journal article·2021-09

Chemical tailoring of sodium content for optimization of interfacial band bending and alignment in flexible kesterite solar cells

Ha Kyung Park, Yunae Cho, Juran Kim, Gee Yeong Kim, Woo-Lim Jeong, Kyung-Pil Kim, Dong-Seon Lee, William Jo

Publisher page

Abstract

Abstract In this study, highly efficient and flexible Na-doped kesterite Cu2ZnSn(S,Se)4 (CZTSSe) thin-film solar cells with an efficiency of over 8% were developed. A CZTSSe thin film was deposited on a flexible Mo foil using metal precursors with varying thickness of the NaF layers on the CZTSSe thin film. The sample maintained 92.2% of its performance after 1000 bending cycles with a bending radius of 12 mm. To investigate defect passivation effect of Na doping through the electrical properties of Na-passivated grain boundaries (GBs), the cells were examined by scanning probe microscopy. Downward band bending was observed at GBs in the Na-sufficient CZTSSe absorber layers; that is, Na enhanced the potential barrier at the CZTSSe GBs in the solar cells and the separation of carriers. The carrier separation increased under illuminated condition. Moreover, the surface photovoltage (SPV) of the cells was measured at laser wavelengths of 405, 532, and 640 nm using photo-assisted Kelvin probe force microscopy to investigate the photogenerated carrier transport in Na-passivated CZTSSe solar cells. The Na content strongly affected the photo-induced changes in the carrier behavior. A cell with a sufficiently Na-doped CZTSSe absorber layer exhibited a large SPV with a maximum value of 46 meV under illumination, whereas Na-deficient samples showed a lower SPV, indicating that Na passivates defects that act as recombination sites. A photo-induced defect passivation effect was observed in a cell with optimal Na content under 405 nm wavelength illuminated condition, which resulted in charge accumulation at the absorber surface.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (75)

Show source-provided references
1. Kesterites-a challenging material for solar cells10.1002/pip.2156 ↗
2. Towards sustainable materials for solar energy conversion: preparation and photoelectrochemical characterization of Cu2ZnSnS410.1016/j.elecom.2008.02.008 ↗
3. Optical properties of high quality Cu2ZnSnSe4 thin films10.1063/1.3624827 ↗
4. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency10.1002/aenm.201301465 ↗
5. Cd-free Cu(in,Ga)(Se,S)2 thin-film solar cell with record efficiency of 23.35%10.1109/JPHOTOV.2019.2937218 ↗
6. Record efficiency for thin-film polycrystalline solar cells up to 22.9% achieved by Cs-treated Cu(in,Ga)(Se,S)210.1109/JPHOTOV.2018.2882206 ↗
7. Why are kesterite solar cells not 20% efficient?10.1016/j.tsf.2012.12.089 ↗
8. Beyond 11% efficiency: characteristics of state-of-the-art Cu2ZnSn(S,Se)4 solar cells10.1002/aenm.201200348 ↗
9. Potassium-induced surface modification of Cu(In,Ga)Se2 thin films for high-efficiency solar cells10.1038/nmat3789 ↗
10. Electrodeposition of CIGS on metal substrates10.1557/PROC-763-B8.5 ↗
11. Enhancement of output performance of Cu2ZnSnS4 thin film solar cells—a numerical simulation approach and comparison to experiments10.1016/j.physb.2012.07.042 ↗
12. Diffusion barriers for CIGS solar cells on metallic substrates10.1016/S0040-6090(03)00259-1 ↗
13. Improving efficiencies of Cu2ZnSnS4 nanoparticle based solar cells on flexible glass substrates10.1016/j.tsf.2017.09.009 ↗
14. Performance improvement of flexible CZTSSe thin film solar cell by adding a Ge buffer layer10.1016/j.matlet.2016.12.106 ↗
15. Earth-abundant and low-cost CZTS solar cell on flexible molybdenum foil10.1039/C4RA02064B ↗
16. High flexible Cu2ZnSn(S,Se)4 solar cells by green solution-process10.1016/j.solener.2018.11.030 ↗
17. 8% efficiency Cu2ZnSn(S,Se)4 (CZTSSe) thin film solar cells on flexible and lightweight molybdenum foil substrates10.1021/acsami.9b03195 ↗
18. Flexible Cu2ZnSn(S,Se)4 solar cells with over 10% efficiency and methods of enlarging the cell area10.1038/s41467-019-10890-x ↗
19. The impact of sodium on the sub-bandgap states in CZTSe and CZTS10.1063/1.4916635 ↗
20. Grain size and texture of Cu2ZnSnS4 thin films synthesized by cosputtering binary sulfides and annealing: effects of processing conditions and sodium10.1007/s11664-011-1729-3 ↗
21. Effect of sodium diffusion on the structural and electrical properties of Cu2ZnSnS4 thin films10.1016/j.solmat.2010.12.012 ↗
22. Effects of sodium incorporation in Co-evaporated Cu2ZnSnSe4 thin-film solar cells, Appl
23. Sodium assisted sintering of chalcogenides and its application to solution processed Cu2ZnSn(S,Se)4 thin film solar cells10.1021/cm403504u ↗
24. Post-deposition treatment of Cu2ZnSnSe4 with alkalis10.1016/j.tsf.2016.11.021 ↗
25. The alterations of carrier separation in kesterite solar cells10.1016/j.nanoen.2018.07.039 ↗
26. Strategic review of secondary phases, defects and defect-complexes in kesterite CZTS–Se solar cells10.1039/C5EE02153G ↗
27. The role of sodium as a surfactant and suppressor of non‐radiative recombination at internal surfaces in Cu2ZnSnS410.1002/aenm.201400849 ↗
28. Sodium induced grain growth, defect passivation and enhancement in the photovoltaic properties of Cu2ZnSnS4 thin film solar cell10.1016/j.matchemphys.2016.04.030 ↗
29. First-principles study on alkali-metal effect of Li, Na, and K in Cu2ZnSnS4 and Cu2ZnSnSe410.1002/pssc.201400345 ↗
30. Bifacial sodium-incorporated treatments: tailoring deep traps and enhancing carrier transport properties in Cu2ZnSnS4 solar cells10.1016/j.nanoen.2015.07.022 ↗
31. Flexible high-efficiency CZTSSe solar cells on diverse flexible substrates via an adhesive-bonding transfer method10.1021/acsami.9b19909 ↗
32. Hydrophilic Cu2ZnSnS4 nanocrystals for printing flexible, low-cost and environmentally friendly solar cells10.1039/c2ce06552e ↗
33. Flexible kesterite Cu2ZnSnS4 solar cells with sodium-doped molybdenum back contacts on stainless steel substrates10.1016/j.solmat.2018.02.036 ↗
34. Influence of sodium incorporation on kesterite Cu2ZnSnS4 solar cells fabricated on stainless steel substrates10.1016/j.solmat.2016.07.036 ↗
35. Alkali doping strategies for flexible and light-weight Cu2ZnSnSe4 solar cells10.1039/C5TA09640E ↗
36. Earth-abundant absorber based solar cells onto low weight stainless steel substrate10.1016/j.solmat.2014.07.030 ↗
37. Fabrication of Cu2ZnSnS4 screen printed layers for solar cells10.1016/j.solmat.2010.06.010 ↗
38. Impact of Na doping on the carrier transport path in polycrystalline flexible Cu2ZnSn(S,Se)4 solar cells10.1002/advs.201903085 ↗
39. Effects of Cu2−xS phase removal on surface potential of Cu2ZnSnS4 thin-films grown by electroplating10.1016/j.cap.2014.09.009 ↗
40. Investigation on limiting factors affecting Cu2ZnGeSe4 efficiency: effect of annealing conditions and surface treatment10.1016/j.solmat.2020.110701 ↗
41. Chemical instability at chalcogenide surfaces impacts chalcopyrite devices well beyond the surface10.1038/s41467-020-17434-8 ↗
42. The electrical properties of polycrystalline silicon films10.1063/1.321593 ↗
43. Investigating the role of grain boundaries in CZTS and CZTSSe thin film solar cells with scanning probe microscopy10.1002/adma.201103470 ↗
44. Direct evidence for a reduced density of deep level defects at grain boundaries of Cu(In,Ga)Se2 thin films10.1103/PhysRevLett.105.116802 ↗
45. Does the local built-in potential on grain boundaries of Cu(In,Ga)Se2 thin films benefit photovoltaic performance of the device?10.1063/1.1793346 ↗
46. Local built-in potential on grain boundary of Cu(In,Ga)Se2 thin films10.1063/1.1737796 ↗
47. Electrically benign behavior of grain boundaries in polycrystalline CuInSe2 films10.1103/PhysRevLett.99.235504 ↗
48. Effects of sodium on electrical properties in Cu2ZnSnS4 single crystal10.1063/1.4871208 ↗
49. Sodium-assisted passivation of grain boundaries and defects in Cu2ZnSnSe4 thin films10.1039/C9CP06537G ↗
50. Enhancement of photo‐conversion efficiency in Cu2ZnSn(S,Se)4 thin‐film solar cells by control of ZnS precursor‐layer thickness10.1002/pip.2693 ↗
51. The state and future prospects of kesterite photovoltaics10.1039/c3ee41781f ↗
52. Point defect engineering in thin-film solar cells10.1038/s41578-018-0026-7 ↗
53. Engineering grain boundaries in Cu2ZnSnSe4 for better cell performance: a first-principle study10.1002/aenm.201300712 ↗
54. Fabrication of Cu2ZnSnS4 solar cells with 5.1% efficiency via thermal decomposition and reaction using a non-toxic sol–gel route10.1039/C3TA13533K ↗
55. Sodium passivation of the grain boundaries in CuInSe2 and Cu2ZnSnS4 for high-efficiency solar cells10.1002/aenm.201601457 ↗
56. Na-doping-induced modification of the CuZnSn(S,Se)/CdS heterojunction towards efficient solar cells
57. An investigation of Na-related defects in Cu2ZnSnSe410.1039/C7CP02192E ↗
58. Identifying a doping type of semiconductor nanowires by photoassisted kelvin probe force microscopy as exemplified for GaN nanowires10.1364/OME.7.000904 ↗
59. Red-blue effect in Cu(In,Ga)Se2-based devices revisited10.1016/j.tsf.2012.11.040 ↗
60. CIGS J–V distortion in the absence of blue photons10.1016/j.tsf.2004.11.099 ↗
61. Photon-induced defects and dynamics of photogenerated carriers in Cu(In,Ga)Se2 thin film solar cells10.1016/j.solmat.2020.110860 ↗
62. Surface photovoltage spectroscopy—a new approach to the study of high-gap semiconductor surfaces10.1116/1.1317922 ↗
63. Surface photovoltage phenomena: theory, experiment, and applications10.1016/S0167-5729(99)00002-3 ↗
64. Sodium distribution in solar-grade Cu2ZnSnS4 layers using atom-probe tomographic technique10.7567/JJAP.54.112302 ↗
65. Effects of Na and MoS2 on Cu2ZnSnS4 thin‐film solar cell10.1002/pip.2500 ↗
66. Na‐induced effects on the electronic structure and composition of Cu(In,Ga)Se2 thin‐film surfaces10.1063/1.115783 ↗
67. VESTA 3 for three-dimensional visualization of crystal, volumetric and morphology data10.1107/S0021889811038970 ↗
68. Surface photovoltage spectroscopy of thin films10.1063/1.362535 ↗
69. Band bending in semiconductors: chemical and physical consequences at surfaces and interfaces10.1021/cr3000626 ↗
70. Surface photovoltage spectroscopy of semiconductor structures: at the crossroads of physics, chemistry and electrical engineering10.1002/sia.1132 ↗
71. Photo-assisted Kelvin probe force microscopy investigation of three dimensional GaN structures with various crystal facets, doping types, and wavelengths of illumination
72. Application of multi-buffer layer of (Zn,Mg)O/CdS in Cu2ZnSn(S,Se)4 solar cells10.1016/j.cap.2015.01.011 ↗
73. Point defects, compositional fluctuations, and secondary phases in non-stoichiometric kesterites10.1088/2515-7655/ab4a25 ↗
74. The role of sulfur in solution-processed Cu2ZnSn(S,Se)4 and its effect on defect properties10.1002/adfm.201201732 ↗
75. Generalized current-voltage analysis and efficiency limitations in non-ideal solar cells: case of Cu2ZnSn(SxSe1-x)4 and Cu2Zn(SnyGe1-y)(SxSe1-x)410.1063/1.4882119 ↗