journal article·2022-06Open access

Refined nickel nucleation and plated metal adhesion induced by pulsed light-induced plating on picosecond laser-ablated silicon solar cells

Xiaowei Shen, Pei-Chieh Hsiao, Zhimeng Wang, Benjamin Phua, Sean Lim, Alison Lennon

Abstract

This study reports the impact of pulsed Ni light-induced plating (LIP), compared to the commonly used galvanostatic Ni LIP, on the initial Ni nucleation and subsequently plated busbar adhesion of Cu-plated laser-ablated p-type passivated emitter and rear Si solar cells. Initial Ni nucleate sizes decreased from 27.8 ± 9.1 to 25.4 ± 7.9 nm when the pulse-on current density during pulsed Ni LIP was increased from 50 to 178 mA cm−2, and were smaller than the 30.4 ± 9.7 nm nucleates observed with galvanostatic plating at 25 mA cm−2 after the same charge had been delivered to the surface. The density of Ni nucleation was also increased for pulsed LIP. This increased density of smaller Ni nucleates was attributed to the higher pulse-on currents inducing a larger surface potential which favoured nucleation over Volmer Weber 3D island growth of Ni. It also led to a greater density of adhesive anchor points along busbars which contributed to more adhesive plated contacts with busbar pull forces as high as 3 N mm−1 being measured when the pulse-on current density was 100 mA cm−2. However, it is shown that higher pulse-on current densities can result in unintended parasitic reactions, such as H2 evolution, and reduced busbar adhesion.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Integrated Circuits and Semiconductor Failure Analysis · Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (65)

Show source-provided references
1. VDMA · 2020
2. Fang · 2020
3. Future challenges for photovoltaic manufacturing at the terawatt level10.1063/5.0020380 ↗
4. Improved contact metallization for high efficiency EFG polycrystalline silicon solar cells
5. A simple copper metallization process for high cell efficiencies and reliable modules
6. Large area copper plated silicon solar cell exceeding 19.5% efficiency10.1016/j.egypro.2012.05.008 ↗
7. Reliable contact formation for industrial solar cells by laser ablation and Ni/Cu plating
8. Industrial Si solar cells with Cu-based plated contacts10.1109/JPHOTOV.2015.2478067 ↗
9. 266-nm ps laser ablation for copper-plated p-type selective emitter PERC silicon solar cells10.1109/JPHOTOV.2018.2834629 ↗
10. Untangling the mysteries of plated metal finger adhesion: understanding the contributions from plating rate, chemistry, grid geometry, and sintering10.1109/JPHOTOV.2016.2589364 ↗
11. Impact of contact integrity during thermal stress testing on degradation analysis of copper-plated silicon solar cells10.1016/j.solmat.2017.09.005 ↗
12. Degradation of plated silicon solar module due to copper diffusion: the role of capping layer formation and contact adhesion10.1016/j.solmat.2020.110638 ↗
13. Degradation of copper-plated silicon solar cells with damp heat stress10.1002/pip.3331 ↗
14. Evolution of metal plating for silicon solar cell metallisation10.1002/pip.2221 ↗
15. Review of the potential of the Ni/Cu plating technique for crystalline silicon solar cells10.3390/ma7021318 ↗
16. Interface oxides in femtosecond laser structured plated Ni-Cu-Ag contacts for silicon solar cells10.1016/j.solmat.2017.03.016 ↗
17. Metallization of Si heterojunction solar cells by nanosecond laser ablation and Ni-Cu plating10.1016/j.solmat.2016.09.021 ↗
18. Impact of surface topography and laser pulse duration for laser ablation of solar cell front side passivating SiNx layers10.1063/1.3493204 ↗
19. Rear-side contact opening by laser ablation for industrial screen-printed aluminium local back surface field silicon wafer solar cells10.1016/j.egypro.2012.07.003 ↗
20. Electrical and mechanical properties of plated Ni/Cu contacts for Si solar cells10.1016/j.egypro.2015.07.104 ↗
21. Microstructure analysis of the interface situation and adhesion of thermally formed nickel silicide for plated nickel–copper contacts on silicon solar cells10.1016/j.solmat.2013.06.005 ↗
22. Improved metal adhesion with galvanic nickel plating to silicon solar cells10.1016/j.solmat.2016.12.012 ↗
23. The importance of surface roughness in the adhesion of electroless-plated metal in inkjet printed grooves
24. Colwell · 2018
25. Pulse and pulse reverse plating—conceptual, advantages and applications10.1016/j.electacta.2007.11.054 ↗
26. Microstructure and surface mechanical properties of pulse electrodeposited nickel10.1016/j.apsusc.2011.04.120 ↗
27. Pulse plating effects in nickel electrodeposition10.1016/0257-8972(89)90091-1 ↗
28. Pulse electrodeposition of nanocrystalline nickel using ultra narrow pulse width and high peak current density10.1016/S0257-8972(03)00014-8 ↗
29. Microstructural evolution in pulse plated nickel electrodeposits10.1016/S0257-8972(96)02928-3 ↗
30. Influence of pulse plating conditions on the structure and properties of pure and composite nickel nanocrystalline coatings10.1134/S1023193508060165 ↗
31. Surface roughening in the growth of direct current or pulse current electrodeposited nickel thin films10.1149/1.1415548 ↗
32. A novel method for improving the adhesion strength of the electrodeposited Ni films in MEMS10.1016/j.apsusc.2010.09.073 ↗
33. Mass transfer and electrocrystallization analyses of nanocrystalline nickel production by pulse plating10.1007/BF00249659 ↗
34. Diffusion barriers in thin films10.1016/0040-6090(78)90184-0 ↗
35. Challenges facing copper-plated metallisation for silicon photovoltaics: insights from integrated circuit technology development10.1002/pip.3062 ↗
36. Lopatin · 2008
37. Laser transfer and firing of NiV seed layer for the metallization of silicon heterojunction solar cells by Cu-plating10.1002/solr.201700085 ↗
38. Novel plating processes for silicon heterojunction solar cell metallization using a structured seed layer10.1109/JPHOTOV.2017.2748999 ↗
39. Copper-plating metallization with alternative seed layers for c-Si solar cells embedding carrier-selective passivating contacts10.1109/JPHOTOV.2019.2957671 ↗
40. Copper metallization of electrodes for silicon heterojunction solar cells: process, reliability and challenges10.1016/j.solmat.2021.110993 ↗
41. Influence of charge and discharge of electric double layer in pulse plating10.1007/BF00611281 ↗
42. MacDermid_Inc · 2002
43. A study of hardness and grain size in pulse current electroforming of nickel using different shaped waveforms10.1023/A:1004120823907 ↗
44. Electrochemical deposition of metals onto silicon10.1088/0022-3727/31/16/001 ↗
45. Light-induced electrochemical deposition of Ni for Si solar cell processing10.1149/2.006404ssl ↗
46. The energy of the dangling-bond states in a-Si10.1080/13642818608238960 ↗
47. Defects in amorphous silicon: a new perspective10.1103/PhysRevLett.57.2979 ↗
48. Rodriguez · 2016
49. Plated contacts for solar cells with superior adhesion strength to screen printed solar cells10.1007/s11708-016-0428-4 ↗
50. Nickel plating by pulse electrolysis: textural and microstructural modifications due to adsorption/desorption phenomena10.1007/BF01019584 ↗
51. Modelling picosecond and nanosecond laser ablation for prediction of induced damage on textured SiNx/Si surfaces of Si solar cells
52. Influence of small size pyramid texturing on contact shading loss and performance analysis of Ag-screen printed mono crystalline silicon solar cells10.1016/j.mssp.2018.05.039 ↗
53. Influence of texture feature size on the optical performance of silicon solar cells10.1002/pip.571 ↗
54. Anisotropic etching of crystalline silicon in alkaline solutions: I . Orientation dependence and behavior of passivation layers10.1149/1.2086277 ↗
55. Electroless nickel deposition and silicide formation for advanced front side metallization of industrial silicon solar cells10.1016/j.egypro.2012.05.006 ↗
56. Interfacial reactions of electroless nickel thin films on silicon10.1016/j.apsusc.2004.09.110 ↗
57. Charge exchange processes during the open-circuit deposition of nickel on silicon from fluoride solutions10.1149/1.1393308 ↗
58. Yao · 2013
59. Electrochemical recovery of nickel from nickel sulfamate plating effluents10.1007/s10800-012-0447-8 ↗
60. Hydrogen embrittlement of pulse-plated nickel
61. Hydrogen embrittlement of electroless copper deposits10.1149/1.2132858 ↗
62. Hydrogen embrittlement in different materials: a review10.1016/j.ijhydene.2018.09.201 ↗
63. Industrial Si solar cells with Cu based plated contacts
64. Dietrich · 2012 · 8472
65. Kraft · 2015