Impact of rapid thermal processing on bulk and surface recombination mechanisms in FZ silicon with fired passivating contacts
Source abstract
Abstract
We investigate bulk and interface recombination in crystalline silicon with p-type fired passivating contacts. These consist of a chemical oxide and an in-situ doped layer of SiCx with low carbon content. Following a rapid thermal annealing to activate the dopants in the SiCx layer, we observe the formation of bulk defect states close to one of the band edges at temperatures between 450 and 700 °C. At temperatures of 800 °C and above, these bulk defects are increasingly cured. At the same time, the surface passivation provided by the interfacial oxide is increasingly deteriorated at temperatures above 800 °C, eventually permitting the injection of a recombination current into the SiCx layer. Consequently, there is a trade-off for the effective minority carrier lifetime with an optimum between 800 and 830 °C. We develop a formalism that distinguishes recombination through shallow bulk defects from the recombination current at the surface in a plot of the effective lifetime τeff over the ratio n/p.
Source: openalex_inverted_index · Quality: baseline
Research context
OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Semiconductor materials and interfaces
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (27)
Show source-provided references
1. Generation and annihilation of point defects by doping impurities during FZ silicon crystal growth10.1016/j.jcrysgro.2011.04.017 ↗
2. Intrinsic point defect behavior in silicon crystals during growth from the melt: a model derived from experimental results10.1016/j.jcrysgro.2011.07.027 ↗
3. Kinetics of bulk lifetime degradation in float‐zone silicon: fast activation and annihilation of grown‐in defects and the role of hydrogen versus light10.1002/pssa.202000436 ↗
4. Thermal activation and deactivation of grown-in defects limiting the lifetime of float-zone silicon10.1002/pssr.201600080 ↗
5. Silicon heterojunction solar cell with interdigitated back contacts for a photoconversion efficiency over 26%,10.1038/nenergy.2017.32 ↗
6. Polysilicon emitters for silicon concentrator solar cells
7. Laser contact openings for local poly-Si-metal contacts enabling 26.1%-efficient POLO-IBC solar cells10.1016/j.solmat.2018.06.020 ↗
8. Design rules for high-efficiency both-sides-contacted silicon solar cells with balanced charge carrier transport and recombination losses10.1038/s41560-021-00805-w ↗
9. A mixed-phase SiOx hole helective junction compatible with high temperatures used in industrial solar cell manufacturing
10. A passivating contact for silicon solar cells formed during a single firing thermal annealing10.1038/s41560-018-0239-4 ↗
11. Contributions to the contact resistivity in fired tunnel-oxide passivating contacts for crystalline silicon solar cells10.1109/JPHOTOV.2019.2939880 ↗
12. Implementation and understanding of p+ fired rear hole selective tunnel oxide passivating contacts enabling >22% conversion efficiency in p-type c-Si solar cells10.1016/j.solmat.2020.110809 ↗
13. Statistics of the recombinations of holes and electrons10.1103/PhysRev.87.835 ↗
14. Electron-hole recombination in germanium10.1103/PhysRev.87.387 ↗
15. Parameterisation of injection-dependent lifetime measurements in semiconductors in terms of Shockley-Read-Hall statistics: an application to oxide precipitates in silicon10.1063/1.4725475 ↗
16. Spatially resolved impurity identification via temperature-and injection-dependent photoluminescence imaging10.1109/JPHOTOV.2015.2447837 ↗
17. Impact of illumination level and oxide parameters on Shockley–Read–Hall recombination at the Si‐SiO2 interface10.1063/1.350782 ↗
18. Determination of Si-SiO/sub 2/interface recombination parameters using a gate-controlled point-junction diode under illumination10.1109/16.2441 ↗
19. Dimensionless solution of the equation describing the effect of surface recombination on carrier decay in semiconductors10.1063/1.357521 ↗
20. Measurement of the emitter saturation current by a contactless photoconductivity decay method
21. Field-effect passivation of the SiO2-Si interface10.1063/1.370784 ↗
22. Improved quantitative description of Auger recombination in crystalline silicon10.1103/PhysRevB.86.165202 ↗
23. Tunnel oxide passivated carrier-selective contacts based on ultra-thin SiO2 layers10.1016/j.solmat.2015.06.048 ↗
24. Crystalline silicon solar cells with coannealed electron- and hole-selective SiCx passivating contacts10.1109/JPHOTOV.2018.2866189 ↗
25. Polzin · Realization of TOPCon using industrial scale PECVD equipment AIP Conf. Proc. · 2018 · 1999
26. M. Lehmann, “Characterization and Development of Fired Passivating Contacts for Silicon Solar Cells,” EPFL.
27. Boron-oxygen defect imaging in p-type Czochralski silicon10.1063/1.4819096 ↗