Tuning back side passivation for enhancing the performance of PERC solar cells
Source abstract
Abstract
Abstract In the mono-crystalline silicon passivated emitter and rear cell (PERC), the back side passivation film made up of Al2O3 + SiNx:H stacks is the mainstream design. In this paper, the effect of the thickness of Al2O3 passivation layer on the performance of the solar cell was studied, and the correlation between the refractive index (RI) of SiNx:H layer and the efficiency gain of the solar cell after regeneration was analyzed. The results indicate that the thickness of Al2O3 layer needs to be balanced between the surface passivation and bulk passivation of SiNx:H, and the lower RI of SiNx:H layer shows a better hydrogen passivation capability. During the restoration of the solar cell efficiency, a thinner Al2O3 layer facilitates a faster stabilization of the boron-oxygen complexes. Finally, a new five-layer SiNx:H film was designed for the back side passivation film, and a conversion efficiency of 22.56 % was achieved, which is 0.05 % higher than that of the solar cell with a single-layer SiNx:H film.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Semiconductor materials and interfaces · Silicon Nanostructures and Photoluminescence
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (36)
Show source-provided references
1. The impact of subsurface damage on the fracture strength of diamond-wire-sawn monocrystalline silicon wafers
2. Fundamental investigation of subsurface damage in single crystalline silicon caused by diamond machining10.1016/j.precisioneng.2008.10.008 ↗
3. New methods to evaluate cleaning processes by detecting the particle load on surfaces of diamond wire sawn silicon wafers10.1016/j.egypro.2017.09.079 ↗
4. Advances in the surface passivation of silicon solar cells10.1016/j.egypro.2012.02.004 ↗
5. Integration of Al3O2 as front and rear surface passivation for large-area screen-printed p-type Si PERC10.1016/j.egypro.2012.07.071 ↗
6. 20.8% industrial PERC solar cell: ALD Al3O2 rear surface passivation, efficiency loss mechanisms analysis and roadmap to 24%10.1016/j.solmat.2016.11.018 ↗
7. Ye · 2016 · 3360
8. Towards high-efficiency industrial p-type mono-like Si PERC solar cells10.1016/j.solmat.2019.110202 ↗
9. Very low surface recombination velocities on p-type silicon wafers passivated with a dielectric with fixed negative charge10.1016/j.solmat.2006.04.014 ↗
10. Data of ALD Al3O2 rear surface passivation, Al3O2 PERC cell performance, and cell efficiency loss mechanisms of Al3O2 PERC cell10.1016/j.dib.2016.12.030 ↗
11. High-temperature stability of c-Si surface passivation by thick PECVD Al3O2 with and without hydrogenated capping layers10.1016/j.apsusc.2012.03.171 ↗
12. Impact of thermal treatment on PECVD Al3O2 passivation layers10.1016/j.egypro.2012.07.063 ↗
13. Comparison of the thermal stability of single Al3O2 layers and Al3O2/SiNx stacks for the surface passiviation of silicon10.1016/j.egypro.2011.06.141 ↗
14. Numerical analysis of p+ emitters passivated by a PECVD AlOx/SiNx stack10.1016/j.egypro.2013.07.258 ↗
15. PECVD-AlOx/SiNx passivation stacks on silicon: effective charge dynamics and interface defect state spectroscopy10.1016/j.egypro.2014.08.068 ↗
16. Ultralow surface recombination of c-Si substrates passivated by plasma-assisted atomic layer deposited Al3O210.1063/1.2240736 ↗
17. Interface issues of All-PECVD synthesized AlOx/SiNx passivation stacks for silicon solar cells, 27th
18. 19.4%-efficient large-area fully screen-printed silicon solar cells10.1002/pssr.201105045 ↗
19. Light-induced degradation of PECVD aluminium oxide passivated silicon solar cells10.1002/pssr.201409424 ↗
20. Light-induced degradation of silicon solar cells with aluminiumoxide passivated rear side10.1016/j.egypro.2015.07.086 ↗
21. Ab-initio calculation study on the formation mechanism of boron-oxygen complexes in c-Si10.1063/1.4927498 ↗
22. Lifetime instabilities in gallium doped monocrystalline PERC silicon solar cells10.1016/j.solmat.2019.110299 ↗
23. Investigations on the long time behavior of the metastable boron–oxygen complex in crystalline silicon10.1002/pip.779 ↗
24. Light induced degradation and regeneration of high efficiency Cz PERC cells with varying base resistivity10.1016/j.egypro.2013.07.312 ↗
25. In-situ characterization of electron-assisted regeneration of Cz-Si solar cells10.1016/j.solmat.2018.05.023 ↗
26. Determination of silicon nitride film chemical composition to study hydrogen desorption mechanisms10.1016/j.tsf.2011.04.130 ↗
27. Influence of hydrogen on the regeneration of boron-oxygen related defects in crystalline silicon10.1063/1.4804310 ↗
28. Characterization of SiNx:H thin film as a hydrogen passivation layer for silicon solar cells with passivated contacts10.1016/j.tsf.2019.02.016 ↗
29. Plasma-induced damage and annealing repairing in ALD- Al3O2/PECVD-SiNx stacks10.1016/j.mssp.2019.05.010 ↗
30. Efficiency improvement of PERC solar cell using an aluminum oxide passivation layer prepared via spatial atomic layer deposition and post-annealing10.1016/j.surfcoat.2018.12.016 ↗
31. Gas diffusion barriers on polymers using multilayers fabricated by Al3O2 and rapid SiO2 atomic layer deposition10.1021/jp076866+ ↗
32. Influence of hydrogenated passivation layers on the regeneration of boron-oxygen related defects10.1016/j.egypro.2013.07.328 ↗
33. Influence of the chemical composition in SiNx films on silver paste contact formation at silicon surface10.1016/j.solener.2016.01.001 ↗
34. Review of advanced hydrogen passivation for high efficient crystalline silicon solar cells10.1016/j.mssp.2018.01.019 ↗
35. Simulation study of light-induced, current-induced degradation and recovery on PERC solar cells10.1016/j.egypro.2016.07.014 ↗
36. Light and elevated temperature induced degradation in B-Ga co-doped cast mono Si PERC solar cells10.1016/j.solmat.2020.110508 ↗