journal article·2019-06

Investigation of polysilicon passivated contact's resilience to potential-induced degradation

Wei Luo, Ning Chen, Cangming Ke, Yan Wang, Armin G. Aberle, Seeram Ramakrishna, Shubham Duttagupta, Yong Sheng Khoo

Publisher page

Abstract

Abstract We present clear evidence of excellent resilience to potential-induced degradation (PID) from polysilicon passivated contacts implemented on the rear of n-type solar cells. Under the stress conditions of −1000 V, 50 °C, 30% relative humidity with aluminum foil, no damage was caused to the passivated contact consisting of an ultrathin silicon oxide (SiOx) film and an n+-doped polysilicon (poly-Si) layer after 168 h. With +1000 V bias and under the same chamber conditions, the SiOx/poly-Si (n+) passivated contact showed a slight change that translated into about 1% module power loss after 168 h, which is significantly lower than the 5% threshold recommended by IEC 62804-1 PID test standard. Furthermore, the SiOx/poly-Si (n+) passivated contact, even when encapsulated with ethylene-vinyl acetate copolymer films having a low volume resistivity in the range of 5 × 1014 Ω⸱cm, exhibited good stability under high-voltage stress. The experimental results were also validated by a generic device simulation, where the SiOx/poly-Si (n+) stack was shown to be immune to the surface polarization effect. In addition, a promising cell-level solution (i.e., using a stack of aluminium oxide and silicon nitride) to the polarization-type PID for n-type passivated emitter rear totally diffused silicon solar cells was also demonstrated.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Integrated Circuits and Semiconductor Failure Analysis

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. A comparative life-cycle assessment of photovoltaic electricity generation in Singapore by multicrystalline silicon technologies10.1016/j.solmat.2017.08.040 ↗
2. A review of solar photovoltaic levelized cost of electricity10.1016/j.rser.2011.07.104 ↗
3. Passivating contacts for crystalline silicon solar cells: from concepts and materials to prospects10.1109/JPHOTOV.2018.2797106 ↗
4. n-Type Si solar cells with passivating electron contact: identifying sources for efficiency limitations by wafer thickness and resistivity variation10.1016/j.solmat.2017.05.042 ↗
5. monoPoly™ cells: large-area crystalline silicon solar cells with fire-through screen printed contact to doped polysilicon surfaces10.1016/j.solmat.2018.05.059 ↗
6. The passivated emitter and rear cell (PERC): from conception to mass production10.1016/j.solmat.2015.06.055 ↗
7. n-Type polysilicon passivating contact for industrial bifacial n-type solar cells10.1016/j.solmat.2016.06.034 ↗
8. Passivated rear contacts for high-efficiency n-type Si solar cells providing high interface passivation quality and excellent transport characteristics10.1016/j.solmat.2013.09.017 ↗
9. Phosphorus-diffused polysilicon contacts for solar cells10.1016/j.solmat.2015.06.001 ↗
10. The application of poly-Si/SiOx contacts as passivated top/rear contacts in Si solar cells10.1016/j.solmat.2016.09.015 ↗
11. Tunnel oxide passivated carrier-selective contacts based on ultra-thin SiO2 layers10.1016/j.solmat.2015.06.048 ↗
12. Potential-induced degradation in photovoltaic modules: a critical review10.1039/C6EE02271E ↗
13. Potential-induced degradation (PID): introduction of a novel test approach and explanation of increased depletion region recombination10.1109/JPHOTOV.2014.2300238 ↗
14. Explanation of potential-induced degradation of the shunting type by Na decoration of stacking faults in Si solar cells10.1016/j.solmat.2013.06.015 ↗
15. Characterization of multicrystalline silicon modules with system bias voltage applied in damp heat
16. Elucidating potential-induced degradation in bifacial PERC silicon photovoltaic modules10.1002/pip.3028 ↗
17. Potential-induced degradation at interdigitated back contact solar cells10.1016/j.egypro.2014.08.015 ↗
18. The surface polarization effect in high-efficiency silicon solar cells
19. Potential-induced degradation for encapsulated n-type IBC solar cells with front floating emitter10.1016/j.egypro.2015.07.050 ↗
20. Investigation of potential-induced degradation in n-PERT bifacial silicon photovoltaic modules with a glass/glass structure10.1109/JPHOTOV.2017.2762587 ↗
21. Changes in the current density–voltage and external quantum efficiency characteristics of n-type single-crystalline silicon photovoltaic modules with a rear-side emitter undergoing potential-induced degradation10.1016/j.solmat.2016.03.003 ↗
22. Potential induced degradation of N-type bifacial silicon solar cells: an investigation based on electrical and optical measurements10.1016/j.solmat.2017.04.007 ↗
23. Accelerated testing and modeling of potential-induced degradation as a function of temperature and relative humidity10.1109/JPHOTOV.2015.2466463 ↗
24. Investigation of the impact of illumination on the polarization-type potential-induced degradation of crystalline silicon photovoltaic modules10.1109/JPHOTOV.2018.2843791 ↗
25. Influence of surface structure of n-type single-crystalline Si solar cells on potential-induced degradation10.1016/j.solmat.2017.03.018 ↗
26. Numerical investigation of metal–semiconductor–insulator–semiconductor passivated hole contacts based on atomic layer deposited AlOx
27. Numerical simulation of carrier-selective electron contacts featuring tunnel oxides10.1109/JPHOTOV.2015.2455346 ↗
28. Sentaurus · 2008
29. Towards 22% efficient screen-printed bifacial n-type silicon solar cells10.1016/j.solmat.2018.07.020 ↗