions10.1016/j.solmat.2014.06.003 ↗
11. Phosphorus-diffused polysilicon contacts for solar cells10.1016/j.solmat.2015.06.001 ↗
12. Polycrystalline silicon passivated tunneling contacts for high efficiency silicon solar cells10.1557/jmr.2016.77 ↗
13. Simple cleaning and conditioning of silicon surfaces with UV/ozone sources10.1016/j.egypro.2014.08.067 ↗
14. Understanding surface treatment and ALD AlOx thickness induced surface passivation quality of c-Si cz wafers10.1109/JPHOTOV.2017.2717040 ↗
15. Ultra-thin atomic layer deposited aluminium oxide tunnel layer passivated hole-selective contacts for silicon solar cells10.1016/j.solmat.2018.11.011 ↗
16. Spatial atomic layer deposition of aluminum oxide as a passivating hole contact for silicon solar cells
17. Engineering aluminum oxide/polysilicon hole selective passivated contacts for high efficiency solar cells10.1016/j.solmat.2020.110758 ↗
18. Aluminum oxide passivating tunneling interlayers for molybdenum oxide hole-selective contacts10.1109/JPHOTOV.2020.2973447 ↗
19. Metal-oxide-based hole-selective tunneling contacts for crystalline silicon solar cells10.1016/j.solmat.2013.06.016 ↗
20. Ultra-thin ALD-AlOx/PEDOT:PSS hole selective passivated contacts: an attractive low cost approach to increase solar cell performance10.1016/j.solmat.2018.06.002 ↗
21. Optical and electrical characterization of poly-Si/SiOx contacts and their implications on solar cell design10.1016/j.egypro.2017.09.336 ↗
22. The application of poly-Si/SiOx contacts as passivated top/rear contacts in Si solar cells10.1016/j.solmat.2016.09.015 ↗
23. Improvement of the SiOx passivation layer for high-efficiency Si/PEDOT:PSS heterojunction solar cells10.1021/am503949g ↗
24. Organic-silicon solar cells exceeding 20% efficiency10.1016/j.egypro.2015.07.047 ↗
25. Interface engineering of ultra-thin ALD-AlOx/PEDOT:PSS carrier selective contact for high efficiency (> 22.5%) Si-solar cells
26. Electronic and chemical properties of the c-Si/Al2O3 interface10.1063/1.3587227 ↗
27. A quantitative measure for the carrier selectivity of contacts to solar cells
28. Contactless determination of current–voltage characteristics and minority‐carrier lifetimes in semiconductors from quasi‐steady‐state photoconductance data10.1063/1.117723 ↗
29. Measurement of the emitter saturation current by a contactless photoconductivity decay method
30. Suckow · 2014
31. Ultra-thin aluminium oxide tunnel layer passivated contact for high-efficiency crystalline silicon solar cells
32. Can interface charge enhance carrier selectivity in tunnel-layer/poly-Si passivated contacts?
33. Ultralow surface recombination of c-Si substrates passivated by plasma-assisted atomic layer deposited Al2O310.1063/1.2240736 ↗
34. Interface and material characterization of thin ALD-Al2O3 layers on crystalline silicon10.1016/j.egypro.2012.07.069 ↗
35. Chemical and structural study of electrically passivating Al2O3/Si interfaces prepared by atomic layer deposition10.1116/1.4704601 ↗
36. Electrochemical grafting passivation of silicon via electron transfer at polymer/silicon hybrid interface10.1016/j.electacta.2017.07.071 ↗
37. On the light-induced enhancement in photovoltaic performance of PEDOT:PSS/Si organic-inorganic hybrid solar cells10.1063/1.5003993 ↗
38. Scaling limitations of gate oxide in p/sup +/polysilicon gate MOS structures for sub-quarter micron CMOS devices
39. Bias temperature instability in scaled p/sup +/polysilicon gate p-MOSFET's10.1109/16.760398 ↗
40. Impact of boron penetration on gate oxide reliability and device lifetime in p+-poly PMOSFETs10.1016/S0167-9317(97)00071-8 ↗
41. Impact of boron penetration at P/sup +/-poly/gate oxide interface on deep-submicron device reliability for dual-gate CMOS technologies10.1109/55.568770 ↗
42. Ab initio study of boron segregation and deactivation at Si/SiO2 interface10.1016/j.mee.2011.04.036 ↗
43. Controlling the fixed charge and passivation properties of Si(100)/Al2O3 interfaces using ultrathin SiO2 interlayers synthesized by atomic layer deposition10.1063/1.3658246 ↗
44. Material combination of Tunnel-SiO2 with a (sub-)Monolayer of ALD-AlOx on silicon offering a highly passivating hole selective contact10.1016/j.solmat.2020.110654 ↗
45. Working principle of carrier selective poly-Si/c-Si junctions: is tunnelling the whole story?10.1016/j.solmat.2016.05.045 ↗
46. Effect of silicon oxide thickness on polysilicon based passivated contacts for high-efficiency crystalline silicon solar cells10.1016/j.solmat.2018.05.011 ↗
47. Understanding the charge transport mechanisms through ultrathin SiOx layers in passivated contacts for high-efficiency silicon solar cells10.1063/1.5081832 ↗
48. Ultra-thin LPCVD SiNx/n+poly-Si passivated contacts – a possibility?
49. Introducing pinhole magnification by selective etching: application to poly-Si on ultra-thin silicon oxide films10.1016/j.egypro.2017.09.270 ↗
50. Study of pinhole conductivity at passivated carrier-selected contacts of silicon solar cells10.1016/j.egypro.2016.07.040 ↗
51. J. Kang, W. Liu, T. Allen, M. De Bastiani, X. Yang, S. De Wolf, Intrinsic silicon buffer layer improves hole-collecting poly-Si passivating contact, Adv. Mater. Interfaces, n/a 2000188.
52. Working principle of carrier selective poly-Si/c-Si junctions: is tunnelling the whole story?10.1016/j.solmat.2016.05.045 ↗