journal article·2024-08

Influence of inverted pyramid texturization on front metallization and performance of crystalline silicon solar cells

Bowen Feng, Wei Chen, Guoguang Xing, Xingqian Chen, Haozhen Li, Zongheng Sun, Yiwen Zhang, Yaoping Liu, Xiaolong Du

Publisher page

Abstract

The silicon surface texturing is an essential part for the fabrication of crystalline silicon solar cells to increase the conversion efficiency. By adjusting the etching texturing condition, inverted pyramid (IP) and upright pyramid (UP) texturization were prepared on crystalline silicon substrates for fabrication of PERC solar cells. The surface morphology not only affects the light trapping but also impacts electrode shading loss and front electrode contact interface. The IP texturization presents better anti-reflective performance due to more common light paths and narrower silver grids owing to less flow of Ag paste on concave blocked structure, both of which results in the higher short-circuit current density (J sc ). Yet in terms of front Ag/Si contact interface, the IP texturization causes more Ag crystallites and more surface recombination under the present condition suitable for UP texturization because of more edges on the upper part of IP, which leads to the lower open-circuit voltage (V oc). The final conversion efficiency of IP solar cells (23.61 %) is 0.06 % higher than that of UP solar cells (23.55 %). An improvement about 0.07 mA/cm 2 of J sc was achieved with IP samples and V oc has a decrease of 0.3 mV caused by the surface recombination on IP texturization. In summary, the structural characteristics of IP results in lower reflectivity and less electrode shading, while Ag/Si contact interface could be optimized by adjusting the processing condition, ultimately promising the higher efficiency.
Source: expertdata · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Photovoltaic System Optimization Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (29)

Show source-provided references
1. Silicon solar cell with undoped tin oxide transparent electrode10.1038/s41560-023-01331-7 ↗
2. Status and perspectives of crystalline silicon photovoltaics in research and industry10.1038/s41578-022-00423-2 ↗
3. Silicon heterojunction solar cells: Techno-economic assessment and opportunities10.1016/j.joule.2022.02.009 ↗
4. Silicon heterojunction solar cells with up to 26.81% efficiency achieved by electrically optimized nanocrystalline-silicon hole contact layers10.1038/s41560-023-01255-2 ↗
5. Optical properties of a random inverted pyramid textured silicon surface studied by the ray tracing method10.1016/j.solener.2019.05.031 ↗
6. Chain pyramid texturization for better light trapping and efficiency of silicon solar cells10.1016/j.solmat.2022.112137 ↗
7. Difference in anisotropic etching characteristics of alkaline and copper based acid solutions for single-crystalline Si10.1038/s41598-018-21877-x ↗
8. Maskless inverted pyramid texturization of silicon
9. Micro-structured inverted pyramid texturization of Si inspired by self-assembled Cu nanoparticles10.1039/C6NR08126F ↗
10. Influence of small size pyramid texturing on contact shading loss and performance analysis of Ag-screen printed mono crystalline silicon solar cells10.1016/j.mssp.2018.05.039 ↗
11. Influence of random pyramid surface texture on silver screen-printed contact formation for monocrystalline silicon wafer solar cells10.1016/j.solmat.2014.10.018 ↗
12. Differently shaped Ag crystallites and four current transport paths at sintered Ag/Si interface of crystalline silicon solar cells10.1016/j.solmat.2023.112381 ↗
13. Selective chemical etching for studying the front side contact in thick film screen printed crystalline P-type silicon solar cells10.4067/S0717-97072015000200009 ↗
14. Abnormal dopant Distribution in POCl3-Diffused N+ emitter of textured silicon solar cells10.1109/LED.2010.2098840 ↗
15. Electrical properties of screen printed silicon solar cell Dependent upon thermophysical behavior of glass frits in Ag pastes10.1143/JJAP.48.05EC06 ↗
16. Silver thick-film contacts on highly doped n-type silicon emitters: structural and electronic properties of the interface10.1063/1.1562338 ↗
17. Current transport mechanism in printed Ag thick film contacts to an N-type emitter of a crystalline silicon solar cell
18. Current transport in thick film Ag metallization: direct contacts at Silicon pyramid tips?10.1016/j.egypro.2011.06.179 ↗
19. The formation mechanism for printed silver-contacts for silicon solar cells10.1038/ncomms11143 ↗
20. Interface analysis of Ag/n‐type Si contacts in n‐type PERT solar cells10.1002/pip.3242 ↗
21. Influence of surface texturing conditions on crystalline silicon solar cell performance10.1016/j.cap.2013.01.008 ↗
22. Optimization of silicon pyramidal emitter by self-selective Ag-assisted chemical etching10.1039/c4ra03120b ↗
23. Black silicon on emitter diminishes the lateral electric field and enhances the blue response of a solar cell by optimizing depletion region uniformity10.1016/j.scriptamat.2012.10.023 ↗
24. Effects of textured morphology on the short circuit current of single crystalline silicon solar cells: evaluation of alkaline wet-texture processes10.1016/j.cap.2008.12.014 ↗
25. Microstructural characterization and current conduction mechanisms of front-side contact of n-type crystalline Si solar cells with Ag/Al pastes10.1063/1.4921544 ↗
26. Electron microscopy study of front-side Ag contact in crystalline Si solar cells10.1063/1.3086663 ↗
27. Microstructural comparison of silicon solar cells' front-side Ag contact and the evolution of current conduction mechanisms10.1063/1.3642956 ↗
28. Understanding current paths and temperature distributions during ‘laser enhanced contact optimization’ (LECO)
29. Microscale contact formation by laser enhanced contact optimization10.1109/JPHOTOV.2021.3129362 ↗