Effects of a pre-annealing treatment (PAT) on Cu2ZnSn(S,Se)4 thin films prepared by rapid thermal processing (RTP) selenization
Source abstract
Abstract
Abstract In this study, CZTSSe precursors (Se/Cu/SnS/ZnS) were deposited by sputtering and evaporation and then annealed without added chalcogen substances in an argon-filled atmospheric chamber using rapid thermal processing (RTP). A low-temperature pre-annealing treatment (PAT) was applied to induce a pre-reaction between Se and Cu/SnS/ZnS. It was found that the PAT leads to the formation of CuSe and Cu2−xSe and enhances Se incorporation during RTP chalcogenization. Scanning electron microscopy (SEM), X-ray diffractometry, Raman analysis and scanning transmission electron microscopy with energy dispersive spectroscopy (STEM-EDS) were applied to investigate the differences between the absorber with the PAT and the one without the PAT. Better morphologies on the surface and in the cross section were obtained for the CZTSSe absorber annealed using the PAT compared with the absorber annealed without the PAT. Both absorbers showed nearly pure kesterite phases in their upper regions, as confirmed by Raman analysis. However, STEM-EDS maps revealed that when the absorber was prepared without the PAT, Zn- and S-rich secondary phases and voids were easily formed near the back contact. The electrical characteristics and efficiencies of the CZTSSe thin films showed drastic changes; the CZTSSe solar cell without the PAT showed no diode response, but the cell with the PAT showed an efficiency of 6.77% with an open-circuit voltage (Voc), short-circuit current density (Jsc) and fill factor (FF) of 376 mV, 31.39 mA/cm2 and 57%, respectively.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Semiconductor materials and interfaces
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (41)
Show source-provided references
1. Atom probe study of Cu[sub 2]ZnSnSe[sub 4] thin-films prepared by co-evaporation and post-deposition annealing10.1063/1.4788815 ↗
2. Crystal and electronic band structure of Cu2ZnSnX4 (X=S and Se) photovoltaic absorbers: First-principles insights10.1063/1.3074499 ↗
3. Cu2ZnSnSe4 thin film solar cells produced by selenisation of magnetron sputtered precursors10.1002/pip.886 ↗
4. Cu2ZnSnS4 thin film solar cells by fast coevaporation10.1002/pip.976 ↗
5. Crystallization behaviour of co-sputtered Cu2 ZnSnS4 precursor prepared by sequential sulfurization processes10.1088/0957-4484/24/9/095706 ↗
6. Cu2ZnSnSe4 thin film solar cells based on a single-step co-evaporation process10.1016/j.tsf.2012.10.082 ↗
7. Co-evaporated Cu2ZnSnSe4 films and devices10.1016/j.solmat.2012.01.008 ↗
8. Growth mechanisms of co-evaporated kesterite: a comparison of Cu-rich and Zn-rich composition paths10.1002/pip.2296 ↗
9. Electrical characterization of Cu2ZnSnSe4 solar cells from selenization of sputtered metal layers10.1016/j.tsf.2012.10.037 ↗
10. Studies on Cu2ZnSnS4 (CZTS) absorber layer using different stacking orders in precursor thin films10.1016/j.solmat.2011.07.005 ↗
11. Comparative study on Cu2ZnSnS4 thin films deposited by sputtering and pulsed laser deposition from a single quaternary sulfide target10.1016/j.jcrysgro.2012.09.023 ↗
12. Optimized fabrication of sputter deposited Cu2ZnSnS4 (CZTS) thin films10.1016/j.solener.2013.02.003 ↗
13. Fabrication of Cu2ZnSnS4 absorbers by sulfurization of Sn-rich precursors10.1002/pssa.201228064 ↗
14. Influence of precursor sulfur content on film formation and compositional changes in Cu2ZnSnS4 films and solar cells10.1016/j.solmat.2011.10.019 ↗
15. Studies of compositional dependent CZTS thin film solar cells by pulsed laser deposition technique: an attempt to improve the efficiency10.1016/j.jallcom.2012.07.108 ↗
16. Efficiency electrodeposited Cu2ZnSnS4 solar cell10.1002/aenm.201100526 ↗
17. 6% Efficiency Cu2ZnSnS4-based thin film solar cells using oxide precursors by open atmosphere type CVD10.1039/c2jm16454j ↗
18. High-efficiency solar cell with Earth-abundant liquid-processed absorber10.1002/adma.200904155 ↗
19. Molecular solution approach to synthesize electronic quality Cu2ZnSnS4 thin films10.1021/ja312678c ↗
20. Formation mechanism of Cu2ZnSnSe4 absorber layers during selenization of solution deposited metal precursors10.1016/j.jallcom.2013.03.056 ↗
21. Synthesis of Cu2ZnSnS4 nanocrystal ink and its use for solar cells10.1021/ja904981r ↗
22. Size control and quantum confinement in Cu2ZnSnS4 nanocrystals10.1039/c1cc14687d ↗
23. Low temperature phase selective synthesis of Cu2ZnSnS4 quantum dots10.1039/c3cc39042j ↗
24. Device characteristics of CZTSSe thin-film solar cells with 12.6% efficiency,10.1002/aenm.201301465 ↗
25. Characterization of defects in 9.7% efficient Cu2ZnSnSe4–CdS–ZnO solar cells10.1063/1.4826448 ↗
26. On the Sn loss from thin films of the material system Cu–Zn–Sn–S in high vacuum10.1063/1.3273495 ↗
27. Thin film solar cell with 8.4% power conversion efficiency using an earth-abundant Cu2ZnSnS4 absorber10.1002/pip.1174 ↗
28. Influence of precursor sulfur content on film formation and the properties of sulfurized Cu2ZnSnS4 thin films for solar cells10.1002/pssa.201330425 ↗
29. Cu2ZnSn(S,Se)4 solar cells processed by rapid thermal processing of stacked elemental layer precursors10.1016/j.tsf.2012.10.042 ↗
30. Effects of Na and MoS2 on Cu2ZnSnS4 thin-film solar cell10.1002/pip.2500 ↗
31. Influence of sulfate residue on Cu2ZnSnS4 thin films prepared by direct solution method10.1016/j.solmat.2015.01.003 ↗
32. Reaction kinetics of CuGaSe2 formation from a GaSe/CuSe bilayer precursor film10.1016/j.jcrysgro.2008.01.034 ↗
33. On the kinetics of MoSe2 interfacial layer formation in chalcogen-based thin film solar cells with a molybdenum back contact10.1063/1.4794422 ↗
34. Growth and characterization of Cu2ZnSn(S,Se)4 thin films for solar cells10.1016/j.solmat.2012.02.031 ↗
35. Growth and Raman scattering characterization of Cu2ZnSnS4 thin films10.1016/j.tsf.2008.11.031 ↗
36. Polarized Raman spectroscopy of Cu-poor and Zn-rich single-crystal Cu2ZnSnSe410.1063/1.4900560 ↗
37. Optical properties and band structure of trigonal selenium10.1103/PhysRev.158.623 ↗
38. Raman spectra of SnS2 and SnSe210.1016/0038-1098(76)91297-7 ↗
39. Growth and characterization of coevaporated Cu2SnSe3 thin films for photovoltaic applications10.1016/j.tsf.2013.03.119 ↗
40. High efficiency Cu2ZnSn(S,Se)4 solar cells by applying a double In2S3/CdS emitter10.1002/adma.201402373 ↗
41. Thin-film solar cells: device measurements and analysis10.1002/pip.518 ↗