Cu2ZnSn(S,Se)4 solar cells with over 10% power conversion efficiency enabled by dual passivation strategy
Source abstract
Abstract
Interfaces quality have always been considered the key factors in the fabrication of efficient Cu 2ZnSn(S,Se) 4 (CZTSSe) solar cells, and harmful defects at the interface can significantly reduce the performance of the device. Here, we propose a dual passivation strategy by adding Na to the surface of the absorber layer (CZTSSe) to passivate the CZTSSe/CdS interface and treating the buffer layer (CdS) using ultraviolet (UV) irradiation to passivate the CdS/ZnO interface. Due to the Na doping passivation, the absorber surface conductivity increases while the roughness decreases and detrimental defects that can lead to nonradiative recombination are reduced. The power conversion efficiency (PCE) of the cell is improved by about 1 percentage point by Na passivation. The contributions of open-circuit voltage ( V oc), short-circuit current density ( J sc), and fill factor (FF) to the improvement of PCE have been quantified as 50.64%, −5.58%, and 54.94%, indicating that Na doping can significantly boost V oc and FF. UV-ozone passivation reduces residual carbon organics in the CdS buffer layer, weakens carrier recombination, allows for more light absorption, and widens the depletion region, which favors efficient carrier collection. The estimated contribution of V oc, J sc , and FF to the PCE of the device is 8.78%, 119.59%, and −28.37%, respectively, demonstrating that UV-ozone passivation can significantly improve the J sc of the device. The two passivation strategies complement each other`s advantages and achieve a synergistic effect. Our prepared champion device exhibits a PCE of 10.69% and remarkable long-term stability.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (57)
Show source-provided references
1. Ultrasonic effect on optical, structural, topographical and morphological studies of Cu2CdSnS4 quaternary alloy nanostructures10.1016/j.jallcom.2016.06.235 ↗
2. Cd-free Cu(In,Ga)(Se,S)2 thin-film solar cell with record efficiency of 23.3510.1109/JPHOTOV.2019.2937218 ↗
3. Unveiling microscopic carrier loss mechanisms in 12% efficient Cu2ZnSnSe4 solar cells10.1038/s41560-022-01078-7 ↗
4. Ambient air-processed Cu2ZnSn(S,Se)4 solar cells with over 12% efficiency10.1016/j.scib.2020.12.030 ↗
5. Solar cell efficiency tables (version 62)10.1002/pip.3726 ↗
6. Kesterite Cu2ZnSn(S,Se)4 solar cells with beyond 8% efficiency by a sol-gel and selenization process10.1021/acsami.5b01151 ↗
7. Cu2ZnSn(SxSe1-x)4 thin film solar cell with high sulfur content (x approximately 0.4) and low Voc deficit prepared using a postsulfurization process10.1016/j.solmat.2017.09.036 ↗
8. Control of the phase evolution of kesterite by tuning of the selenium partial pressure for solar cells with 13.8% certified efficiency10.1038/s41560-023-01251-6 ↗
9. Device postannealing enabling over 12% efficient solution‐processed Cu2ZnSnS4 solar cells with Cd2+ substitution10.1002/adma.202000121 ↗
10. Controllable double gradient bandgap strategy enables high efficiency solution‐processed kesterite solar cells
11. Unveiling the selenization reaction mechanisms in ambient air‐processed highly efficient kesterite solar cells10.1002/aenm.202300521 ↗
12. Identifying the origin of the Voc deficit of kesterite solar cells from the two grain growth mechanisms induced by Sn2+ and Sn4+ precursors in DMSO solution10.1039/D0EE03702H ↗
13. Elemental de-mixing-induced epitaxial kesterite/CdS interface enabling 13%-efficiency kesterite solar cells10.1038/s41560-022-01132-4 ↗
14. Influencing mechanism of cationic ratios on efficiency of Cu2ZnSn(S,Se)4 solar cells fabricated with DMF-based solution approach10.1016/j.solmat.2019.02.029 ↗
15. Optimization of the selenization pressure enabling efficient Cu2ZnSn(S,Se)4 solar cells
16. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
17. Coordination engineering of Cu-Zn-Sn-S aqueous precursor for efficient kesterite solar cells10.1016/j.scib.2020.01.005 ↗
18. A high-efficiency 12.5% kesterite solar cell realized by crystallization growth kinetics control over aqueous solution based Cu2ZnSn(S,Se)410.1039/D1TA09024K ↗
19. Aqueous-solution-Processed Cu2ZnSn(S,Se)4 thin-film solar cells via an improved successive ion-layer-adsorption-reaction sequence10.1021/acsomega.7b00967 ↗
20. Kesterite Cu2ZnSnS4 thin film solar cells by a facile DMF-based solution coating process10.1039/C5TC01750E ↗
21. Germanium alloyed kesterite solar cells with low voltage deficits10.1021/acs.chemmater.5b04806 ↗
22. 11.5% efficient Cu2ZnSn(S,Se)4 solar cell fabricated from DMF molecular solution10.1039/D1TA01871J ↗
23. DMF-based large-grain spanning Cu2ZnSn(Sx ,Se1-x)4 device with a PCE of 11.7610.1002/advs.202201241 ↗
24. Underlying mechanism of the efficiency loss in CZTSSe solar cells: disorder and deep defects10.1007/s40843-020-1385-0 ↗
25. Defect suppression for high-efficiency kesterite CZTSSe solar cells: advances and prospects10.1016/j.cej.2023.142121 ↗
26. Engineering of interface band bending and defects elimination via a Ag-graded active layer for efficient (Cu, Ag)2ZnSn(S,Se)4 solar cells10.1039/C7EE01405H ↗
27. Improved CZTSe solar cell efficiency via silver and germanium alloying10.1016/j.solener.2023.112247 ↗
28. Improving device performance of sputtered CZTSe based solar cells by Manganese doping10.1016/j.optmat.2024.115138 ↗
29. Mechanism of enhanced power conversion efficiency of Cu2ZnSn(S,Se)4 solar cell by cadmium surface diffusion doping10.1016/j.jallcom.2021.160160 ↗
30. Boosting the electrical properties of Cu2ZnSn(S,Se)4 solar cells via low amounts of Mg substituting Zn10.1021/acsaem.0c02121 ↗
31. Highly efficient solution-processed CZTSSe solar cells based on a convenient sodium-incorporated post-treatment method10.1016/j.jechem.2019.03.029 ↗
32. Na-doping-induced modification of the Cu2ZnSn(S,Se)4/CdS heterojunction towards efficient solar cells10.1016/j.jechem.2020.09.007 ↗
33. Synergistic incorporation of NaF and CsF PDT for high efficiency kesterite solar cells: unveiling of grain interior and grain boundary effects10.1039/D0TA08224D ↗
34. Sodium assisted sintering of chalcogenides and its application to solution processed Cu2ZnSn(S,Se)4 thin film solar cells10.1021/cm403504u ↗
35. Passivation of grain boundaries and defects in CZTSSe solar cells by in situ Na doping10.1002/solr.202300061 ↗
36. Evolution of morphology and composition during annealing and selenization in solution-processed Cu2ZnSn(S,Se)410.1021/acs.chemmater.7b03313 ↗
37. Simple and versatile UV-ozone oxide for silicon solar cell applications10.1016/j.solmat.2018.06.006 ↗
38. Low-temperature UV ozone-treated high efficiency radial p-n junction solar cells: N-Si NW arrays embedded in a p-Si matrix10.1016/j.nanoen.2014.10.028 ↗
39. Solvent mediated inclusion of metal oxide into block copolymer nanopatterns: mechanism of oxide formation under UV-Ozone treatment10.1016/j.polymer.2019.04.043 ↗
40. Performance improvement of Cu2ZnSn(S,Se)4 solar cells by ultraviolet ozone treatment on precursor films10.1016/j.solmat.2021.111092 ↗
41. Effect of UV irradiation on Cu2ZnSnS4 thin films prepared by the sol–gel sulfurization method10.1016/j.jallcom.2015.08.231 ↗
42. UV-ozone induced surface passivation to enhance the performance of Cu2ZnSnS4 solar cells10.1016/j.solmat.2019.04.014 ↗
43. Ultrasensitive detection of volatile organic compounds by a freestanding aligned Ag/CdSe-CdS/PMMA texture with double-side UV-ozone treatment10.1021/acsami.9b12333 ↗
44. The enhancement of CZTSSe solar cell performance through active construction of the double-layer absorber10.1016/j.solmat.2023.112670 ↗
45. CdS (In)/CZTSSe bandgap alignment engineering for performance enhancement of solar cells without ZnO layer10.1016/j.solmat.2024.112787 ↗
46. Impact of Na dynamics at the Cu2ZnSn(S,Se)4/CdS interface during post low temperature treatment of absorbers10.1021/acsami.5b12243 ↗
47. Photoluminescence and Raman study of Cu2ZnSn(SexS1−x)4 monograins for photovoltaic applications10.1016/j.tsf.2010.12.099 ↗
48. Improved interfacial properties of electrodeposited Cu2ZnSn(S,Se)4 thin-film solar cells by a facile post-heat treatment process10.1002/pip.3332 ↗
49. Effects of Ge alloying on device characteristics of kesterite-based CZTSSe thin film solar cells10.1021/acs.jpcc.5b11594 ↗
50. Tailoring the defects and carrier density for beyond 10% efficient CZTSe thin film solar cells10.1016/j.solmat.2016.09.034 ↗
51. Cu2ZnSnS4 solar cells with over 10% power conversion efficiency enabled by heterojunction heat treatment10.1038/s41560-018-0206-0 ↗
52. Synergistic effect of Na and Se on CZTSe solar cells through a soft chemical process10.1016/j.solmat.2019.04.015 ↗
53. Thermodynamic analysis of decomposition of thiourea and thiourea oxides10.1021/jp051620v ↗
54. Luque · 2011
55. Efficiency enhancement of Cu2ZnSn(S,Se)4 solar cells by addition a CuSe intermediate layer between Cu2ZnSn(S,Se)4 and Mo electrode10.1016/j.jallcom.2022.165056 ↗
56. Roughness-controlled Cu2ZnSn(S,Se)4 thin-film solar cells with reduced charge recombination10.1021/acsami.9b05852 ↗
57. Wearable perovskite solar cells by aligned liquid crystal elastomers10.1038/s41467-023-36938-7 ↗