journal article·2019-03Open access

CrAlSiN barrier layer to improve the thermal stability of W/CrAlSiNx/CrAlSiOyNx/SiAlOx solar thermal absorber

A. AL-Rjoub, L. Rebouta, P. Costa, L.G. Vieira, T.M.R. Miranda, N.P. Barradas, E. Alves

Abstract

The influence of adding CrAlSiN barrier layer between the back-reflector tungsten (W) and stainless-steel substrate on thermal stability has been investigated. In previous work, after the annealing in vacuum at 600 °C, tungsten diffusion from the back-reflection layer towards the stainless-steel substrate was found. In this study, a barrier layer was added and its influence upon the W diffusion was studied. Several designs of multilayer solar selective absorber for high temperature applications were used to test the thermal and chemical stability and oxidation resistance after vacuum annealing. These samples were characterized by Scanning Electron Microscopy (SEM), Rutherford Backscattering Spectrometry (RBS), X-ray diffraction (XRD), Fourier-transform Infrared Spectroscopy (FTIR) and UV–VIS–NIR spectroscopy. All absorber tandems show good thermal stability after vacuum annealing at 600 °C and the changes in optical constants solar absorptance (α) and thermal emittance (ε) are negligible. In some cases, small changes in the reflectance curves after the first step of annealing were seen. Some changes were found in the oxide layer, due to the incomplete oxidized Si atoms, as confirmed by FTIR analyses. This cannot justify the increase of NIR reflectance observed in the optical stacks after annealing, which can be due to the phase changes of the back-reflector tungsten layer. All layers of stacks are amorphous, except the tungsten layer, which is polycrystalline and shows a columnar growth. The addition of a CrAlSiNP = 0.11 Pa barrier layer between tungsten and stainless-steel substrate proved to be a good solution to control the diffusion of W atoms towards the substrate, whereas using higher nitrogen partial pressure in the high and the low absorption layers reduce the diffusion of Cr from those layers to surface.
Source: openalex_inverted_index · Quality: baseline

Research context

OpenAlex topics: Solar Thermal and Photovoltaic Systems · Silicon and Solar Cell Technologies · Thin-Film Transistor Technologies

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (39)

Show source-provided references
1. Highly efficient selective metamaterial absorber for high-temperature solar thermal energy harvesting10.1016/j.solmat.2015.02.019 ↗
2. Review of mid-to high-temperature solar selective absorber materials
3. Efficiency of ceramic absorber coatings for solar-thermal conversion10.1016/0272-8842(81)90032-8 ↗
4. Renewable energy technologies cost analysis series: concentrating solar power
5. Solar selective absorbing coatings based on AlSiN/AlSiON/AlSiOy layers10.1016/j.apsusc.2015.07.193 ↗
6. Enhanced thermal stability of W-Ni-Al2O3 cermet-based spectrally selective solar absorbers with tungsten infrared reflectors10.1002/aenm.201401042 ↗
7. High-temperature tolerance in WTi-Al2O3 cermet-based solar selective absorbing coatings with low thermal emissivity10.1016/j.nanoen.2017.05.036 ↗
8. Solar selective absorbers based on Al2O3:W cermets and AlSiN/AlSiON layers10.1016/j.solmat.2015.01.029 ↗
9. Optical and structural analysis of solar selective absorbing coatings based on AlSiOx:W cermets10.1016/j.solener.2017.04.055 ↗
10. Angular solar absorptance and thermal stability of W/WAlN/WAlON/Al2O3-based solar selective absorber coating10.1016/j.applthermaleng.2016.04.069 ↗
11. Multi-layer solar selective absorber coatings based on W/WSiAlN x/WSiAlOyNx/SiAlOx for high temperature applications10.1016/j.solmat.2018.07.001 ↗
12. Thermal stability test and ageing mechanisms study of different solar selective absorbing coatings10.1016/j.surfcoat.2016.08.092 ↗
13. Thermal aging characteristics of CrNxOy solar selective absorber coating for flat plate solar thermal collector applications10.1016/j.solmat.2013.03.005 ↗
14. Influence of temperature-induced copper diffusion on degradation of selective chromium oxy-nitride solar absorber coatings10.1016/j.solmat.2015.10.034 ↗
15. A study of solar thermal absorber stack based on CrAlSiNx/CrAlSiNx/Oy structure by ion beams
16. A design of selective solar absorber for high temperature applications10.1016/j.solener.2018.04.052 ↗
17. Unambiguous automatic evaluation of multiple ion beam analysis data with simulated annealing10.1016/S0168-583X(98)00731-9 ↗
18. High-temperature tribological properties of CrAlN, CrAlSiN and AlCrSiN coatings10.1016/j.surfcoat.2011.08.037 ↗
19. Superhard nanocomposites: origin of hardness enhancement, properties and applications10.1016/j.surfcoat.2009.09.033 ↗
20. Air-oxidation of nano-multilayered CrAlSiN thin films between 800 and 1000 °C10.1016/j.surfcoat.2008.10.011 ↗
21. Mechanical properties and oxidation behaviour of (Al,Cr)N and (Al,Cr,Si)N coatings for cutting tools deposited by HPPMS10.1016/j.tsf.2008.06.050 ↗
22. Influences of oxygen on the formation and stability of A15 B-W thin films10.1016/S0921-5093(00)00745-0 ↗
23. Structure and stability of sputter deposited beta-tungsten thin films10.1063/1.111318 ↗
24. Evaluating substrate bias on the phase-forming behavior of tungsten thin films deposited by diode and ionized magnetron sputtering10.1016/j.tsf.2005.02.032 ↗
25. Stability of W-Al2O3 cermet based solar coating for receiver tube operating at high temperature10.1016/j.solmat.2010.04.080 ↗
26. Optical property and thermal stability of Mo/Mo-SiO2/SiO2 solar-selective coating prepared by magnetron sputtering
27. Development of W-SiO2 and Nb-TiO2 solar absorber coatings for combined heat and power systems at intermediate operation temperatures10.1016/j.solmat.2014.10.022 ↗
28. Phase transformation of sputter deposited tungsten thin films with A-15 structure10.1063/1.362584 ↗
29. Adjusting poles and zeros of dielectric dispersion to fit reststrahlen of PrCl3 and LaCl310.1103/PhysRev.174.791 ↗
30. Optical properties of the metals Al, Co, Cu, Au, Fe, Pb, Ni, Pd, Pt, Ag, Ti, and W in the infrared and far infrared10.1364/AO.22.001099 ↗
31. Quantitative analysis of the effect of disorder-induced mode coupling on infrared absorption in silica10.1103/PhysRevB.38.1255 ↗
32. Infrared spectroscopy in the investigation of oxide glasses structure10.1016/S0022-2860(99)00146-5 ↗
33. FTIR, AFM and PL properties of thin SiOxfilms deposited by HFCVD10.1016/j.mseb.2010.05.005 ↗
34. Synthesis and characterization by FTIR spectroscopy of silica aerogels prepared using several Si(OR)4 and R′′Si(OR′)3 precursors10.1016/j.molstruc.2008.08.025 ↗
35. Optical phonons in amorphous silicon oxides (II)10.1002/pssb.2221210209 ↗
36. Cathodoluminescence of SiOx under-stoichiometric silica layers10.1002/pssa.200521443 ↗
37. Infrared band assignment and structural refinement of Al-Si, Al-Ge, and Ga-Ge mullites10.1127/0935-1221/2001/0013-0591 ↗
38. Crystallization of hydrosodalite Na6[AlSiO4]6(H2O)8 and tetrahydroborate sodalite Na8[AlSiO4]6(BH4)2 inside the openings of wafer-thin steel mesh10.4236/aces.2017.73021 ↗
39. A new assignment of IR vibrational modes in mullite10.1016/S0924-2031(02)00030-9 ↗