The detailed analysis of auger effect on the efficiency of intermediate band solar cells
Source abstract
Abstract
Abstract The effect of Auger mechanism on the efficiency of intermediate band solar cell (IBSC) has been investigated using detailed balance equations. Four types of the IBSCs, cells (a), (b), (c) and (d) including optical transitions and low (below bandgap)/high (above bandgap) threshold Auger generation/recombination between three bands have been analyzed. The effect of carrier multiplication probability, σ , on the variation of efficiency due to the bandgap, position of intermediate band energy level, the amount of overlap between equal and nonequal absorption coefficients and the sun concentration have been studied in detail. Since the Auger mechanism was more effective at lower bandgaps, it has been found out that the efficiency rised and the optimum bandgap providing the maximum efficiency moved towards the lower bandgaps, for three types of the cells, as multiplication probability increased. The highest efficiency of 72.9% has been obtained for new cell (c) at E G =1.42 eV, if both optical transitions and low/high threshold Auger processes were taken into account. This value was higher than the maximum efficiency of 63.2% obtained for E G =1.95 eV without Auger effect (cell (d)). Under maximum overlap condition, cell (b) exhibited the highest efficiency for the case of equal absorption coefficients and efficiency was highest in cell (c) for the case of nonequal absorption coefficients. Although the increment of sun concentration improved the efficiencies of all the cells, cell (b) had shown the highest efficiency below 200 sun concentration.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Semiconductor Quantum Structures and Devices · solar cell performance optimization · Chalcogenide Semiconductor Thin Films
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (26)
Show source-provided references
1. Present and future of super high efficiency multi-junction solar cells
2. Improving solar cell efficiencies by up-conversion of sub-band-gap light10.1063/1.1505677 ↗
3. Improving solar cell efficiencies by down-conversion10.1063/1.1492021 ↗
4. Luque · 2003
5. Thermodynamic efficiency limits for semiconductor solar cells with carrier multiplication10.1016/0927-0248(95)00125-5 ↗
6. Increasing the efficiency of ideal solar cells by photon induced transitions at intermediate levels10.1103/PhysRevLett.78.5014 ↗
7. Detailed balance limit of efficiency of p–n junction solar cells10.1063/1.1736034 ↗
8. Efficiency variation of the intermediate band solar cell due to the overlap between absorption coefficients10.1016/j.solmat.2007.08.012 ↗
9. T.S. Navruz, Efficiency optimization of intermediate band solar cell, Ph.D. Thesis, Gazi University, Department of Electrical and Electronics Engineering, Ankara, May 2008.
10. Intermediate band solar cell with many bands: ideal performance10.1063/1.1610774 ↗
11. T.S. Navruz, M. Saritas, The effect of Auger mechanism on the efficiency of the intermediate band solar cell, in: Proceedings of the 22nd European Photovoltaic Solar Energy Conference, Milan, Italy, 2007, pp. 641–647.
12. A metallic intermediate band high efficiency solar cell10.1002/pip.354 ↗
13. Influence of the overlap between the absorption coefficients on the efficiency of the intermediate band cell10.1109/TED.2004.828161 ↗
14. Quasi drift-diffusion model for the quantum dot intermediate band solar cell10.1109/TED.2002.802642 ↗
15. A. Marti, L. Cuadra, A. Luque, Quantum dot intermediate band solar cell, in: Photovoltaic Specialists Conference Record of the Twenty-Eighth IEEE, Anchorage, AK, USA, 2002, pp. 940–943.10.1109/PVSC.2000.916039 ↗
16. General equivalent circuit for intermediate band devices: potentials, currents and electroluminescence10.1063/1.1760836 ↗
17. Novel semiconductor solar cell structures: the quantum dot intermediate band solar cell10.1016/j.tsf.2005.12.122 ↗
18. Operation of the intermediate band solar cell under nonideal space charge region conditions and half filling of the intermediate band10.1063/1.2193063 ↗
19. Experimental analysis of the operation of quantum dot intermediate band solar cells10.1115/1.2735344 ↗
20. Impact-ionization-assisted intermediate band solar cell10.1109/TED.2003.809024 ↗
21. Thermodynamic efficiency of an intermediate band photovoltaic cell with low threshold Auger generation10.1063/1.2010622 ↗
22. Hennel · 1993 · vol. 38
23. Absorption characteristics of a quantum dot array induced intermediate band: implications for solar cell design10.1063/1.3058716 ↗
24. Optical properties of chalcopyrite-type intermediate transition metal band materials from first principles10.1016/j.tsf.2007.12.085 ↗
25. Evaluation of the efficiency potential of intermediate band solar cells based on thin-film chalcopyrite materials10.1063/1.2901213 ↗
26. Intermediate bands versus levels in non-radiative recombination10.1016/j.physb.2006.03.006 ↗