Insertion of the AGS layer at the CIGSe/ITO interface: A way to reduce the formation of the GaOx interfacial phase in CIGSe solar cells
Source abstract
Abstract
Abstract Semitransparent (ST) Cu(In,Ga)Se2 (CIGSe) solar cells based on the ultrathin absorbers with a bandgap of ~1.5 eV are prepared on the tin-doped indium oxide (ITO) back electrode. In a solar cell with absorber thickness ≤300 nm, incorporation of a sulfurized-AgGa (AGS) layer between the CIGSe layer and the ITO back contact was found to improve the device efficiency. This article explores the effect of the AGS layer on the CIGSe structure and CIGSe/ITO interface. Meanwhile, an ordered defect compound formation is observed in the AGS interlayered-CIGSe absorbers, the origin of which is the decrease in the (Ag+Cu)/(Ga+In) ratio arising from diffusion of In from the ITO to the absorber and the Ag/Ga ratio of 0.60 in the AGS layer. It is found that the AGS layer can significantly reduce the formation of the GaOx phase at the CIGSe/ITO interface. However, the increase in the deposition time of the CIGSe layer in the AGS interlayered-absorbers resulted in an increase in the GaOx interfacial (IF) layer thickness. The roll-over phenomenon in the illuminated J-V curves of devices based on AGS interlayered-absorbers became increasingly pronounced when the thickness of GaOx IF layer increased. The SCAPS (solar cell capacitance simulator) simulation results indicate that the reason for the roll-over effect in the illuminated J-V curves of the solar cells with AGS layers is the GaOx IF phase (n-type in nature). In light of the present results, possibilities to further enhance the conversion efficiency of ST CIGSe solar cells are also discussed.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Semiconductor materials and interfaces · Quantum Dots Synthesis And Properties
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (35)
Show source-provided references
1. A Review of Solar Photovoltaic Levelized Cost of Electricity10.1016/j.rser.2011.07.104 ↗
2. Comprehensive review on material requirements, present status, and future prospects for building-integrated semitransparent photovoltaics (BISTPV)10.1039/C6TA01016D ↗
3. Alternative device structures for CIGS-based solar cells with semi-transparent absorbers10.1016/j.nanoen.2016.10.038 ↗
4. Printable, wide band-gap chalcopyrite thin films for power generating window applications10.1038/srep04408 ↗
5. Development of semitransparent CIGS thin-film solar cells modified with a sulfurized-agga layer for building applications10.1039/C6TA01909A ↗
6. Improved Performance of Ultrathin Cu(InGa)Se2 Solar Cells with a Backwall Superstrate Configuration10.1109/JPHOTOV.2014.2345436 ↗
7. Modelling polycrystalline semiconductor solar cells10.1016/S0040-6090(99)00825-1 ↗
8. The Role of Sulfur Alloying in Defects and Transitions in Copper Indium Gallium Diselenide DisulfideThin Films
9. The interfacial reaction at ITO back contact in kesterite CZTSSe bifacial solar cells10.1021/acssuschemeng.5b00962 ↗
10. High efficiency bifacial Cu2ZnSnSe4 thin-film solar cells on transparent conducting oxide glass substrates10.1063/1.4962145 ↗
11. Characteristics of in-substituted CZTS thin film and bifacial solar cell10.1021/am505980n ↗
12. Deposition and characterization of graded Cu(In1-xGax)Se2 thin films by spray pyrolysis10.1016/j.matchemphys.2015.05.001 ↗
13. Structural properties of chalcopyrite thin films studied by raman spectroscopy10.1002/pssb.200541132 ↗
14. Epitaxial growth and characterization of CuInSe2 crystallographic polytypes10.1063/1.1446234 ↗
15. Structural analysis of CIGS film prepared by chemical spray deposition10.1016/j.cap.2010.11.089 ↗
16. Preparation and characterization of silver-doped Cu(In,Ga)Se2 films via nonvacuum solution process10.1111/jace.14339 ↗
17. Impact of electronic defects on the raman spectra from electrodeposited Cu(In,Ga)Se2 solar cells: application for non-destructive defect assessment10.1063/1.4793418 ↗
18. Advanced diagnostic and control methods of processes and layers in CIGS solar cells and modules10.1002/pip.966 ↗
19. Single-step electrodeposition of a microcrystalline Cu2ZnSnSe4 thin film with a kesterite structure10.1016/j.electacta.2012.10.076 ↗
20. Cu(InGa)Se2 thin film absorber with high Ga contents and its application to the solar Cells10.1016/S0022-3697(03)00204-X ↗
21. The effect of Cu concentration in the photovoltaic efficiency of CIGS solar cells prepared by co-evaporation technique10.1016/j.vacuum.2016.07.008 ↗
22. Raman spectra of the ordered vacancy compounds CuIn3Se5 and CuGa3Se510.1063/1.121893 ↗
23. Effects of substrates on structural and optical properties of Cu-poor CuGaSe2 thin films prepared by in-situ Co-evaporation10.1016/j.cap.2013.01.044 ↗
24. Structural and optical properties of (Ag,Cu)(In,Ga)Se2 polycrystalline thin film alloys10.1063/1.4880243 ↗
25. Effect of Ni thin film on the reflectivity of ITO/Ag mirrors of GaN light-emitting diodes10.1149/1.2977761 ↗
26. Electrical properties of the Cu(In,Ga)Se2/ MoSe2/Mo structure10.1016/S0927-0248(00)00283-X ↗
27. Formation of Ga2O3 barrier layer in Cu(InGa)Se2 superstrate devices with ZnO buffer layer10.1557/opl.2013.1007 ↗
28. Ga2O3 segregation in Cu(In, Ga)Se2/ZnO superstrate solar cells and its impact on their photovoltaic properties10.1016/S0040-6090(01)01526-7 ↗
29. Characteristics of Ga-Rich Cu(In, Ga)Se2 solar cells grown on Ga-Doped ZnO back contact10.1166/jnn.2016.12545 ↗
30. 19·9%-efficient ZnO/CdS/CuInGaSe2 Solar Cell with 81·2% Fill Factor10.1002/pip.822 ↗
31. Cu(In,Ga)Se2 superstrate solar cells: prospects and limitations10.1002/pip.2536 ↗
32. Heinemann · 2016
33. M. Contreras, L. Mansfield, B. Egaas, J. Li, M. Romero, R. Noufi, Improved Energy Conversion Efficiency in Wide-Bandgap Cu(In,Ga)Se2 Solar Cells, in: 37th IEEE Photovolt. Specialists Conference, IEEE, Seattle, Washington, 2011.10.1109/PVSC.2011.6185837 ↗
34. Thin-film solar cells: device measurements and analysis10.1002/pip.518 ↗
35. An investigation into the effects of band gap and doping concentration on Cu(In,Ga)Se2 solar cell efficiency10.1186/s40064-016-2256-8 ↗