journal article·2015-01

Influence of laser damage on the performance of selective emitter solar cell fabricated using laser doping process

Myungsu Kim, Donghwan Kim, Dongseop Kim, Yoonmook Kang

Publisher page

Abstract

Abstract This article investigates the impact of laser damage on the performance of a selective emitter solar cell fabricated using a laser doping process (LD). After the optimization of the laser doping process, an amorphous silicon layer with a thickness of approximately 100 A was observed on the laser-doped emitter. The amorphous laser damage decreased the power conversion efficiency due to poor contact between the Ag front electrode and the selective emitter. To effectively improve the quality of the front contacts, a solution etch-back process was applied after the laser doping step (LEB), and the series resistance of the selective emitter solar cell was restored to 0.55 Ω cm2 from around 1.0 Ω cm2. The contact formation during the LEB process clearly improved, and it was verified by comparing the densities of the Ag crystallites after Ag electrode removal from the LEB cell and the LD cell. The improvement in the formation of the front contact resulted in the LEB selective emitter solar cell recording a maximum 19.16% of power conversion efficiency, with a standard deviation of 0.055.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies · Laser Material Processing Techniques

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (20)

Show source-provided references
1. V. Meemongkolkiat, High Efficiency Monocrystalline Si Solar Cells Through Improved Optical and Electrical Confinement, Center of Excellence for Photovoltaic Research and Education, Georgia Institute of Technology, 2008.
2. Thermal oxidation for crystalline silicon solar cells exceeding 19% efficiency applying industrially feasible process technology10.1002/pip.814 ↗
3. Back-contact solar cells: a review10.1002/pip.657 ↗
4. 24% efficient silicon solar cells10.1063/1.103610 ↗
5. M.M. Hilali, A. Rohatgi, A review and understanding of screen-printed contacts and selective-emitter formation, in: 14th Workshop on Crystalline Silicon Solar Cells, NREL, 2004.
6. High-throughput ion-implantation for low-cost high-efficiency silicon solar cells10.1016/j.egypro.2012.02.002 ↗
7. Selective emitter formation with a single screen-printed p-doped paste deposition using out-diffusion in an RTP-step10.1016/S0927-0248(02)00050-8 ↗
8. Silicon ink selective emitter progress: optimization of selective diffusied regions for short wavelength response
9. F. Book et al., Two diffusion step selective emitter: comparison of mask opening by laser or etching paste, in: Proceeding of the 23rd EVPVSEC, Valencia, Spain, 2008.
10. D. Ruby et al., Recent progress on the self-aligned selective-emitter silicon solar cell, in: Proceeding of the 26th IEEE PVSC, Anaheim, CA, USA, 1997.
11. Selective emitters for screen printed multicrystalline silicon solar cells
12. A. Dastghaib-Shirazi et al., Selective emitter for industrial solar cell production: a wet chemical approach using a single side diffusion process, in: Proceeding of the 23rd EUPVSEC, Valencia, Spain, 2008.
13. D. Meier et al., Self-doping contacts to silicon using silver coated with a dopant source, in: Proceeding of the 28th IEEE, PVSC, Anchorage, AL, USA, 2000.
14. J. Horzel et al., Novel method to form selective emitters in one diffusion step without etching or masking, in: Proceeding of the 14th EUPVSEC, Barcelona, Spain, 1997.
15. Investigation of ablation mechanisms for selective laser ablation of silicon nitride layers10.1016/j.egypro.2011.06.188 ↗
16. Laser ablation of silicon dioxide on silicon using femtosecond near infrared laser pulses10.1016/j.egypro.2011.06.167 ↗
17. M.O. Ulrich Jager, M. Hortheis, A. Crohe, R. Preu, Selective emitter by laser doping from phosphosilicate glass, in: Proceeding of the 24th EUPVSEC, Germany, Hamburg, 2009.
18. Abnormal dopant distribution in-diffused emitter of textured silicon solar cells10.1109/LED.2010.2098840 ↗
19. H. Wagner et al., Analyzing emitter dopant inhomogeneities at textured Si surfaces by using 3D process and device simulations in combination with SEM imaging, in: Proceeding of the 38th IEEE Photovoltaics Specialist Conference, U.S., Austin, 2012.10.1109/PVSC.2012.6317625 ↗
20. U. Jager et al., Beam shaping for high throughput laser doped selective emitter solar cells, in: Proceeding of the 26th EU PVSEC, Germany, Hamburg, 2011.