Microstructural improvement of solar salt based MgO composites through surface tension/wettability modification with SiO2 nanoparticles
Source abstract
Abstract
Composite phase change materials (CPMCs) are of particular interest in high-temperature thermal energy storage and waste heat utilization applications. To further enhance their thermal conductivity, CPCMs are often doped with nanosized particles (NPs). However, NP`s influence the PCM`s viscosity and wettability, significantly contributing to the CPCM`s microstructure. Their effects on the PCM`s viscosity have been extensively documented, but little has been done on its effect on wettability. To this end, we investigated, using a custom maximum bubble pressure tensiometer, the surface tension of the solar salt, as well as its contact angle on an MgO {1 0 0} surface with various concentrations of α-SiO 2 NPs. At 0.5 wt%, an increase of 2.45% on the surface tension is observed, scaling up to 11.8% at 2.5 wt%. Contrary to the pure salt, in the presence of SiO 2 the surface tension increases up to 400 °C followed by rapid decay, which is found to be related to NP agglomeration and subsequent sedimentation. In terms of contact angle NP addition leads to an increase at the melting point, but fully wetting conditions are attained at 390 °C independent of α-SiO 2 content. To capitalize on this effect, MgO-Solar salt CPCMs without and with 1.0 wt % SiO 2 are kept at 390 °C for 5 h. Silica addition leads to smaller leakage (mass loss), improved density (by 8.9%), improved porosity (by 18.9%), mean pore size reduction (by 100%) and enhanced thermal diffusivity (by 6.5%). This is suggested to be indirectly related to the surface tension/wettability modification through doping with polar NPs.
Source: expertdata · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Phase Change Materials Research · Adsorption and Cooling Systems · Solar-Powered Water Purification Methods
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (71)
Show source-provided references
1. Solar thermal energy technologies and its applications for process heating and power generation – a review
2. Review on sensible thermal energy storage for industrial solar applications and sustainability aspects10.1016/j.solener.2020.08.081 ↗
3. The current state of Distributed Renewable Generation, challenges of interconnection and opportunities for energy conversion based DC microgrids10.1016/j.jclepro.2020.122777 ↗
4. Waste Heat Recovery in the EU industry and proposed new technologies10.1016/j.egypro.2019.02.064 ↗
5. Latent heat thermal energy storage: a bibliometric analysis explicating the paradigm from 2000–201910.1016/j.est.2020.102027 ↗
6. Review on shell materials used in the encapsulation of phase change materials for high temperature thermal energy storage10.1016/j.rser.2015.03.038 ↗
7. Towards higher energy efficiency in future waste-to-energy plants with novel latent heat storage-based thermal buffer system10.1016/j.rser.2019.05.009 ↗
8. Skeleton materials for shape-stabilization of high temperature salts based phase change materials: a critical review10.1016/j.rser.2019.109539 ↗
9. Preparation and thermal properties of novel eutectic salt/nano-SiO2/expanded graphite composite for thermal energy storage10.1016/j.solmat.2020.110590 ↗
10. Effect of SiO 2 on the thermal stability of carbonate/MgO composite for thermal energy storage10.1088/1757-899X/504/1/012011 ↗
11. Multi-walled carbon nanotubes added to Na2CO3/MgO composites for thermal energy storage10.1016/j.partic.2013.05.001 ↗
12. Solidification of phase change materials infiltrated in porous media in presence of voids10.1115/1.4028354 ↗
13. Effect of Marangoni Convection on Solidification of phase change materials infiltrated in porous media in presence of voids
14. Experimental study on the phase change behavior of phase change material confined in pores10.1016/j.solener.2006.08.010 ↗
15. The dynamics of capillary flow10.1103/PhysRev.17.273 ↗
16. 2008
17. Capillary number correlations for gas-liquid systems10.2118/07-02-03 ↗
18. Carbonate salt based composite phase change materials for medium and high temperature thermal energy storage: a microstructural study10.1016/j.solmat.2019.03.035 ↗
19. Molten salt-based nanofluids as efficient heat transfer and storage materials at high temperatures. An overview of the literature10.1016/j.rser.2017.10.080 ↗
20. Effect of SiO2 nanoparticle addition on the wetting and rheological properties of solar salt10.1016/j.solmat.2020.110483 ↗
21. Unexpected effect of nanoparticles doping on the corrosivity of molten nitrate salt for thermal energy storage10.1016/j.solmat.2018.01.002 ↗
22. Contact angle, wettability and adhesion10.1016/0143-7496(94)90024-8 ↗
23. Why is surface tension a force parallel to the interface?10.1119/1.3619866 ↗
24. Composite materials for thermal energy storage: enhancing performance through microstructures10.1002/cssc.201300878 ↗
25. The surface tension of molten salts10.1070/RC1966v035n07ABEH001491 ↗
26. Molten salt mixtures. Part 3.—Vapour pressure and derived information for the molten salt systems PbCl 2 + KCl, CdCl 2 + KCl and CdCl 2 + NaCl10.1039/TF9595501792 ↗
27. The surface tensions and their temperature coefficients of molten mixtures of potassium chloride and barium chloride10.1021/ja01639a016 ↗
28. Theory of the surface tension of molten salts10.1063/1.1731809 ↗
29. Molten salts as Blanket fluids in Controlled Fusion Reactors
30. Molten salts: Volume 4, Part 1, Fluorides and mixtures electrical conductance, density, viscosity, and surface tension data10.1063/1.3253134 ↗
31. Molten salts: Volume 4, part 2, chlorides and mixtures—electrical conductance, density, viscosity, and surface tension data10.1063/1.555527 ↗
32. Molten salts: Volume 3 nitrates, nitrites, and mixtures: electrical conductance, density, viscosity, and surface tension data10.1063/1.3253103 ↗
33. Molten salts data as reference standards for density, surface tension, viscosity, and electrical conductance: KNO3 and NaCl10.1063/1.555634 ↗
34. Preparation and investigation on density and surface tension of quaternary bromides for concentrating solar power10.1016/j.solmat.2016.07.016 ↗
35. Evaluation of surface tension for the NaNO3-KNO3-Ca(NO3)2 system and its sub-system
36. Current trends in surface tension and wetting behavior of nanofluids10.1016/j.rser.2018.07.006 ↗
37. Preparation and characterization of molten salt based nanothermic fluids with enhanced thermal properties for solar thermal applications10.1016/j.applthermaleng.2016.04.102 ↗
38. A review on preparation methods, stability and applications of hybrid nanofluids10.1016/j.rser.2017.05.221 ↗
39. Physical properties data compilations relevant to energy storage, 2. Molten salts: data on single and multi-component salt systems
40. Effect of surface tension on nanotube nanofluids10.1063/1.3085766 ↗
41. The maximum bubble pressure method of measuring surface tension, revisited10.1016/0166-6622(90)80291-B ↗
42. Maximum bubble pressure tensiometry - an analysis of experimental constraints
43. Application of the maximum bubble pressure technique for dynamic surface tension studies of surfactant solutions using the Sugden two-capillary method10.1016/j.jcis.2006.08.023 ↗
44. The effect of capillary characteristics on the results of dynamic surface tension measurements using the maximum bubble pressure method10.1016/S0927-7757(97)00231-8 ↗
45. Critical assessment of the surface tension determined by the maximum pressure bubble method10.1590/1516-1439.232513 ↗
46. Development of maximum bubble pressure method for surface tension measurement of high viscosity molten silicate10.1007/s10765-017-2249-z ↗
47. Corrosion Inhibition/Foamer Combination Treatment to Enhance gas Production
48. Surface-tension effects in suspended-level capillary viscometers10.1007/BF00503516 ↗
49. Effects of interplay of nanoparticles, surfactants and base fluid on the surface tension of nanocolloids10.1140/epje/i2017-11541-5 ↗
50. Adsorption of colloidal particles to curved interfaces10.1063/1.2216697 ↗
51. The effect of nanoparticles on the liquid–gas surface tension of Bi 2 Te 3 nanofluids10.1088/0957-4484/20/18/185702 ↗
52. Nanoparticles in ionic liquids: interactions and organization10.1039/C5CP01620G ↗
53. High-temperature heterogeneous catalysis in platinum nanoparticle – molten salt suspensions10.1039/C9CY01823A ↗
54. Effect of temperature on the internal structure of solar salt-SiO210.1063/1.5117718 ↗
55. Effect of surface charge density on the affinity of oxide nanoparticles for the vapor–water interface10.1021/la4005054 ↗
56. Brillo
57. Experimental and theoretical studies of the colloidal stability of nanoparticles−A general interpretation based on stability maps10.1021/nn200465b ↗
58. Multi-scale approach for modeling stability, aggregation, and network formation of nanoparticles suspended in aqueous solutions10.1039/C8NR08782B ↗
59. Effect of nanoparticles on the interfacial properties of liquid/liquid and liquid/air surface layers10.1021/jp0636468 ↗
60. The influence of negatively charged silica nanoparticles on the surface properties of anionic surfactants: electrostatic repulsion or the effect of ionic strength?10.1039/C9CP05475H ↗
61. Dynamics of an initially spherical bubble rising in quiescent liquid10.1038/ncomms7268 ↗
62. Bubble shape and rising velocity in viscous liquids at high temperature and pressure10.1016/j.expthermflusci.2018.12.018 ↗
63. Density, surface tension, and electrical conductivity of ternary molten carbonate system Li[sub 2]CO[sub 3]–Na[sub 2]CO[sub 3]–K[sub 2]CO[sub 3] and methods for their estimation10.1149/1.2917212 ↗
64. A simple experiment for measuring the surface tension of soap solutions10.1119/1.1365402 ↗
65. Determination of surface tension from the measurement of internal pressure of mini soap bubbles10.1119/1.3623414 ↗
66. Wetting: statics and dynamics10.1103/RevModPhys.57.827 ↗
67. Thermal properties and thermal conductivity enhancement of composite phase change materials using myristyl alcohol/metal foam for solar thermal storage10.1016/j.solmat.2017.05.059 ↗
68. Synergetic enhancement of heat storage density and heat transport ability of phase change materials inlaid in 3D hierarchical ceramics10.1016/j.apenergy.2021.117995 ↗
69. Form-stable ternary carbonates/MgO composite material for high temperature thermal energy storage10.1016/j.solener.2019.01.002 ↗
70. Measurement of volumetric thermal expansion coefficient of various nanofluids10.1134/S1063785010080055 ↗
71. Rheological analysis of nitrate molten salts with suspended particles for solar thermal plants10.1016/j.molliq.2020.112903 ↗