journal article·2021-04Open access

Effective module level encapsulation of CIGS solar cells with Al2O3 thin film grown by atomic layer deposition

Shan-Ting Zhang, Maxim Guc, Oliver Salomon, Roland Wuerz, Victor Izquierdo-Roca, Alejandro Pérez-Rodríguez, Friedrich Kessler, Wolfram Hempel, Thibaud Hildebrandt, Nathanaelle Schneider

Abstract

Abstract An effective encapsulation solution for flexible CIGS is urgently needed to ensure a competitive market entry of the technology. In this work, we demonstrate the feasibility to effectively encapsulate module-level (10 × 10 cm2) CIGS/glass solar cells by employing a thin Al2O3 barrier layer grown by atomic layer deposition (ALD). As determined by a direct methodology, 10 nm ALD-Al2O3 is proved to be sufficient in preventing electrical degradation of the Al:ZnO (AZO) window layer upon exposure to damp heat test (DHT) and equally effective to encapsulate 10 × 10 cm2 CIGS/glass mini-modules by efficient blockage of moisture ingress. CIGS mini-modules encapsulated by ALD-Al2O3 barrier layer retain an average of 80% and 72% of initial efficiency after 1000 and 2000 h of DHT, respectively. Whereas unencapsulated modules drop to an average of 67% (1000 h DHT) and 22% (2000 h DHT) of initial efficiency. Thanks to the presence of ALD-Al2O3 barrier layer, less electrical degradation occurred in AZO window layer and P3 interconnection; also less shunting paths appeared – both led to a lower FF drop in encapsulated CIGS mini-modules. However, an issue of Na migration out of the CIGS layer is observed, which negatively impacts the module stability during DHT.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Semiconductor materials and devices · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (51)

Show source-provided references
1. Flexible CIGS, CdTe and a-Si:H based thin film solar cells: a review
2. Flexible solar cells10.1002/cssc.200800127 ↗
3. BIPV: merging the photovoltaic with the construction industry10.1002/pip.920 ↗
4. Study on the incorporation of photovoltaic systems as an auxiliary power source for hybrid and electric vehicles10.1016/j.solener.2011.10.019 ↗
5. Advanced alkali treatments for high‐efficiency Cu(in,Ga)Se2 solar cells on flexible substrates10.1002/aenm.201900408 ↗
6. International Electrotechnical Commission IEC · 2016 · 61215–2
7. Polymeric materials for long-term durability of photovoltaic systems10.1002/app.43080 ↗
8. Acetic acid production and glass transition concerns with ethylene-vinyl acetate used in photovoltaic devices10.1016/j.solmat.2006.10.009 ↗
9. Degradation behaviors of EVA encapsulant and AZO films in Cu(In,Ga)Se2 photovoltaic modules under accelerated damp heat exposure10.1016/j.solmat.2014.12.036 ↗
10. Failure analysis of Cu(In,Ga)Se2 photovoltaic modules: degradation mechanism of Cu(In,Ga)Se2 solar cells under harsh environmental conditions: failure analysis of CIGS photovoltaic modules10.1002/pip.2497 ↗
11. Encapsulation of PV modules using ethylene vinyl acetate copolymer as a pottant: a critical review10.1016/0927-0248(95)00150-6 ↗
12. Recent progress on thin-film encapsulation technologies for organic electronic devices10.1016/j.optcom.2015.08.021 ↗
13. Growth of thin barrier films on flexible polymer substrates by atomic layer deposition10.1016/j.tsf.2016.12.055 ↗
14. Ultra-thin alumina layer encapsulation of bulk heterojunction organic photovoltaics for enhanced device lifetime10.1016/j.orgel.2013.10.014 ↗
15. Scratch resistance and durability enhancement of bulk heterojunction organic photovoltaics using ultra-thin alumina layers10.1016/j.solmat.2014.05.006 ↗
16. The use of feature parameters to asses barrier properties of ALD coatings for flexible PV substrates10.1088/1742-6596/483/1/012011 ↗
17. Atomic layer deposition: an overview10.1021/cr900056b ↗
18. Low-temperature Al2O3 atomic layer deposition10.1021/cm0304546 ↗
19. Versatile perovskite solar cell encapsulation by low-temperature ALD-Al2O3 with long-term stability improvement10.1039/C8SE00282G ↗
20. Ca test of Al2O3 gas diffusion barriers grown by atomic layer deposition on polymers10.1063/1.2221912 ↗
21. Encapsulation of Cu(InGa)Se2 solar cell with Al2O3 thin-film moisture barrier grown by atomic layer deposition10.1016/j.solmat.2010.08.021 ↗
22. ALD moisture barrier for Cu(InGa)Se2 solar cells10.1149/1.3485261 ↗
23. Encapsulation of Cu(InGa)Se2 solar cells with ALD Al2O3 flexible thin-film moisture barrier: stability under 1000 hour damp heat and UV exposure
24. The Zn(S,O,OH)/ZnMgO buffer in thin-film Cu(In,Ga)(Se,S)2-based solar cells part II: magnetron sputtering of the ZnMgO buffer layer for in-line co-evaporated Cu(In,Ga)Se2 solar cells10.1002/pip.897 ↗
25. Impact of the sequence of precursor introduction on the growth and properties of atomic layer deposited Al-doped ZnO films10.1116/1.5030990 ↗
26. Damp-heat treatment effects on sputtered Al-doped ZnO films
27. Influence of damp heat on the optical and electrical properties of Al-doped zinc oxide10.1016/j.tsf.2008.10.107 ↗
28. Damp heat stability of Al-doped zinc oxide films on smooth and rough substrates10.1016/j.tsf.2011.04.190 ↗
29. Stability of CIS/CIGS modules at the outdoor test facility over two decades
30. Examination of lifetime-limiting failure mechanisms in CIGSS-based PV minimodules under environmental stress
31. Effects of ZnO:Al films on CIGS PV modules degraded under accelerated damp heat10.1016/j.solmat.2012.05.002 ↗
32. In-situ analysis of the degradation of Cu(In, Ga)Se2 solar cells
33. Stability of Cu(In,Ga)Se2 solar cells: a literature review10.1016/j.solener.2016.04.010 ↗
34. Nondestructive Raman scattering assessment of solution-processed ZnO-doped layers for photovoltaic applications10.1021/acs.jpcc.6b11525 ↗
35. Non-destructive assessment of ZnO:Al window layers in advanced Cu(In,Ga)Se 2 photovoltaic technologies: ZnO:Al window layers in advanced Cu(In,Ga)Se2 PV technologies10.1002/pssa.201431222 ↗
36. Coupling of plasmons to polar phonons in degenerate semiconductors10.1103/PhysRev.137.A1896 ↗
37. Raman study of the phonon halfwidths and the phonon—plasmon coupling in ZnO10.1002/pssb.2221190126 ↗
38. Temperature dependence of Raman scattering in ZnO10.1103/PhysRevB.75.165202 ↗
39. Cu(In,Ga)Se2-based thin-film photovoltaic modules optimized for long-term performance10.1016/S0927-0248(02)00101-0 ↗
40. Damp heat stability of chalcopyrite mini-modules: evaluation of specific test structures
41. Damp heat degradation of CIGS-based PV Modules
42. Influence of deposition pressure and selenisation on damp heat degradation of the Cu(In,Ga)Se2 back contact molybdenum10.1016/j.surfcoat.2014.05.001 ↗
43. Applications for infrared imaging equipment in photovoltaic cell, module, and system testing
44. A study on the humidity susceptibility of thin-film CIGS absorber
45. Modelling water vapour permeability through atomic layer deposition coated photovoltaic barrier defects10.1016/j.tsf.2014.08.042 ↗
46. Influence of molybdenum back contact on the PID effect for Cu(in,Ga)Se2 solar cells10.3390/coatings9120794 ↗
47. Sodium in the degradation process of Cu(in,Ga)Se2 solar cells
48. Damp heat treatment of Cu(in,Ga)Se2 solar cells with different sodium content10.3390/ma6125478 ↗
49. Accelerated performance degradation of CIGS solar cell determined by in-situ monitoring
50. Degradation of CIGS solar cells due to the migration of alkali-elements
51. Unveiling the effects of post-deposition treatment with different alkaline elements on the electronic properties of CIGS thin film solar cells10.1039/c4cp00614c ↗