Wasted scrub pad functionalized with graphene and porous BiFeO3 microparticles for the desalination/decontamination of water by solar evaporation
Source abstract
Abstract
Solar water evaporators were fabricated with wasted scrub pad (SP) and their performance for the desalination/decontamination of water was evaluated. Firstly, bare SP was utilized for the desalination of seawater obtained from Puerto Vallarta beach, Mexico. SP produced an evaporation rate (ER)/efficiency of 2.18 kg m −2 h −1/72.6 %, respectively, under natural solar light. Subsequently, the SP evaporator was coated with graphene (G) + porous BiFeO 3 (BFO) microparticles. This SPG + BFO evaporator produced an outstanding evaporation rate/efficiency of 2.93 kg m −2 h −1 /94.6 %. Thus, the evaporation rate and evaporation efficiency increased by 33 % and by 22 % after adding the graphene + BFO coating. Absorbance and Raman analysis on the evaporators’ surface revealed that the evaporators made with graphene + BFO had higher absorbance of NIR light and higher content of defects. This favored the transformation of light to heat and steam generation. Additionally, the SPG + BFO evaporator was employed for the decontamination of water. Laundry wastewater (LWW) and domestic-wastewater contaminated with coke-soda (WCS) or coffee-drink (WCD) were also decontaminated using the SPG + BFO evaporator. The LWW contained mainly suspended solids, while the WCS and the WCD contained caffeine. The clean water obtained from the evaporation of LWW, WCS and WCD was completely free of suspended solids or caffeine as demonstrated by the FTIR and absorbance measurements. Overall, the results of this investigation demonstrate that low-cost evaporators can be fabricated from wasted scrub pads and those ones are very efficient for the evaporation/decontamination of water. Giving a second use to the wasted scrub pads benefits the environment because this delays its contamination by plastics.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Solar-Powered Water Purification Methods · Solar Thermal and Photovoltaic Systems · Membrane Separation Technologies
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (71)
Show source-provided references
1. Reassessing the projections of the world water development report10.1038/s41545-019-0039-9 ↗
2. Economically challenged and water scarce: identification of global populations most vulnerable to water crises10.1080/07900627.2019.1698413 ↗
3. A review of remote sensing applications for water security: quantity, quality, and extremes10.1016/j.jhydrol.2020.124826 ↗
4. Water scarcity impacts on global food production10.1016/j.gfs.2019.07.007 ↗
5. Future global urban water scarcity and potential solutions10.1038/s41467-021-25026-3 ↗
6. Tzanakakis · 2020 · 2347
7. Global water scarcity including surface water quality and expansions of clean water technologies10.1088/1748-9326/abbfc3 ↗
8. Utilization of solar energy for wastewater treatment: challenges and progressive research trends10.1016/j.jenvman.2021.113300 ↗
9. Same materials, bigger output: a reversibly transformable 2D–3D photothermal evaporator for highly efficient solar steam generation10.1016/j.nanoen.2020.105477 ↗
10. Enhancing solar steam generation using a highly thermally conductive evaporator support10.1016/j.scib.2021.09.018 ↗
11. Recyclable and efficient ocean biomass-derived hydrogel photothermal evaporator for thermally-localized solar desalination10.1016/j.desal.2021.115449 ↗
12. Dual‐zone photothermal evaporator for antisalt accumulation and highly efficient solar steam generation10.1002/adfm.202102618 ↗
13. Scalable and cost-effective fabrication of self-floating three-dimensional interconnected polyethylene/multiwall carbon nanotubes composite foam for high evaporation performance10.1016/j.compositesb.2022.110111 ↗
14. State‐of‐the‐Art advances, development, and challenges of metal oxide semiconductor nanomaterials for photothermal solar steam generation
15. Structure development of carbon-based solar-driven water evaporation systems10.1016/j.scib.2021.02.014 ↗
16. A review on photothermal material and its usage in the development of photothermal membrane for sustainable clean water production10.1016/j.desal.2021.115259 ↗
17. A highly flexible and washable nonwoven photothermal cloth for efficient and practical solar steam generation10.1039/C8TA00187A ↗
18. A salt-free superhydrophilic metal-organic framework photothermal textile for portable and efficient solar evaporator10.1016/j.solmat.2021.111329 ↗
19. Low‐cost, unsinkable, and highly efficient solar evaporators based on coating MWCNTs on nonwovens with unidirectional water‐transfer10.1002/advs.202101727 ↗
20. All-in-one polymer sponge composite 3D evaporators for simultaneous high-flux solar-thermal desalination and electricity generation10.1016/j.nanoen.2021.106882 ↗
21. Polyimide-based superhydrophilic porous membrane with enhanced thermal insulation for efficient interfacial solar evaporation10.1016/j.compscitech.2022.109683 ↗
22. Tailoring graphene oxide‐based aerogels for efficient solar steam generation under one sun
23. Integrative solar absorbers for highly efficient solar steam generation10.1039/C7TA08256H ↗
24. Photocatalytic treatment of detergent-contaminated wastewater: a short review on current progress10.1007/s11814-021-0964-4 ↗
25. Laundry wastewater treatment using a combination of sand filter, bio-char and teff straw media10.1038/s41598-019-54888-3 ↗
26. Water pathways through the ages: integrated laundry wastewater treatment for pollution prevention10.1016/j.scitotenv.2020.143966 ↗
27. Topology‐controlled hydration of polymer network in hydrogels for solar‐driven wastewater treatment10.1002/adma.202007012 ↗
28. Yolk-like non-stoichiometric nickel sulfide-based Janus hydrogel photothermal film for enhanced solar-driven water evaporation and multi-media purification10.1016/j.jcis.2021.09.074 ↗
29. Impact of caffeine and coffee on our health10.1016/j.tem.2014.07.003 ↗
30. Chronic effects of soft drink consumption on the health state of Wistar rats: a biochemical, genetic and histopathological study10.3892/mmr.2016.5199 ↗
31. Occurrence, fate, persistence and remediation of caffeine: a review10.1007/s11356-019-06998-8 ↗
32. Alternative techniques for caffeine removal from wastewater: an overview of opportunities and challenges
33. Photo-active and optical properties of bismuth ferrite (BiFeO3): an experimental and theoretical study10.1016/j.cplett.2013.04.024 ↗
34. Controllable electrical, magnetoelectric and optical properties of BiFeO3 via domain engineering10.1016/j.pmatsci.2022.100943 ↗
35. Converting poly (ethylene terephthalate) waste into N-doped porous carbon as CO2 adsorbent and solar steam generator10.1016/j.gee.2020.10.002 ↗
36. Influence of sub-monolayer quantities of carbon nanoparticles on the melting and crystallization behavior of polyamide 12 powders for additive manufacturing10.1016/j.matdes.2021.109487 ↗
37. Microwave-assisted rapid preparation of nano-ZnO/Ag composite functionalized polyester nonwoven membrane for improving its UV shielding and antibacterial properties10.3390/ma11081412 ↗
38. Synthesis of mixed calcite–calcium oxide nanojasmine flowers10.1016/j.ceramint.2015.10.030 ↗
39. Performance of graphite and graphene as electrodes in primary cell battery
40. Electrospun BMIMPF 6/nylon 6, 6 nanofiber chemiresistors as organic vapour sensors10.1007/s13233-012-0043-0 ↗
41. Effect of rice husk ash filler of resistance against of high-speed projectile impact on polyester-fiberglass double panel composites
42. 1, 3-Diamino-2-hydroxypropane-N, N, N′, N′-tetraacetic acid stabilized amorphous calcium carbonate: nucleation, transformation and crystal growth10.1039/B911426M ↗
43. Adsorption of methylene blue from aqueous solution by graphene10.1016/j.colsurfb.2011.10.019 ↗
44. Effects on the thermo-mechanical and crystallinity properties of nylon 6, 6 electrospun fibres reinforced with one dimensional (1D) and two dimensional (2D) carbon10.3390/ma6083494 ↗
45. Anchoring Co3O4 on BiFeO3: achieving high photocatalytic reduction in Cr (VI) and low cobalt leaching10.1007/s10853-019-03816-x ↗
46. Effects of polymerization conditions on hydrophilic groups in aromatic polyamide thin films10.1016/j.memsci.2008.12.055 ↗
47. Regulating interfacial polymerization via a multi-functional calcium carbonate based interlayer for a highly permselective nanofiltration membrane10.1039/D2TA10050A ↗
48. Graphene-based nanofiltration membranes for improving salt rejection, water flux and antifouling–A review10.1016/j.desal.2017.12.012 ↗
49. Electrospun reduced graphene oxide/polyacrylonitrile membrane for high-performance solar evaporation10.1016/j.solener.2020.09.013 ↗
50. Bioinspired fractal design of waste biomass‐derived solar–thermal materials for highly efficient solar evaporation
51. Carbonized sugarcane as interfacial photothermal evaporator for vapor generation10.1016/j.desal.2021.115544 ↗
52. Engineering a superhydrophilic TiC/C absorber with multiscale pore network for stable and efficient solar evaporation of high-salinity brine
53. Identification of functional groups and determination of carboxyl formation temperature in graphene oxide using the XPS O 1s spectrum10.1016/j.tsf.2015.07.051 ↗
54. XPS study in BiFeO3 surface modified by argon etching10.3390/ma15124285 ↗
55. A high-efficient and ultra-strong interfacial solar evaporator based on carbon-fiber fabric for seawater and wastewater purification10.1016/j.desal.2022.115586 ↗
56. Waste-treating-waste: upcycling discarded polyester into metal–organic framework nanorod for synergistic interfacial solar evaporation and sulfate-based advanced oxidation process10.1016/j.cej.2022.140994 ↗
57. Semiconductor photothermal materials enabling efficient solar steam generation toward desalination and wastewater treatment10.1016/j.desal.2020.114853 ↗
58. A strategy to fabricate bismuth ferrite (BiFeO3) nanotubes from electrospun nanofibers and their solar light-driven photocatalytic properties10.1039/c3ra44085k ↗
59. Cost-effective and eco-friendly laser-processed cotton paper for high-performance solar evaporation10.1016/j.solmat.2020.110693 ↗
60. Unsaturated polyester resin supported form-stable phase change materials with enhanced thermal conductivity for solar energy storage and conversion10.1016/j.renene.2021.04.033 ↗
61. Thermal conductivity of graphene-based polymer nanocomposites10.1016/j.mser.2020.100577 ↗
62. Preparation and properties of polyamide 6 thermal conductive composites reinforced with fibers10.1016/j.matdes.2013.03.076 ↗
63. Phonon thermal transport and phonon–magnon coupling in polycrystalline BiFeO3 systems10.1088/0022-3727/48/11/115301 ↗
64. Computation of nitrate concentrations in turbid coastal waters using an in situ ultraviolet spectrophotometer10.1016/j.seares.2011.04.002 ↗
65. Treatment of laundry waste‐water by electrocoagulation10.1002/jctb.2625 ↗
66. Simultaneous determination of methylxanthines in coffees and teas by UV-Vis spectrophotometry and partial least squares10.1016/S0003-2670(03)00862-6 ↗
67. Compositional differences between size classes of dissolved organic matter from freshwater and seawater revealed by an HPLC-FTIR system10.1021/es203711v ↗
68. Optical properties of alkali halide crystals
69. Determination of sodium fatty acid in soap formulation using Fourier Transform Infrared (FTIR) spectroscopy and multivariate calibrations10.1007/s11743-010-1195-6 ↗
70. Chemical changes of wood treated with caffeine10.3390/ma14030497 ↗
71. 2021