journal article·2014-01

Breakdown characteristics of flexible Cu(In,Ga)Se2 solar cells

S. Puttnins, S. Jander, A. Wehrmann, G. Benndorf, M. Stölzel, A. Müller, H. von Wenckstern, F. Daume, A. Rahm, M. Grundmann

Publisher page

Abstract

Abstract The behavior of solar cells under reverse bias conditions is of crucial importance for solar module design and stability. For flexible, low temperature deposited Cu(In,Ga)Se 2 (CIGSe) solar cells indications for tunnel breakdown at operation temperatures around 300 K are found using temperature and net carrier concentration dependent measurements of the breakdown voltage V BR . For temperatures below 200 K, the temperature coefficient of the breakdown voltage becomes positive, indicating a change of the breakdown mechanism to avalanche breakdown. A reduction of V BR caused by the illumination with blue photons is demonstrated, which coincides well with results and models for high temperature deposited CIGSe on glass. Furthermore, spectrally resolved measurements of light emission during breakdown indicate a first ReBEL (reverse bias electroluminescence) signature for CIGSe solar cells.
Source: openaire · Quality: candidate unverified · Source record ↗

Research context

OpenAlex topics: Chalcogenide Semiconductor Thin Films · Quantum Dots Synthesis And Properties · Semiconductor materials and interfaces

SciVX discovery tags are terminology-based. OpenAlex topics are source-provided classifications.

References (30)

Show source-provided references
1. Diode breakdown related to recombination active defects in block-cast multicrystalline silicon solar cells10.1063/1.3224908 ↗
2. Correlation of pre-breakdown sites and bulk defects in multicrystalline silicon solar cells
3. Understanding junction breakdown in multicrystalline solar cells10.1063/1.3562200 ↗
4. Internal field emission in silicon p–n junctions10.1103/PhysRev.106.418 ↗
5. A. Dubois, J. Veirmann, N. Enjalbert, P. Scheiblin, Hard breakdown mechanisms of compensated p-type and n-type single-crystalline silicon solar cells, Solid-State Electronics, 76 (2012), 36-39, 10.1016/j.sse.2012.05.03310.1016/j.sse.2012.05.033 ↗
6. Bauer · Physica Status Solidi Rapid Research Letters · 2009 · 3 · 4010.1002/pssr.200802250 ↗
7. Photon emission from avalanche breakdown in silicon10.1103/PhysRev.102.369 ↗
8. P. Mack, T. Walter, R. Kniese, D. Hariskos, R. Schäffler Reverse bias and reverse currents in CIGS thin film solar cells and modules, in: Conference Record of the 23rd European Photovoltaic Solar Energy Conference, 2008, pp. 2156–2159
9. S. Puttnins, S. Jander, K. Pelz, S. Heinker, F. Daume, A. Rahm, A. Braun, M. Grundmann, The influence of front contact and buffer layer properties on CIGSe solar cell breakdown characteristics, in: Conference Record of the 26th European Photovoltaic Solar Energy Conference, 2011, 3C0.4.6, doi: 10.4229/26thEUPVSEC2011-3CO.4.6
10. S. Puttnins, M. Purfürst, M. Hartung, H. K. Lee, F. Daume, L. Hartmann, A. Rahm, A. Braun, M. Grundmann, The influence of sodium on CIGSe solar cell breakdown characteristics, in: Conference Record of the 27th European Photovoltaic Solar Energy Conference, 2012, 3C0.2.6, doi: 10.4229/27thEUPVSEC2012-3CO.2.6
11. Electrical breakdown in semiconductors10.1002/pssa.2210080202 ↗
12. Flexible Cu(In,Ga)Se2 thin film solar cells for space application10.1016/j.tsf.2005.11.068 ↗
13. H. Zachmann, S. Puttnins, F. Daume, A. Rahm, K. Otte, R. Caballero, C.A. Kaufmann, T. Eisenbarth, H.W. Schock, Incorporation of Na in low-temperature deposition of CIGS flexible solar cells, in: Materials Research Society Symposia Proceedings, 1220: 1210-Q03-02, 2009.10.1557/PROC-1210-Q03-02 ↗
14. S. Puttnins, S. Levcenco, K. Schwarzburg, G. Benndorf, F. Daume, A. Rahm, A.Braun, M. Grundmann, T. Unold, Effect of Sodium on Material and Device Quality in Low Temperature Deposited Cu(In,Ga)Se2, Solar Energy Materials and Solar Cells 119 (2013) 281–286, 10.1016/j.solmat.2013.08.029.10.1016/j.solmat.2013.08.029 ↗
15. Oxygen and air-annealing effects on the electronic properties of Cu(In,Ga)Se2 films and devices10.1063/1.370758 ↗
16. Thin-film solar cells: device measurements and analysis10.1002/pip.518 ↗
17. Classification of metastabilities in the electrical characteristics of ZnO/CdS/Cu(In,Ga)Se2 solar cells10.1016/S0040-6090(00)01850-2 ↗
18. Sze · 2007
19. Na incorporation into Cu(In,Ga)Se2 for high-efficiency flexible solar cells on polymer foils10.1063/1.1857059 ↗
20. Effects of Na on the electrical and structural properties of CuInSe210.1063/1.370534 ↗
21. The effect of NaF precursors on low temperature growth of CIGS thin film solar cells on polyimide substrates10.1002/pssa.200881144 ↗
22. D. Rudmann, Ph.D. Thesis. E.T.H. Zürich, 2004
23. Series resistance imaging of solar cells by voltage dependent electroluminescence10.1063/1.2804562 ↗
24. Examination of blocking current–voltage behaviour through defect chalcopyrite layer in ZnO/CdS/Cu(In,Ga)Se2/Mo solar cell10.1016/S0927-0248(97)00058-5 ↗
25. Interpretation of admittance, capacitance–voltage, and current–voltage signatures in Cu(In,Ga)Se2 thin film solar cells10.1063/1.3277043 ↗
26. Physical model of CdS-based thin-film photovoltaic junctions10.1063/1.2181201 ↗
27. J. Cesar, S. Puttnins, F. Daume, A. Braun, A. Rahm, Temperature-dependent IV and EQE measurements on CIGSe solar cells with varying sodium content, in: Conference Record of the 27th European Photovoltaic Solar Energy Conference, 2012, 3CV.1.31, doi: 10.4229/27thEUPVSEC2012-3CV.1.31
28. Analyses of local open circuit voltages in polycrystalline Cu(In,Ga)Se2 thin film solar cell absorbers on the micrometer scale by confocal luminescence10.2533/chimia.2007.801 ↗
29. Lateral inhomogeneities of Cu(In,Ga)Se2 absorber films10.1016/S0040-6090(99)00784-1 ↗
30. Local current transport and surface potential of photovoltaic Cu(In,Ga)Se2 thin films probed by multi-scale imaging methods10.1088/2043-6262/4/1/015007 ↗