journal article·2026-08Open access

Improving VOC in wide bandgap (Ag,Cu) (In,Ga)Se2 solar cells for voltage-matched ACIGS/Si tandem modules

Ceren Mitmit, Matthias Diethelm, Matteo De Marzi, Nina Kochel, Joanna Maciejewska, Ajay Narasimhamurthy, Andrzej Miszczuk, Jessica de Wild, Bart Reekmans, Bart Vermang, Julia Horstmann, Romain Carron

Abstract

The open-circuit voltage (V OC ) deficit in wide-bandgap (Ag,Cu) (In,Ga)Se 2 (ACIGS) absorbers remains as the main limitation for their application in tandem solar cells. The roles of absorber growth temperature, surface treatment, and rubidium fluoride (RbF) post-deposition treatment (PDT) on the V OC of wide-bandgap ACIGS solar cells on transparent substrates and their integration into voltage-matched two-terminal ACIGS/Si tandems are investigated. Growth below 415 °C leads to poor morphology, Cu deficiency at the rear contact, and diode non-idealities, whereas higher temperatures improve film quality and V OC . An ammonia-based absorber rinsing step reduces V OC at growth temperature 415 °C and low Rb doses, whereas DI-water rinsing better preserves V OC and boosts short-circuit current density (J SC ). V OC -loss analysis based on the photoluminescence quantum yield (PLQY) is used to separate absorber bulk and interface contributions which are challenging to distinguish in complete solar cells. Quasi-Fermi-level splitting and diffusion-length estimates reveal that non-radiative recombination dominates V OC -loss, limiting the benefit of Ga back-grading. Building on these insights, we present the first experimental demonstration of a voltage- and area-matched two-terminal bifacial ACIGS/Si tandem module, implementing a fully laser-interconnected top ACIGS submodule. Voltage matching is achieved at 10 % rear illumination, with power density generation continuing to increase linearly beyond the voltage matching condition. In contrast to the more frequent series-connected tandems constrained by current matching conditions, the circuitry-2T architecture enables additional power gains under varying bifacial illumination. • Wide-bandgap ACIGS on TCO are V OC limited by non-radiative recombination. • Discrimination of bulk and front interface recombinations by PLQY-based analysis. • Investigation of growth temperature, alkali PDT and rinsing on recombination mechanisms. • First demonstration of voltage- and area-matched 2T bifacial ACIGS/Si tandem module. • Voltage-matched circuitry-2T tandems very resilient to varying bifacial illumination.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Ga2O3 and related materials · Optical Coatings and Gratings

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (42)

Show source-provided references
1. Cu(In,Ga)Se2 thin-film solar cells
2. High-concentration silver alloying and steep back-contact gallium grading enabling copper indium gallium selenide solar cell with 23.6% efficiency
3. Efficiency boost of bifacial Cu(In,Ga)Se2 thin-film solar cells for flexible and tandem applications with silver-assisted low-temperature process10.1038/s41560-022-01157-9 ↗
4. Wide-gap chalcopyrite solar cells with indium oxide–based transparent back contacts10.1002/solr.202200401 ↗
5. Using hydrogen-doped In2O3 films as a transparent back contact in (Ag,Cu)(In,Ga)Se2 solar cells10.1002/pip.2977 ↗
6. Wide-bandgap CuGaSe2 thin film solar cell fabrication using ITO back contacts10.1016/j.vacuum.2015.06.016 ↗
7. Assessment of transparent conductive oxides as back contacts for inline-fabricated Cu(In,Ga)Se2 solar cells
8. Effects of Ga contents on properties of CIGS thin films and solar cells fabricated by co-evaporation technique10.1016/j.cap.2009.11.082 ↗
9. Intrinsic DX centers in ternary chalcopyrite semiconductors10.1103/PhysRevLett.100.016401 ↗
10. Electronic defects in Cu(In,Ga)Se2: towards a comprehensive model
11. Origin of reduced efficiency in Cu(In,Ga)Se2 solar cells with high Ga concentration: alloy solubility versus intrinsic defects10.1109/JPHOTOV.2013.2285617 ↗
12. Revisiting the defect physics in CuInSe/sub 2/and CuGaSe/sub 2
13. Recombination effects of urbach tails as trap states in Cu(In, Ga)Se2 solar cells probed by temperature-dependent junction-transient spectroscopies10.1002/solr.202400925 ↗
14. The long-wavelength edge of photographic sensitivity and of the electronic absorption of solids10.1103/PhysRev.92.1324 ↗
15. Improved CuGaSe2 absorber properties through a modified co-evaporation process10.1016/j.tsf.2020.138224 ↗
16. Wide-gap (Ag,Cu)(In,Ga)Se2 solar cells with different buffer materials—A path to a better heterojunction10.1002/pip.3232 ↗
17. Direct evidence for grain boundary passivation in Cu(In,Ga)Se2 solar cells through alkali-fluoride post-deposition treatments10.1038/s41467-019-11996-y ↗
18. Advanced alkali treatments for high‐efficiency Cu(In,Ga)Se 2 solar cells on flexible substrates10.1002/aenm.201900408 ↗
19. Precise alkali supply during and after growth for high-performance low bandgap (Ag,Cu)InSe2 solar cells10.1002/solr.202400077 ↗
20. Influence of Ga back grading on voltage loss in low-temperature co-evaporated Cu(In,Ga)Se2 thin film solar cells10.1002/pip.3413 ↗
21. Silver‐promoted high‐performance (Ag,Cu)(In,Ga)Se 2 thin‐film solar cells grown at very low temperature10.1002/solr.202100108 ↗
22. Grain-boundary recombination in Cu(In,Ga)Se2 solar cells10.1063/1.2133906 ↗
23. Wide bandgap Cu(In,Ga)Se2 solar cells with improved energy conversion efficiency10.1002/pip.2244 ↗
24. Multi layer precursor method for Cu(In,Ga)Se2 solar cells fabricated on flexible substrates10.7567/JJAP.53.05FW03 ↗
25. Optimization of growth parameters of the RF-Sputtered CuInGaSe 2 thin films for photovoltaic applications10.1149/2162-8777/acedcf ↗
26. Effects of growth temperature on the morphological, structural, and electrical properties of CIGS thin film for use in solar cell applications10.3390/en16114467 ↗
27. Enabling low-temperature deposition of high-efficiency CIGS solar cells with a modified three-stage Co-Evaporation process10.1021/acsaem.9b02025 ↗
28. Overall distribution of rubidium in highly efficient Cu(In,Ga)Se2 solar cells
29. Effects of rubidium fluoride and potassium fluoride postdeposition treatments on Cu(In,Ga)Se2 thin films and solar cell performance10.1021/acs.chemmater.7b03412 ↗
30. XPS AND UPS investigation of NH/sub 4/OH-exposed Cu(In,Ga)Se/sub 2/thin films
31. Comparative study of water and ammonia rinsing processes of potassium fluoride-treated Cu(In,Ga)Se2thin film solar cells10.7567/JJAP.56.08MC12 ↗
32. ALD-ZnMgO and absorber surface modifications to substitute CdS buffer layers in co-evaporated CIGSe solar cells10.1051/epjpv/2020010 ↗
33. A comparison of different module configurations for multi-band-gap solar cells10.1016/0379-6787(88)90044-0 ↗
34. Efficiency limit of Perovskite/Si tandem solar cells10.1021/acsenergylett.6b00405 ↗
35. Experimental investigation of 2-Terminal voltage-matched perovskite/crystalline silicon tandem modules
36. Experimental demonstration of voltage-matched two-terminal tandem minimodules
37. Efficiency potential of photovoltaic materials and devices unveiled by detailed-balance analysis10.1103/PhysRevApplied.7.044016 ↗
38. Detailed balance limit of efficiency of p-n junction solar cells10.1063/1.1736034 ↗
39. Tabulated values of the shockley–Queisser limit for single junction solar cells10.1016/j.solener.2016.02.015 ↗
40. Interdependence of absorber composition and recombination mechanism in Cu(In,Ga)(Se,S)2 heterojunction solar cells10.1063/1.1467621 ↗
41. Enhancing photocurrent collection in wide-gap ACIGS solar cells
42. N. Nisika, S. Nishiwaki, C. Mitmit, M. De Marzi, R. Carron, High mobility and low carrier concentration transparent conducting oxide rear contact for bifacial CIGS solar cells, Prog. Photovoltaics Res. Appl. https://doi.org/10.1002/pip.70061.10.1002/pip.70061 ↗