journal article·2010-09

High deposition rate device quality a-Si:H films at low substrate temperature by HWCVD technique

S.K. Soni, Anup Phatak, R.O. Dusane

Publisher page

Abstract

Hot wire chemical vapor deposition (HWCVD) provides a low cost fabrication technology for hyrdogenated amorphous silicon (a-Si:H) based thin film single junction and tandem solar cells. In this paper, we report our results on the high deposition rate device quality a-Si:H films deposited by HWCVD at low substrate temperature. Films have been deposited using tantalum filament with highest deposition rates of 16 A/s and having the desired device quality properties like high photoconductivity gain (σ ph /σ dark ), low microstructure factor (as revealed by IR spectroscopy), good short range order parameter and acceptable thickness uniformity over the deposited area. An average photoconductivity gain of ≈ 3 × 10 5 has been obtained for the films deposited at rates ~15 A/s and the substrate temperature of 200 °C. The p- and n-type films have also been deposited by the HWCVD. Single junction p-i-n solar cells on ASAHi U-type substrates, fabricated using these layers have an efficiency of 5.1% under AM1.5 illumination. Depositing anti-reflection coating on front side, reflection coating before back contact and using textured TCO layer for light trapping would further improve the efficiency of the cell.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Thin-Film Transistor Technologies · Silicon and Solar Cell Technologies · Silicon Nanostructures and Photoluminescence

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (17)

Show source-provided references
1. p–i interface engineering and i-layer control of hot wire a-Si:H based p-i-n solar cells using in-situ ellipsometry10.1016/0927-0248(96)00055-4 ↗
2. Hydrogenated micro-crystalline silicon films produced at low temperature by hot wire deposition method10.1063/1.110801 ↗
3. Is the nucleation and coalescence behavior in the growth of a-Si:H films prepared by the Cat-CVD different?10.1016/S0040-6090(01)01228-7 ↗
4. Deposition of amorphous and micro-crystalline silicon using a graphite filament in the hot wire CVD technique10.1116/1.1405514 ↗
5. Electronic transport study of high deposition rate HWCVD a-Si:H by the microwave photomixing technique10.1557/PROC-664-A23.4 ↗
6. High-deposition rate a-Si:H n–i–p solar cells grown by HWCVD10.1016/S0040-6090(01)01274-3 ↗
7. Influence of the dilute-phase SiH bond concentration on the steady-state defect density in a-Si:H10.1016/0022-3093(95)00727-X ↗
8. Dopant atom induced disorder in hydrogenated amorphous silicon: Raman studies10.1103/PhysRevB.40.8026 ↗
9. Degradation and silicidation of Ta- and W-filaments for different filament temperatures10.1016/j.tsf.2009.01.025 ↗
10. The influence of different catalyzers in hot-wire CVD for the deposition of polycrystalline silicon thin films10.1016/S0040-6090(01)01254-8 ↗
11. Reversibility of silicidation of Ta filaments in HWCVD of thin film silicon
12. The influence of the filament temperature on the structure of deposited silicon10.1016/S0040-6090(03)00136-6 ↗
13. Microstructure and the light-induced metastability in hydrogenated amorphous silicon10.1063/1.99089 ↗
14. Optical characterization of wide band gap amorphous semiconductors .a-Si:C:H.: effect of hydrogen dilution
15. Properties of high growth rate amorphous silicon deposited by MC-RF-PECVD10.1016/S0042-207X(01)00293-7 ↗
16. Phase diagrams for Si:H film growth by plasma-enhanced chemical vapor deposition10.1016/S0022-3093(01)00996-6 ↗
17. P. Kumar, M. Kupich, W. Bock, R.O. Dusane, B. Schroeder, Microcrystalline single and double junction silicon based solar cells entirely prepared by HWCVD on textured zinc oxide substrate. J. Non-Cryst. Solids 352 (2006) 1855–1858.