The impact of atmospheric species on the degradation of CIGS solar cells
Source abstract
Abstract
CIGS solar cells were exposed to liquid water purged with the atmospheric gases carbon dioxide (CO 2 ), oxygen (O 2 ), nitrogen (N 2 ) and air in order to investigate their chemical degradation behavior. The samples were analyzed by electrical, compositional and optical measurements before, during and after exposure in order to follow the degradation behavior of these solar cells in time. The solar cells showed a rapid decrease in conversion efficiency when exposed to water purged with a combination of CO 2 and N 2 as well as to water purged with air, while their efficiency was slowly reduced in unpurged water and water purged with N 2 or O 2 . Cross-section SEM showed that the exposure of samples to H 2 O with large concentrations of CO 2 led to the dissolution of the ZnO:Al layer, likely starting from the grain boundaries. This resulted in an increased series resistance, which is likely related to an increase in resistivity of the ZnO:Al layer. It also led to a very rapid decrease of the short-circuit current of these samples. Therefore, the conversion efficiency was rapidly lost. cop. 2015 Elsevier Ltd. All rights reserved.
Source: openaire · Quality: candidate unverified · Source record ↗
Research context
OpenAlex topics: Chalcogenide Semiconductor Thin Films · ZnO doping and properties · Copper-based nanomaterials and applications
SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.
References (15)
Show source-provided references
1. Life prediction for CIGS solar modules Part 1: modelling moisture ingress and degradation10.1002/pip.1172 ↗
2. J. Del Cueto, S. Rummel, B. Kroposki, C. Osterwald, A. Anderberg, Stability of CIS/CIGS modules at the outdoor test facility over two decades, in: Proceedings of the 33rd IEEE PVSC, 2008, pp. 1–610.1109/PVSC.2008.4922772 ↗
3. Influence of atmospheric species water, oxygen, nitrogen and carbon dioxide on the degradation of aluminum doped zinc oxide layers10.1016/j.tsf.2014.07.005 ↗
4. Damp heat stable doped zinc oxide films10.1016/j.tsf.2013.08.011 ↗
5. Physical and chemical degradation behavior of sputtered aluminum doped zinc oxide layers for Cu(In,Ga)Se2 solar cells10.1016/j.tsf.2013.10.149 ↗
6. The influence of atmospheric species on the degradation of aluminum doped zinc oxide and Cu(In,Ga)Se2 solar cells10.1117/12.2061330 ↗
7. Re-investigation of preferential orientation of Cu(In,Ga)Se2 thin films grown by the three-stage process10.1002/pip.1079 ↗
8. Accelerated performance degradation of CIGS solar cell determined by in-situ monitoring
9. Molybdenum, molybdenum oxides, and their electrochemistry10.1002/cssc.201100660 ↗
10. The impact of sodium and potassium on the degradation of CIGS solar cells10.1002/pip.2610 ↗
11. Potential-induced degradation of CuIn1−xGaxSe2 thin film solar cells10.1109/JPHOTOV.2013.2253833 ↗
12. R. Feist, S. Rozeveld, M. Mushrush, R. Haley, B. Lemon, J. Gerby, B. Nicols, R. Nilsson, T. Richardson, S. Sprague, R. Tesch, S. Torka, C. Wood, S. Wu, S. Yeung, M. Bernius, Examination of lifetime-limiting failure mechanisms in CIGSS-based PV minimodules under environmental stress, in: Proceedings of the 33rd IEEE PVSC, 2008, pp. 1–510.1109/PVSC.2008.4922579 ↗
13. Zhang · 1996
14. Acetic acid production and glass transition concerns with ethylene-vinyl acetate used in photovoltaic devices10.1016/j.solmat.2006.10.009 ↗
15. Failure analysis of Cu(In,Ga)Se2 photovoltaic modules: degradation mechanism of Cu(In,Ga)Se2 solar cells under harsh environmental conditions