journal article·2011-07

Effect of concentration gradients in ZnPc:C60 bulk heterojunction organic solar cells

Wolfgang Tress, Karl Leo, Moritz Riede

Publisher page

Abstract

Abstract A concentration gradient in a mixed absorber layer with increasing content of donor (acceptor) towards the hole (electron) collecting contact could improve the charge carrier collection in bulk heterojunction organic solar cells. We study p-i-metal type solar cells where the gradient in a 45 nm thick ZnPc:C 60 absorber layer is introduced by varying the deposition rate during co-evaporation. It is shown that the observed increase in the performance is mainly caused by a better energy level alignment and reduced recombination at the p-side. A significant influence on charge carrier transport is not observed. However, regions with a concentration of less than 20% of one component do not fully contribute to the photocurrent. Voltage dependent external quantum efficiency data are used to identify the photoactive regions.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Organic Electronics and Photovoltaics · Thin-Film Transistor Technologies · Nanowire Synthesis and Applications

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (35)

Show source-provided references
1. Tandem solar cell by Heliatek/IAPP with an efficiency of 8.3% on an area of 1.1 square centimeters, certified at Fraunhofer ISE (Freiburg), press release, 2010.
2. Single junction solar cell by Konarka with an efficiency of 8.3% on an area of 1 square centimeter, press release, 2010.
3. Low band gap polymers for organic photovoltaics10.1016/j.solmat.2007.01.015 ↗
4. Small bandgap polymers for organic solar cells (polymer material development in the last 5 years)10.1080/15583720802231833 ↗
5. Three-layered organic solar cell with a photoactive interlayer of codeposited pigments10.1063/1.104423 ↗
6. Two-layer organic photovoltaic cell10.1063/1.96937 ↗
7. Small molecular weight organic thin-film photodetectors and solar cells10.1063/1.1534621 ↗
8. Organic p-i-n solar cells10.1007/s00339-003-2494-9 ↗
9. Influence of molecular architecture and intermixing on the photovoltaic, morphological and spectroscopic properties of CuPc/C60 heterojunctions10.1016/j.solmat.2004.02.027 ↗
10. Relating the morphology of poly(p-phenylene vinylene)/methanofullerene blends to solar-cell performance10.1002/adfm.200305049 ↗
11. 2.5% efficient organic plastic solar cells10.1063/1.1345834 ↗
12. M.T. Rispens, A. Meetsma, R. Rittberger, C.J. Brabec, N.S. Sariciftci, J.C. Hummelen, Influence of the solvent on the crystal structure of PCBM and the efficiency of MDMO-PPV:PCBM ‘plastic’ solar cells, Chemical communications (Cambridge, England) (17) (2003) 2116–2118.10.1039/B305988J ↗
13. High-efficiency solution processable polymer photovoltaic cells by self-organization of polymer blends10.1038/nmat1500 ↗
14. Effects of postproduction treatment on plastic solar cells10.1002/adfm.200390011 ↗
15. Effects of annealing on the nanomorphology and performance of poly(alkylthiophene): fullerene bulk-heterojunction solar cells10.1002/adfm.200601038 ↗
16. Enhanced photovoltaic performance in fullerene: phthalocyanine codeposited films deposited on heated substrate10.1143/JJAP.43.L1014 ↗
17. Correlation between morphology and performance of low bandgap oligothiophene: C60 mixed heterojunctions in organic solar cells10.1063/1.3271407 ↗
18. Concentration gradient P3OT/PCBM photovoltaic devices fabricated by thermal interdiffusion of separately spin-cast organic layers10.1016/j.solmat.2009.06.009 ↗
19. Influence of codeposition on the performance of CuPc/C60 heterojunction photovoltaic devices10.1063/1.1643549 ↗
20. Improvement of the efficiency of CuPc/C60-based photovoltaic cells using a multistepped structure10.1016/j.orgel.2009.02.024 ↗
21. Graded donor-acceptor heterojunctions for efficient organic photovoltaic cells10.1002/adma.201002454 ↗
22. Open circuit voltage and IV curve shape of ZnPc:C60 solar cells with varied mixing ratio and hole transport layer10.1117/1.3556726 ↗
23. Influence of hole-transport layers and donor materials on open-circuit voltage and shape of I–V curves of organic solar cells10.1002/adfm.201002669 ↗
24. Small-molecule solar cells—status and perspectives10.1088/0957-4484/19/42/424001 ↗
25. M. Tietze, S. Pfuetzner, W. Tress, K. Leo, M. Riede, in preparation.
26. The electronic structure of C60/ZnPc interface for organic photovoltaic device with blended layer architecture10.1063/1.3285174 ↗
27. Modeling photocurrent action spectra of photovoltaic devices based on organic thin films10.1063/1.370757 ↗
28. Generalized matrix method for calculation of internal light energy flux in mixed coherent and incoherent multilayers10.1364/AO.44.007532 ↗
29. Correlation of hole mobility, exciton diffusion length, and solar cell characteristics in phthalocyanine/fullerene organic solar cells10.1063/1.2711525 ↗
30. Wuerfel · 2009
31. Comparing organic to inorganic photovoltaic cells: theory, experiment, and simulation10.1063/1.1544413 ↗
32. Recombination dynamics as a key determinant of open circuit voltage in organic bulk heterojunction solar cells: a comparison of four different donor polymers10.1002/adma.201002360 ↗
33. Mixed donor-acceptor molecular heterojunctions for photovoltaic applications. I. Material properties10.1063/1.2142072 ↗
34. Molecular semiconductor blends: microstructure, charge carrier transport, and application in photovoltaic cells10.1002/pssa.200925238 ↗
35. Imbalanced mobilities causing S-shaped IV curves in planar heterojunction organic solar cells10.1063/1.3553764 ↗