Co-solvent effect on microwave-assisted Cu2ZnSnS4 nanoparticles synthesis for thin film solar cell
Source abstract
Abstract
Abstract Cu2ZnSnS4 (CZTS) nanoparticles (NPs) were prepared in a one-step microwave-assisted synthesis using a mixture of trioctylphosphine oxide (TOPO) and oleylamine (OLA) as solvent. The reaction medium was optimized by varying the TOPO and OLA ratios to control the CZTS NPs formation. The synthesized CZTS NPs were characterized by X-ray diffraction, Raman spectroscopy, UV–vis spectroscopy, and transmission electron microscopy techniques. High quality CZTS NPs with composition of Cu1.8Zn1.4SnS3.6, optimum size distribution in the range of 22±4 nm and band gap of around 1.5 eV were obtained using microwave assisted synthesis method with OLA:TOPO (1:1) as co-solvent. In the microwave assisted process, the reaction temperature and time has been reduced significantly to 165 °C and 10 min respectively, as compared with other wet chemical solvothermal hot injection/ surfactant based methods. Finally, CZTSSe solar cell fabricated from the selenized microwave-assisted CZTS NPs yielded an efficiency of 4.48%; therefore, the low cost of synthesis of this high quality CZTS NPs ink and the capability of spraying for large solar cell area is very attractive.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (34)
Show source-provided references
1. Development of CZTS-based thin film solar cells10.1016/j.tsf.2008.11.002 ↗
2. 19.9%-efficient ZnO/CdS/CuInGaSe2 solar cell with 81.2% fill factor10.1002/pip.822 ↗
3. Addressing the terawatt challenge: scalability in the supply of chemical elements for renewable energy10.1039/c2ra20839c ↗
4. Detailed balance limit of efficiency of p-n junction solar cells10.1063/1.1736034 ↗
5. A nontoxic solvent based sol–gel Cu2ZnSnS4 thin film for high efficiency and scalable low-cost photovoltaic cells10.1039/C5TA02833G ↗
6. Beyond 11% efficiency: characteristics of state-of-the-art Cu2ZnSn(S,Se)4 solar cells10.1002/aenm.201200348 ↗
7. Optical designs that improve the efficiency of Cu2ZnSn(S,Se)4 solar cells10.1039/C3EE42541J ↗
8. Synthesis of Cu2ZnSnS4 nanocrystal ink and its use for solar cells10.1021/ja904981r ↗
9. Solution-based synthesis and characterization of Cu2ZnSnS4 nanocrystals10.1021/ja9044168 ↗
10. Fabrication of 7.2% efficient CZTSSe solar cells using CZTS nanocrystals10.1021/ja108427b ↗
11. High-efficiency solution-processed Cu2ZnSn(S,Se)4 thin-film solar cells prepared from binary and ternary nanoparticles10.1021/ja3057985 ↗
12. Microwave-enhanced reaction rates for nanoparticle synthesis10.1021/ja052463g ↗
13. Hayes · 2002
14. The use of microwave ovens for rapid organic synthesis10.1016/S0040-4039(00)83996-9 ↗
15. Application of commercial microwave ovens to organic synthesis10.1016/S0040-4039(00)85103-5 ↗
16. Microwave assisted synthesis of Cu2ZnSnS4 colloidal nanoparticle inks10.1002/pssa.201127734 ↗
17. Oleylamine in nanoparticle synthesis10.1021/cm4000476 ↗
18. Colloidal nanocrystal synthesis and the organic–inorganic interface10.1038/nature04165 ↗
19. Investigation of the formation of CuInS2 nanoparticles by the oleylamine route: comparison of microwave-assisted and conventional syntheses10.1021/ic101651p ↗
20. Raman scattering studies of Cu2ZnSnS4 thin films: local distribution of the secondary phase Cu2−xS and the effect of KCN etching on Cu2−xS10.3938/jkps.66.117 ↗
21. Enhanced solar cell performance of Cu2ZnSn(S,Se)4 thin films through structural control by using multi-metallic stacked nanolayers and fast ramping process for sulfo-selenization10.1016/j.nanoen.2016.09.022 ↗
22. Intrinsic point defects and complexes in the quaternary kesterite semiconductor Cu2ZnSnS410.1103/PhysRevB.81.245204 ↗
23. Study of polycrystalline Cu2ZnSnS4 films by Raman scattering10.1016/j.jallcom.2011.04.097 ↗
24. Development of a selective chemical etch to improve the conversion efficiency of Zn-rich Cu2ZnSnS4 solar cells10.1021/ja301373e ↗
25. Collision-induced dissociation of II-VI semiconductor nanocrystal precursors, Cd2+ and Zn2+ complexes with trioctylphosphine oxide, sulfide, and selenide10.1021/jp905153v ↗
26. Reversible lithium intercalation in teardrop-shaped ultrafine SnP0.94 particles: an anode material for lithium-ion batteries10.1002/adma.200600644 ↗
27. Controlled crystalline structure and surface stability of cobalt nanocrystals10.1021/jp044363n ↗
28. Applications of microwave dielectric heating effects to synthetic problems in chemistry10.1039/cs9912000001 ↗
29. The critical role of surfactants in the growth of cobalt nanoparticles10.1021/la902120e ↗
30. Strong valence-band offset bowing of ZnO1−xSx enhances p-type nitrogen doping of ZnO-like alloys10.1103/PhysRevLett.97.146403 ↗
31. Band-structure, optical properties, and defect physics of the photovoltaic semiconductor SnS10.1063/1.3675880 ↗
32. Synthesis of earth-abundant Cu2SnS3 for solar cells
33. Copper sulphide (CuxS) as an ammonia gas sensor working at room temperature10.1016/j.snb.2008.02.015 ↗
34. Investigation of Al2O3 diffusion barrier layer fabricated by atomic layer deposition for flexible Cu(In,Ga)Se2 solar cells10.1016/j.renene.2012.12.024 ↗