journal article·2011-01

Development of thin film amorphous silicon oxide/microcrystalline silicon double-junction solar cells and their temperature dependence

K. Sriprapha, C. Piromjit, A. Limmanee, J. Sritharathikhun

Publisher page

Abstract

We have developed thin film silicon double-junction solar cells by using micromorph structure. Wide bandgap hydrogenated amorphous silicon oxide (a-SiO:H) film was used as an absorber layer of top cell in order to obtain solar cells with high open circuit voltage (V oc ), which are attractive for the use in high temperature environment. All p, i and n layers were deposited on transparent conductive oxide (TCO) coated glass substrate by a 60 MHz-very-high-frequency plasma enhanced chemical vapor deposition (VHF-PECVD) technique. The p-i-n-p-i-n double-junction solar cells were fabricated by varying the CO 2 and H 2 flow rate of i top layer in order to obtain the wide bandgap with good quality material, which deposited near the phase boundary between a-SiO:H and hydrogenated microcrystalline silicon oxide (μc-SiO:H), where the high V oc can be expected. The typical a-SiO:H/μc-Si:H solar cell showed the highest initial cell efficiency of 10.5%. The temperature coefficient (TC) of solar cells indicated that the values of TC for conversion efficiency (η) of the double-junction solar cells were inversely proportional to the initial V oc , which corresponds to the bandgap of the top cells. The TC for η of typical a-SiO:H/μc-Si:H was -0.32% °C, lower than the value of conventional a-Si:H/μc-Si:H solar cell. Both the a-SiO:H/μc-Si:H solar cell and the conventional solar cell showed the same light induced degradation ratio of about 20%. We concluded that the solar cells using wide bandgap a-SiO:H film in the top cells are promising for the use in high temperature regions.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Thin-Film Transistor Technologies · Silicon and Solar Cell Technologies · Silicon Nanostructures and Photoluminescence

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (9)

Show source-provided references
1. I.A. Yunaz, K. Sriprapha, S. Hiza, A. Yamada, M. Konagai, Optimum design of amorphous silicon solar cells for tropical climate regions, in: Proceedings of Renewable Energy, Chiba, Japan, 2006, pp. 193–196.
2. H. Stiebig, Th. Eickhoff, J. Zimmer, C. Beneking, H. Wagner, Measured and simulated temperature dependence of a-Si:H solar cell parameter, in: Proceedings of MRS California, Vol. 420, 1996, USA, , pp. 855–858.10.1557/PROC-420-855 ↗
3. The influence of operation temperature on the output properties of amorphous silicon-related solar cells10.1016/j.solmat.2004.04.016 ↗
4. Outdoor performance of amorphous silicon and polycrystalline silicon PV module10.1016/S0927-0248(97)00003-2 ↗
5. K. Sriprapha, S. Inthisang, S. Miyajima, A. Yamada, P. Sichanugrist and M. Konagai, Temperature dependence of amorphous silicon oxide thin-film solar cells near phase boundary, in: Proceedings of 23rd EUPVSEC, Valencia, Spain, 2008, pp. 2278–2281.
6. R.E.I. Schropp, J.W.A. Schüttauf, C.H.M. van der Werf, W. Arnoldbik, Oxygenated protocrystalline silicon thin films for wide bandgap solar cell with temperature-insensitive cell performance, in: Proceedings of 23rd EUPVSEC, Valencia, Spain, 2008, pp. 2109-2112.
7. S. Inthisang, K. Sriprapha1, A. Yamada , M. Konagai, Characterization of wide bandgap a-SiO:H films and their application to thin film solar cells, in: Proceedings of 33rd IEEE PVSC, CA, USA, 2008, 4922562.10.1109/PVSC.2008.4922562 ↗
8. Temperature dependence of Si-based thin film solar cells near phase boundary10.1117/12.733451 ↗
9. Theoretical analysis of amorphous silicon alloy based triple junction solar cells10.1143/JJAP.46.L1152 ↗